Coverage across Wiltshire
Booking automatic door repairs in Wiltshire does not depend on being close to a particular town. Engineers working under our management travel throughout the area, and nothing goes ahead until the price has been agreed in writing. Below are the towns we list here, 7 at present, each linking to a page with nearby places and guide prices.
Towns listed in Wiltshire: Swindon, Salisbury, Trowbridge, Chippenham, Melksham, Warminster, Calne.
What to think about for automatic door repairs in Wiltshire
- Opening hours matter when booking a repair in Wiltshire. If your premises close early or open late, mention it so the engineer can work while the entrance is quiet.
- Wet and windy weather causes many false openings. Sensors over exposed entrances can react to rain and blowing leaves, and a small change to the detection zone often cures it.
- A door with battery backup may show a fault, or fail to open in a power cut, when its battery is worn out. Batteries are a routine replacement part rather than a major repair.
- Leisure centres, schools and public buildings in Wiltshire may need a contractor induction or permit before work starts. Send any site rules with your booking so the visit can go ahead first time.
- Rule out the simple things. Check whether the door's isolator or fused spur has been switched off, and whether other equipment on the same circuit has also stopped working.
Automatic door repairs in Wiltshire: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: from £95 ex VAT (£114 inc VAT).
| Item | Guide price | Notes |
|---|---|---|
| Repair visit including the first hour, standard hours | £95 – £195 | ex VAT; homes £114 – £234 inc VAT |
| Repair visit, evenings and weekends | £195 – £300 | ex VAT; homes £234 – £360 inc VAT |
| Additional labour | £65 – £95 | per hour, ex VAT; homes £78 – £114 inc VAT |
| Sensor replacement | £195 – £495 | fitted, ex VAT; homes £234 – £594 inc VAT |
| Drive belt replacement | £145 – £345 | fitted, ex VAT; homes £174 – £414 inc VAT |
| Rollers, carriage wheels or floor guides | £195 – £495 | fitted, ex VAT; homes £234 – £594 inc VAT |
| Door off track or realignment | £125 – £345 | ex VAT; homes £150 – £414 inc VAT |
| Controller (control board) replacement | £395 – £895 | fitted, ex VAT; homes £474 – £1,074 inc VAT |
| Motor or gearbox replacement | £695 – £1,395 | fitted, ex VAT; homes £834 – £1,674 inc VAT |
The visit price is agreed in writing before an engineer attends. Parts and further work are quoted before they are done. Prices for faulty parts depend on the make and model of the door.
Standards and rules in England
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
How it works
- Make contact. Phone, email or use the form. Tell us the type of door, what it is doing and whether it is safe to use, so the right visit for automatic door repairs can be planned.
- Written visit price. The cost of attending is agreed in writing before the visit is booked. For a planned service or inspection, the price per door and what each visit includes are set out at the same time.
- On-site work. The engineer, working under our management, checks the door from end to end, deals with the fault or the service, and tests every safety function and sensor setting before signing the door off.
- Report and quote. You receive a report of the findings. Where a repair, part or upgrade is recommended, it is quoted in writing so you can decide, and the door is left in a safe state if it cannot be used.
For a written repair price in Wiltshire, tell us the make of the door, what it is doing and whether it is stuck open, stuck shut or unsafe.
Automatic door repairs in Wiltshire: questions
Can you repair revolving doors in Wiltshire?
Yes. The engineers we send work on automatic and manual revolving doors as well as sliding and swing doors. Revolving doors have extra safety devices, such as stop buttons and edge sensors, which are all tested after a repair. Parts for some revolving doors take longer to source, so photos of the drive and control panel help us prepare.
How are prices worked out for automatic door repairs in Wiltshire?
Our guide starts from £95 excluding VAT (visit including the first hour), the same guide price we use across the UK. For homes that is from £114 including VAT. We agree the visit price in writing before an engineer attends in Wiltshire, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Do engineers carry spare parts for doors in Wiltshire?
Engineers carry common parts such as sensors, belts and some rollers. Controllers, motors and parts for less common doors are ordered once the fault is confirmed, and delivery is typically 1 to 3 weeks. Knowing the make and model in advance improves the chance of a repair during the first visit.
Do you repair automatic doors in Wiltshire?
Yes. We take the booking, agree the price and manage the job, and the visit in Wiltshire is made by a specialist automatic door engineer working under our management. The engineers we send work on sliding, swing, folding and revolving doors from most makers, including doors we did not install. The visit price is confirmed with you in writing before the engineer is booked.
How is the visit price set for work in Wiltshire?
We agree the visit price with you in writing before an engineer attends. It is based on the type of door, the work requested and the location. If parts or further work are needed once the engineer has found the cause, those are quoted before they are done, so the cost never moves without your agreement.
What happens during a visit in Wiltshire?
The engineer checks how the door is operating, diagnoses the fault or carries out the service, and tests the safety sensors and other functions before leaving. On a service visit that includes cleaning, adjustment and lubrication where needed. Anything that cannot be put right on the visit, or that needs parts, is explained and quoted before further work goes ahead.
Can a home in Wiltshire get help paying for a door opener?
Possibly. In England a Disabled Facilities Grant of up to £30,000 can fund adaptations that make it easier to get in and out of a home. It is means-tested and must be approved by the council before work starts, so ask your council and occupational therapist.