Coverage across Mid Glamorgan
Enquiries about safety inspections and risk assessments come to us from right across Mid Glamorgan, and each one is handled the same way. Specialist automatic door engineers working under our management travel to the address, and we remain your contracting party throughout. The 10 towns we list below are a starting point, not a boundary: villages, business parks and rural sites in between are covered as well.
Towns listed in Mid Glamorgan: Bridgend, Merthyr Tydfil, Pontypridd, Aberdare, Maesteg, Porthcawl, Porth, Mountain Ash, Tonyrefail, Pencoed.
What to think about for safety inspections and risk assessments in Mid Glamorgan
- Power failure behaviour is easy to overlook. The inspection tests what the door does when the mains supply or battery fails, which matters most on escape routes.
- Care homes and hospitals in Mid Glamorgan have users who move slowly or unpredictably. The inspection pays close attention to sensor coverage and door speeds where frail or confused people pass through.
- Retail entrances in Mid Glamorgan with heavy footfall can have sensors knocked out of alignment over time. The inspection checks that detection still covers the full closing edge.
- Doors on escape routes must let people out safely during a fire or evacuation. The inspection checks break-out, power-failure opening or manual release, as the fire strategy requires.
- Insurers sometimes ask for inspection reports at renewal. Booking the inspection well before the renewal date gives you time to act on any high-priority findings first.
Safety inspections and risk assessments in Mid Glamorgan: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: typically £125 to £250 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Safety inspection and risk assessment, existing door | £125 – £250 | per door, written report, ex VAT |
| Inspection added to a service visit | reduced | quoted with the service |
| Upgrades found by the inspection | quoted separately | see safety and compliance upgrades |
The inspection price is agreed in writing before the visit. Any upgrades the report recommends are quoted separately so you can plan them.
Standards and rules in Wales
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
How it works
- Explain the problem. Whether the door is stuck, slow, noisy or due its next check, a short description and a few photos tell us which kind of visit to book for safety inspections and risk assessments and what to bring.
- Visit cost agreed. You get the visit price in writing before we book the engineer. There are no hidden extras: parts and further work are always quoted separately and in advance.
- Engineer on site. The engineer inspects the operator, sensors, tracks and leaves, carries out the repair or service, and runs the door through its safety tests before it goes back into use.
- Follow-up quoted. You are sent a record of the visit. If something else needs attention, we quote it in writing; for doors on a service plan, the next visit date is noted on the record.
Ask for an inspection price for your site in Mid Glamorgan. Every door is assessed on its hazard zones, and upgrades are quoted separately if you want them.
Safety inspections and risk assessments in Mid Glamorgan: questions
Do you carry out automatic door safety inspections in Mid Glamorgan?
Yes. We organise the inspection and issue the report, and the assessment in Mid Glamorgan is carried out by a specialist engineer under our management. Each door is assessed on site against BS EN 16005 hazard zones, its safety sensors are tested and you receive a written report with ranked findings. The inspection price is agreed in writing before the visit.
How much should I budget for safety inspections and risk assessments in Mid Glamorgan?
Our guide is £125 to £250 excluding VAT (per door), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in Mid Glamorgan, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Can an inspection in Mid Glamorgan be combined with a service?
Yes, and it often makes sense. The engineer services the door, then carries out the risk assessment while on site, which saves a second visit. The combined price is agreed in writing before the visit, and you receive both the service record and the inspection report.
How often should doors in Mid Glamorgan be risk assessed?
There is no set legal frequency. Most owners assess each door once, then repeat the assessment when the door is altered, when the people using it change or after an incident. In between, regular servicing keeps the safety functions checked, which in our view should happen at least once a year.
Which makes of automatic door can you work on in Mid Glamorgan?
Engineers working under our management work on most makes of automatic door, including sliding, swing, folding, telescopic and revolving types. Some older or obsolete operators have limited parts availability. If that applies, we explain the options, which may include a replacement drive unit on the existing frame, and quote them before anything is ordered.
Do you offer service contracts in Mid Glamorgan?
Yes. A service contract sets out how many visits a year each door receives, what each visit includes and the price, all agreed in writing before you sign. Contracts suit sites with several doors or busy entrances, because visits are planned ahead and the records stay in one place. Contract length and notice terms are shown in the agreement.
Are the rules for automatic doors different in Wales?
Some are. Wales has its own building regulations guidance: Approved Document M (Wales) calls for a powered door where opening a self-closing entrance door would need more than 20 N, lower than the figure used in England. Fire law (the Regulatory Reform (Fire Safety) Order 2005) and the Equality Act 2010 apply as in England.