Coverage across Northamptonshire
Booking automatic door repairs in Northamptonshire does not depend on being close to a particular town. Engineers working under our management travel throughout the area, and nothing goes ahead until the price has been agreed in writing. Below are the towns we list here, 6 at present, each linking to a page with nearby places and guide prices.
Towns listed in Northamptonshire: Northampton, Corby, Kettering, Wellingborough, Rushden, Daventry.
What to think about for automatic door repairs in Northamptonshire
- Older shopfronts in Northamptonshire may have automatic doors with discontinued drive units. Ask whether parts are still available before agreeing to a large repair, as a new operator may be better value.
- Leisure centres, schools and public buildings in Northamptonshire may need a contractor induction or permit before work starts. Send any site rules with your booking so the visit can go ahead first time.
- Rule out the simple things. Check whether the door's isolator or fused spur has been switched off, and whether other equipment on the same circuit has also stopped working.
- Grit and stones in the floor guide are a frequent cause of doors sticking or stopping short. Sweeping the threshold and track area regularly prevents many breakdowns.
- A door with battery backup may show a fault, or fail to open in a power cut, when its battery is worn out. Batteries are a routine replacement part rather than a major repair.
Automatic door repairs in Northamptonshire: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: from £95 ex VAT (£114 inc VAT).
| Item | Guide price | Notes |
|---|---|---|
| Repair visit including the first hour, standard hours | £95 – £195 | ex VAT; homes £114 – £234 inc VAT |
| Repair visit, evenings and weekends | £195 – £300 | ex VAT; homes £234 – £360 inc VAT |
| Additional labour | £65 – £95 | per hour, ex VAT; homes £78 – £114 inc VAT |
| Sensor replacement | £195 – £495 | fitted, ex VAT; homes £234 – £594 inc VAT |
| Drive belt replacement | £145 – £345 | fitted, ex VAT; homes £174 – £414 inc VAT |
| Rollers, carriage wheels or floor guides | £195 – £495 | fitted, ex VAT; homes £234 – £594 inc VAT |
| Door off track or realignment | £125 – £345 | ex VAT; homes £150 – £414 inc VAT |
| Controller (control board) replacement | £395 – £895 | fitted, ex VAT; homes £474 – £1,074 inc VAT |
| Motor or gearbox replacement | £695 – £1,395 | fitted, ex VAT; homes £834 – £1,674 inc VAT |
The visit price is agreed in writing before an engineer attends. Parts and further work are quoted before they are done. Prices for faulty parts depend on the make and model of the door.
Standards and rules in England
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
How it works
- Tell us what is happening. Describe the fault, or the service or inspection that is due, and send photos of the door and any label on the operator. Include the address in Northamptonshire and how much the site depends on the door.
- Visit price agreed in writing. We confirm the price of the visit in writing before an engineer attends. If the door can be priced from photos and its make and model, we say so at this stage.
- Engineer visit. A specialist engineer working under our management diagnoses the fault or carries out the service, then tests the operation of the door and its safety sensors before leaving the site.
- Findings and follow-up. You receive a written record of what was found and done. Any parts or further work needed are quoted in writing before they go ahead, and nothing is added without your agreement.
For a written repair price in Northamptonshire, tell us the make of the door, what it is doing and whether it is stuck open, stuck shut or unsafe.
Automatic door repairs in Northamptonshire: questions
What if my door in Northamptonshire cannot be repaired?
If a drive unit is obsolete, or a repair would cost close to a new operator, the engineer explains why. A new drive unit can usually be fitted to the existing frame and leaves, which costs far less than a whole new door. You receive a written quote for that, and whether to go ahead is entirely your choice.
Is there a guide price for automatic door repairs in Northamptonshire?
Our guide starts from £95 excluding VAT (visit including the first hour), the same guide price we use across the UK. For homes that is from £114 including VAT. We agree the visit price in writing before an engineer attends in Northamptonshire, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Do engineers carry spare parts for doors in Northamptonshire?
Engineers carry common parts such as sensors, belts and some rollers. Controllers, motors and parts for less common doors are ordered once the fault is confirmed, and delivery is typically 1 to 3 weeks. Knowing the make and model in advance improves the chance of a repair during the first visit.
Can you repair revolving doors in Northamptonshire?
Yes. The engineers we send work on automatic and manual revolving doors as well as sliding and swing doors. Revolving doors have extra safety devices, such as stop buttons and edge sensors, which are all tested after a repair. Parts for some revolving doors take longer to source, so photos of the drive and control panel help us prepare.
Are parts quoted before they are fitted?
Always. If a repair or service in Northamptonshire needs parts, such as rollers, belts, sensors, a control board or a motor, we quote them in writing first. Some common parts may be on the engineer's van; others are ordered once you accept the quote and fitted on a return visit at a price already agreed.
Which makes of automatic door can you work on in Northamptonshire?
Engineers working under our management work on most makes of automatic door, including sliding, swing, folding, telescopic and revolving types. Some older or obsolete operators have limited parts availability. If that applies, we explain the options, which may include a replacement drive unit on the existing frame, and quote them before anything is ordered.
Which building regulations apply to a new automatic entrance in Northamptonshire?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.