Coverage across Oxfordshire
Our coverage of Oxfordshire is not tied to a depot or a showroom. Engineers who carry out automatic door repairs for us travel to each site, so a farm shop down a country lane goes through the same process as a city-centre office. Every job is priced in writing before work starts, and the town list below currently numbers 6.
Towns listed in Oxfordshire: Oxford, Banbury, Abingdon, Bicester, Didcot, Witney.
What to think about for automatic door repairs in Oxfordshire
- Opening hours matter when booking a repair in Oxfordshire. If your premises close early or open late, mention it so the engineer can work while the entrance is quiet.
- For surgeries, clinics and care settings in Oxfordshire, a door that will not open can stop wheelchair users getting in. Plan an alternative accessible entrance and clear signs while the repair is arranged.
- A door with battery backup may show a fault, or fail to open in a power cut, when its battery is worn out. Batteries are a routine replacement part rather than a major repair.
- Wet and windy weather causes many false openings. Sensors over exposed entrances can react to rain and blowing leaves, and a small change to the detection zone often cures it.
- Glass damage needs prompt action to keep people safe. Switch the door off, keep people back from the broken leaf and tape or board the glass if that can be done safely.
Automatic door repairs in Oxfordshire: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: from £95 ex VAT (£114 inc VAT).
| Item | Guide price | Notes |
|---|---|---|
| Repair visit including the first hour, standard hours | £95 – £195 | ex VAT; homes £114 – £234 inc VAT |
| Repair visit, evenings and weekends | £195 – £300 | ex VAT; homes £234 – £360 inc VAT |
| Additional labour | £65 – £95 | per hour, ex VAT; homes £78 – £114 inc VAT |
| Sensor replacement | £195 – £495 | fitted, ex VAT; homes £234 – £594 inc VAT |
| Drive belt replacement | £145 – £345 | fitted, ex VAT; homes £174 – £414 inc VAT |
| Rollers, carriage wheels or floor guides | £195 – £495 | fitted, ex VAT; homes £234 – £594 inc VAT |
| Door off track or realignment | £125 – £345 | ex VAT; homes £150 – £414 inc VAT |
| Controller (control board) replacement | £395 – £895 | fitted, ex VAT; homes £474 – £1,074 inc VAT |
| Motor or gearbox replacement | £695 – £1,395 | fitted, ex VAT; homes £834 – £1,674 inc VAT |
The visit price is agreed in writing before an engineer attends. Parts and further work are quoted before they are done. Prices for faulty parts depend on the make and model of the door.
Standards and rules in England
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
How it works
- Tell us what is happening. Describe the fault, or the service or inspection that is due, and send photos of the door and any label on the operator. Include the address in Oxfordshire and how much the site depends on the door.
- Visit price agreed in writing. We confirm the price of the visit in writing before an engineer attends. If the door can be priced from photos and its make and model, we say so at this stage.
- Engineer visit. A specialist engineer working under our management diagnoses the fault or carries out the service, then tests the operation of the door and its safety sensors before leaving the site.
- Findings and follow-up. You receive a written record of what was found and done. Any parts or further work needed are quoted in writing before they go ahead, and nothing is added without your agreement.
Send us a photo of the faulty door and its operator label in Oxfordshire. We will confirm the visit price in writing and offer the earliest engineer visit available.
Automatic door repairs in Oxfordshire: questions
What if my door in Oxfordshire cannot be repaired?
If a drive unit is obsolete, or a repair would cost close to a new operator, the engineer explains why. A new drive unit can usually be fitted to the existing frame and leaves, which costs far less than a whole new door. You receive a written quote for that, and whether to go ahead is entirely your choice.
Can you give me a price for automatic door repairs in Oxfordshire?
Our guide starts from £95 excluding VAT (visit including the first hour), the same guide price we use across the UK. For homes that is from £114 including VAT. We agree the visit price in writing before an engineer attends in Oxfordshire, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Can you tell me the cost before visiting my premises in Oxfordshire?
We always confirm the visit price before attending. For some faults, photos of the door and the operator label let us price the repair itself in advance. Where the cause needs testing on site, parts and extra work are quoted after diagnosis and only go ahead if you agree.
How soon can an engineer get to my door in Oxfordshire?
That depends on engineer availability around Oxfordshire when you contact us, so we do not promise a time. Tell us whether the door is stuck open, stuck shut or unsafe, and we will tell you the earliest visit we can offer. Meanwhile, set the door to a safe mode and keep people away from the leaves.
How is the visit price set for work in Oxfordshire?
We agree the visit price with you in writing before an engineer attends. It is based on the type of door, the work requested and the location. If parts or further work are needed once the engineer has found the cause, those are quoted before they are done, so the cost never moves without your agreement.
How often should automatic doors in Oxfordshire be serviced?
No law sets a fixed interval. We recommend a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer's instructions and how heavily the door is used; busy doors are often serviced more often. Site staff should also carry out simple regular checks and keep a record of them.
Who is responsible for automatic doors on escape routes in Oxfordshire?
Under the Regulatory Reform (Fire Safety) Order 2005 the responsible person for the premises must make sure escape routes work and fire safety equipment is maintained. Automatic doors on an escape route need fail-safe opening or break-out, set by the fire strategy.