Coverage across Orkney, Shetland and the Western Isles
We treat Orkney, Shetland and the Western Isles as one service area for automatic door refurbishment, so a site on the edge of the area gets the same written pricing and the same standard of work as one in the busiest town centre. Specialist automatic door engineers working under our management carry out each visit. Choose from the 4 towns below, or contact us with any address.
Towns listed in Orkney, Shetland and the Western Isles: Stornoway, Kirkwall, Lerwick, Stromness.
What to think about for automatic door refurbishment in Orkney, Shetland and the Western Isles
- Busy retail units in Orkney, Shetland and the Western Isles may prefer the work done in stages, one leaf at a time, so the entrance stays open throughout trading hours.
- Older shopfronts with discontinued door systems may need equivalent parts rather than exact matches. The survey identifies what is still available before anything is ordered.
- Listed buildings and conservation areas can limit changes to how the frame looks. Refurbishment within the existing frame usually avoids those issues and any need for consent.
- If the operator is close to the end of its life, refurbishing the running gear while fitting a new drive unit saves a second visit and a second set-up.
- Frames near the coast or busy roads can corrode faster. The survey checks fixings and the bottom of the frame, where water and grit tend to collect.
Automatic door refurbishment in Orkney, Shetland and the Western Isles: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. For island addresses the survey is still free; travel and accommodation for the installation itself are shown as a separate line in the quote. Guide price: from £395 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Running gear refresh: rollers, guides, brushes and seals | £395 – £895 | per door, ex VAT |
| Track overhaul | £395 – £895 | per door, ex VAT |
| Replacement glass leaf | from £495 | each, ex VAT; size and glass type on survey |
| Full refurbishment of a sliding door | £1,495 – £2,995 | running gear, seals, guides and one leaf, ex VAT |
Standards and rules in Scotland
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Send photos and the address. A few pictures of the door from both sides, the address in Orkney, Shetland and the Western Isles and a note of who uses the entrance help us understand the job before anyone visits the site.
- No-cost survey on site. We arrange a survey at a time that suits the building. The engineer records measurements, fixings and power, plus any constraints such as listed status, opening hours or access for deliveries.
- Itemised quote to approve. We price every element of the work on automatic door refurbishment separately in a written quote that you can check, share and approve. Lead time and payment stages are stated, and nothing is ordered until you accept.
- Fit, test and hand over. On the agreed dates the engineer installs the equipment, commissions the operator and tests each safety function. You get a demonstration, the test record and any conformity paperwork that applies to the work.
Book a free refurbishment survey in Orkney, Shetland and the Western Isles. We will check the frame, leaves and running gear, then price each item separately on a fixed quote.
Automatic door refurbishment in Orkney, Shetland and the Western Isles: questions
Can you replace a single broken glass leaf in Orkney, Shetland and the Western Isles?
Yes. The leaf is made safe, measured and reglazed with new safety glass, or replaced completely if its frame is damaged. New glass is typically 2 to 4 weeks from order. Once the leaf is rehung, the door is set up again and the track and floor guide are checked.
What price range should I expect for automatic door refurbishment in Orkney, Shetland and the Western Isles?
Our guide starts from £395 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Orkney, Shetland and the Western Isles confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Can you refinish the frame of our door in Orkney, Shetland and the Western Isles?
Yes. Aluminium frames can be cleaned, repaired and recoated on site to refresh their colour. Badly damaged sections may need replacing rather than refinishing. Refinishing is listed separately in the quote, so you can decide whether to include it now or leave it for a later phase.
Can refurbishment in Orkney, Shetland and the Western Isles help with draughts and heating costs?
New seals and brush strips, and leaves that close fully, reduce draughts through a closed door. For very exposed entrances, a second set of doors forming a draught lobby may also be worth considering, and we can price both so you can compare the likely benefit.
Can installation in Orkney, Shetland and the Western Isles happen outside opening hours?
Yes. Many shops, surgeries and offices prefer work early in the morning, in the evening or at weekends, when the entrance is quietest. Tell us your constraints when you enquire and they are built into the plan. Any extra cost for out-of-hours work is shown in the written quote rather than added afterwards.
What does the written quote for automatic door refurbishment in Orkney, Shetland and the Western Isles include?
The quote lists each item separately: the door or equipment, installation, electrical connections where we provide them, removal of anything being replaced, testing and handover. It is a fixed price for the work described, so it does not change unless the scope changes, and any change is agreed with you in writing first.
Who is responsible for automatic doors on escape routes in Orkney, Shetland and the Western Isles?
The person responsible for fire safety under the Fire (Scotland) Act 2005 for those premises. Scottish guidance allows automatic doors on escape routes only where they fail safely to outward opening or have a monitored fail-safe system that opens them on power failure, sensor failure and fire alarm.