Coverage across Derbyshire
For telescopic sliding doors anywhere in Derbyshire, you deal with one contracting party and one written price. We organise the visit, brief the engineer, who works under our management, and keep the paperwork together afterwards. Below you will find the towns we list in this part of England, 14 in all; if your address sits outside them, the arrangements are exactly the same.
Towns listed in Derbyshire: Derby, Chesterfield, Long Eaton, Ilkeston, Swadlincote, Staveley, Belper, Heanor, Alfreton, Dronfield, Ripley, Buxton, New Mills, Glossop.
What to think about for telescopic sliding doors in Derbyshire
- Hospital and supermarket entrances in Derbyshire that run for long hours put more wear on the extra rollers and belts of a telescopic door. Plan a servicing arrangement from the start rather than waiting for the first fault.
- Care homes and supported living buildings in Derbyshire may want the main door to open freely for visitors but stay locked for some residents. A keypad or fob reader on the inside can be wired to the operator.
- If the entrance is on an escape route, ask your fire risk assessor what the door must do before ordering. Break-out telescopic leaves have to be chosen at the start, because they cannot be added afterwards.
- A telescopic header is deeper than a standard one. In older buildings in Derbyshire with low ceilings or decorative fanlights, the survey checks whether the header can sit above the opening or needs to be recessed.
- Grit and leaves blown into the threshold collect in floor guide channels. Entrances facing a car park or open ground benefit from a matwell or canopy, which also keeps rain off the sensors.
Telescopic sliding doors in Derbyshire: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £6,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Telescopic single-slide, two leaves | £6,995 – £9,995 | installed, ex VAT |
| Telescopic bi-parting, four leaves | £8,995 – £13,995 | installed, ex VAT |
| Very wide or full-height openings | Priced on survey | measured and designed at the survey |
| Touch-free switch or push pad, fitted | £145 – £395 | per switch, ex VAT |
| Card or fob reader tied into the door | £795 – £2,495 | per door, ex VAT |
Standards and rules in England
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking. Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, which can include altering a physical feature such as a heavy entrance door. New entrances and some alterations count as building work, so check with building control before the work is ordered.
How it works
- Send photos and the address. A few pictures of the door from both sides, the address in Derbyshire and a note of who uses the entrance help us understand the job before anyone visits the site.
- No-cost survey on site. We arrange a survey at a time that suits the building. The engineer records measurements, fixings and power, plus any constraints such as listed status, opening hours or access for deliveries.
- Itemised quote to approve. We price every element of the work on telescopic sliding doors separately in a written quote that you can check, share and approve. Lead time and payment stages are stated, and nothing is ordered until you accept.
- Fit, test and hand over. On the agreed dates the engineer installs the equipment, commissions the operator and tests each safety function. You get a demonstration, the test record and any conformity paperwork that applies to the work.
Short of side space but need a wide entrance in Derbyshire? Get in touch and we will show you the clear opening a telescopic door can give.
Telescopic sliding doors in Derbyshire: questions
How much wider will our entrance in Derbyshire be with telescopic doors?
As a rough guide, a telescopic door gives about two-thirds of its overall width as clear opening, against about half for a standard sliding door. On a typical shop or surgery entrance that can mean an extra 300 to 600 mm. The survey drawing for your building in Derbyshire shows the exact clear width before you commit.
What price range should I expect for telescopic sliding doors in Derbyshire?
Our guide starts from £6,995 excluding VAT (per door set), the same guide price we use across the UK. The free site survey in Derbyshire confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Can our existing sliding door in Derbyshire be converted to telescopic?
Not usually by modifying the old door, because the header, tracks and leaves are different. It is normally replaced as a complete set within the same opening. The survey checks whether the existing structure and floor can take the new door, and the quote shows removal of the old one as a separate line.
What paperwork do we get after installation in Derbyshire?
You receive the commissioning and test record, a site-specific risk assessment, user instructions and the conformity paperwork for the door. Keep them with your building records. They are the starting point for later servicing and safety inspections, and they show how the door was set up with reference to BS EN 16005.
What should I send before the survey in Derbyshire?
A few photos of the door from inside and outside, rough measurements of the opening, the address and a note of how the entrance is used. If the door already has an operator, a photo of any label on it helps. With that, the engineer arrives prepared, the survey takes less of your time and we can put the quote for telescopic sliding doors together more easily.
Will the building stay secure while the entrance is being changed?
We plan to keep the entrance usable or secure throughout. Where a door has to come out, the work is sequenced so the opening is closed up before the engineer leaves, or a temporary door or hoarding is arranged when a longer gap cannot be avoided. How this is handled for your site in Derbyshire is agreed before work starts.
Do businesses in Derbyshire have to fit automatic doors?
No law says every building must have automatic doors. Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, and building regulations guidance in England calls for a powered door where an entrance door would otherwise be too heavy to open. An automatic door is often the simplest way to meet both.