Coverage across Gwent
Booking safety inspections and risk assessments in Gwent does not depend on being close to a particular town. Engineers working under our management travel throughout the area, and nothing goes ahead until the price has been agreed in writing. Below are the towns we list here, 14 at present, each linking to a page with nearby places and guide prices.
Towns listed in Gwent: Newport, Cwmbran, Pontypool, Ebbw Vale, Caerphilly, Blackwood, Tredegar, Abergavenny, Bargoed, Chepstow, Risca, Abertillery, Monmouth, Caldicot.
What to think about for safety inspections and risk assessments in Gwent
- Retail entrances in Gwent with heavy footfall can have sensors knocked out of alignment over time. The inspection checks that detection still covers the full closing edge.
- Shared entrances in office blocks and business parks in Gwent may serve several tenants. Agree who holds the report and who pays for upgrades before booking.
- Schools and nurseries need particular care with finger traps at hinges and beside side screens, because children are more likely to put their hands into gaps.
- Older shopfronts and listed buildings in Gwent may have narrow side screens and tight gaps that were thought acceptable when fitted. The report weighs what can reasonably be improved.
- Power failure behaviour is easy to overlook. The inspection tests what the door does when the mains supply or battery fails, which matters most on escape routes.
Safety inspections and risk assessments in Gwent: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: typically £125 to £250 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Safety inspection and risk assessment, existing door | £125 – £250 | per door, written report, ex VAT |
| Inspection added to a service visit | reduced | quoted with the service |
| Upgrades found by the inspection | quoted separately | see safety and compliance upgrades |
The inspection price is agreed in writing before the visit. Any upgrades the report recommends are quoted separately so you can plan them.
Standards and rules in Wales
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
How it works
- Tell us what is happening. Describe the fault, or the service or inspection that is due, and send photos of the door and any label on the operator. Include the address in Gwent and how much the site depends on the door.
- Visit price agreed in writing. We confirm the price of the visit in writing before an engineer attends. If the door can be priced from photos and its make and model, we say so at this stage.
- Engineer visit. A specialist engineer working under our management diagnoses the fault or carries out the service, then tests the operation of the door and its safety sensors before leaving the site.
- Findings and follow-up. You receive a written record of what was found and done. Any parts or further work needed are quoted in writing before they go ahead, and nothing is added without your agreement.
Ask for an inspection price for your site in Gwent. Every door is assessed on its hazard zones, and upgrades are quoted separately if you want them.
Safety inspections and risk assessments in Gwent: questions
How long will our door in Gwent be out of use during the inspection?
Usually only for short periods while sensors are tested and the door is observed in different modes. A single door generally takes about an hour in total. For busy entrances the inspection can be planned for a quieter time, or one leaf tested at a time where the door allows it.
What price range should I expect for safety inspections and risk assessments in Gwent?
Our guide is £125 to £250 excluding VAT (per door), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in Gwent, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
What if a door in Gwent is found to be unsafe?
The engineer explains the problem before leaving and may recommend switching the door to a safer mode until it is fixed. High-priority findings are flagged at the top of the report. We can quote the repair or upgrade straight away, or you can arrange it with another competent installer.
Can you inspect all the doors on our site in Gwent in one visit?
Usually, yes. A whole-site inspection covers every automatic door in one visit and one report, with each door's findings ranked so you can compare priorities across the site. Larger sites may need more than one day, which we agree with you when the inspection is priced.
Which makes of automatic door can you work on in Gwent?
Engineers working under our management work on most makes of automatic door, including sliding, swing, folding, telescopic and revolving types. Some older or obsolete operators have limited parts availability. If that applies, we explain the options, which may include a replacement drive unit on the existing frame, and quote them before anything is ordered.
Do you leave a written record after each visit in Gwent?
Yes. Every visit ends with a written record of what was checked, what was done and anything that still needs attention. For safety inspections you receive a report of the findings and a site-specific risk assessment. Keeping these on file is the usual way to show that a workplace door is maintained and in good working order.
Do businesses in Gwent have to fit automatic doors?
There is no blanket requirement. Service providers and employers must make reasonable adjustments for disabled people under the Equality Act 2010, and Welsh building regulations guidance expects entrances that are easy to open. An automatic door is a common way to meet both.