Coverage across Derbyshire
There is no branch to visit in Derbyshire; instead, specialist engineers working under our management travel to you. That keeps frameless glass automatic doors available across the whole area, including smaller towns and rural addresses. The page for each of the 14 towns we list below sets out nearby places, guide prices and the questions people usually ask.
Towns listed in Derbyshire: Derby, Chesterfield, Long Eaton, Ilkeston, Swadlincote, Staveley, Belper, Heanor, Alfreton, Dronfield, Ripley, Buxton, New Mills, Glossop.
What to think about for frameless glass automatic doors in Derbyshire
- Glass partitions in office buildings across Derbyshire are often supplied by a fit-out contractor. Share their drawings with us so the door glass, gaps and finishes match the rest of the screens.
- Every edge and fitting on a frameless door is visible. Choose a top rail and clamp finish, such as satin stainless or black, that suits the rest of the ironmongery in the building.
- Cleaning staff at busy venues in Derbyshire should use non-abrasive products on frameless doors, keep the floor guide clear of grit and report any chipped glass edge straight away.
- Listed interiors and heritage buildings in Derbyshire sometimes favour frameless glass because it hides less of the original fabric. Consent may still be needed, so check with the planning authority early.
- Showrooms in Derbyshire with large displays, or vehicles moving in and out, may want a wide bi-parting frameless door with a hold-open mode for deliveries.
Frameless glass automatic doors in Derbyshire: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £5,495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Single-slide frameless glass door | £5,495 – £8,995 | installed, ex VAT |
| Bi-parting frameless glass door, about 2 m clear opening | £7,495 – £12,995 | installed, ex VAT |
| Touch-free switch or push pad, fitted | £145 – £395 | per switch, ex VAT |
| Card or fob reader tied into the door | £795 – £2,495 | per door, ex VAT |
| Battery backup for power-cut operation | £395 – £695 | per door, ex VAT |
Standards and rules in England
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking. Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, which can include altering a physical feature such as a heavy entrance door. New entrances and some alterations count as building work, so check with building control before the work is ordered.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in Derbyshire.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
For an all-glass entrance in Derbyshire that is measured, fitted and set up properly, contact us and book your free site survey.
Frameless glass automatic doors in Derbyshire: questions
What should we do if the frameless door in Derbyshire is damaged?
If the glass is chipped or cracked, switch the door off, keep people away from the damaged leaf and contact us. A repair or replacement visit is priced in writing before an engineer attends, and replacement glass is quoted before it is ordered. Laminated glass usually stays in place until it can be replaced.
What will frameless glass automatic doors in Derbyshire cost?
Our guide starts from £5,495 excluding VAT (per door set), the same guide price we use across the UK. The free site survey in Derbyshire confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Can a frameless door in Derbyshire be connected to our access control?
Yes. The operator can be linked to card readers, fob readers, keypads, intercoms or a timer, so the door opens freely in working hours and only for authorised people at other times. Tell us what you already have at the survey and the quote will set out the interface work.
How long does fitting take in Derbyshire?
Most frameless automatic doors take a day on site once the glass has been made, which is typically 4 to 8 weeks from order. Work in occupied offices can be planned for quieter times, early mornings or weekends, and any extra cost for out-of-hours work is shown separately in the quote.
What does the written quote for frameless glass automatic doors in Derbyshire include?
The quote lists each item separately: the door or equipment, installation, electrical connections where we provide them, removal of anything being replaced, testing and handover. It is a fixed price for the work described, so it does not change unless the scope changes, and any change is agreed with you in writing first.
What does the free site survey in Derbyshire involve?
An engineer working under our management visits the building, measures the opening, checks the frame, floor, head height and power supply, and looks at how people use the entrance. The survey is free and carries no obligation. Afterwards you receive a fixed, itemised written quote for frameless glass automatic doors, with drawings where the door type needs them.
Who is responsible for automatic doors on escape routes in Derbyshire?
Under the Regulatory Reform (Fire Safety) Order 2005 the responsible person for the premises must make sure escape routes work and fire safety equipment is maintained. Automatic doors on an escape route need fail-safe opening or break-out, set by the fire strategy.