Coverage across the Highlands
There is no branch to visit in the Highlands; instead, specialist engineers working under our management travel to you. That keeps automatic door refurbishment available across the whole area, including smaller towns and rural addresses. The page for each of the 6 towns we list below sets out nearby places, guide prices and the questions people usually ask.
Towns listed in the Highlands: Inverness, Fort William, Nairn, Thurso, Wick, Portree.
What to think about for automatic door refurbishment in the Highlands
- After refurbishment, sensors and speeds are reset to suit the new parts. Keep the test record with your service history so later engineers can see what was done.
- Frames near the coast or busy roads can corrode faster. The survey checks fixings and the bottom of the frame, where water and grit tend to collect.
- Floors around the door in the Highlands may be worn or uneven. New floor guides and thresholds sometimes need small areas of making good, which the quote lists separately.
- If the operator is close to the end of its life, refurbishing the running gear while fitting a new drive unit saves a second visit and a second set-up.
- Care settings in the Highlands benefit from level thresholds and smooth-running leaves that do not snag walking frames, trolleys or wheelchair footplates as people pass through.
Automatic door refurbishment in the Highlands: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £395 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Running gear refresh: rollers, guides, brushes and seals | £395 – £895 | per door, ex VAT |
| Track overhaul | £395 – £895 | per door, ex VAT |
| Replacement glass leaf | from £495 | each, ex VAT; size and glass type on survey |
| Full refurbishment of a sliding door | £1,495 – £2,995 | running gear, seals, guides and one leaf, ex VAT |
Standards and rules in Scotland
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Describe what you need. Whether the job is automatic door refurbishment for a busy entrance or for a single internal door, a brief description and some photos let us understand it and plan a survey visit in the Highlands.
- Free visit to the site. An engineer working under our management assesses the opening, the existing door and frame, the floor and the electrical supply, and notes any access, consent or timing issues to plan around.
- Your fixed quotation. The quote is fixed for the work it describes and lists each item, including any removal, making good and electrical work. It also states the lead time, the payment stages and the warranty terms.
- Fitting and sign-off. Work goes ahead on dates agreed with you. Once fitted, the door is adjusted and its safety functions are tested and recorded with reference to BS EN 16005, and you are shown how to use it.
Book a free refurbishment survey in the Highlands. We will check the frame, leaves and running gear, then price each item separately on a fixed quote.
Automatic door refurbishment in the Highlands: questions
Can you replace a single broken glass leaf in the Highlands?
Yes. The leaf is made safe, measured and reglazed with new safety glass, or replaced completely if its frame is damaged. New glass is typically 2 to 4 weeks from order. Once the leaf is rehung, the door is set up again and the track and floor guide are checked.
What do you charge for automatic door refurbishment in the Highlands?
Our guide starts from £395 excluding VAT (per door), the same guide price we use across the UK. The free site survey in the Highlands confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Do you set up the door again after refurbishing it in the Highlands?
Yes. New running parts change how the leaves move, so speeds, sensor zones and obstacle detection are checked and reset before handover. You receive a record of the parts fitted and the test results to keep with the door's service history.
Can you refurbish a door in the Highlands that another company installed?
Yes. We refurbish doors whoever fitted them. The survey identifies the door system, and matching or equivalent rollers, guides, seals and glass are then sourced for it. If a part is no longer made, the quote explains the alternative.
What happens once the installation in the Highlands is finished?
The engineer tests every function, including the safety sensors and the behaviour on power loss, and sets the door up with reference to BS EN 16005. You are shown how to use the controls and which simple checks to make, and you receive the handover documents, including the test record and any conformity paperwork that applies to the work.
How do you make sure the door works for disabled visitors in the Highlands?
We look at who uses the entrance: wheelchair users, people with walking aids, parents with buggies and older visitors. That shapes the opening width, the opening speed, the hold-open time and where push pads or sensors go. Service providers and employers have duties to make reasonable adjustments under equality and accessibility law, and an automatic door is a common one.
Who is responsible for automatic doors on escape routes in the Highlands?
The person responsible for fire safety under the Fire (Scotland) Act 2005 for those premises. Scottish guidance allows automatic doors on escape routes only where they fail safely to outward opening or have a monitored fail-safe system that opens them on power failure, sensor failure and fire alarm.