Coverage across Somerset
Not every part of Somerset is easy to reach, and some sites need planning around access, parking or opening hours. We take that into account when arranging automatic door repairs, and the engineer, working under our management, arrives with what the job is likely to need. The towns below, 11 in all, each have their own page, but any address in the area can be covered.
Towns listed in Somerset: Bath, Weston-super-Mare, Taunton, Yeovil, Bridgwater, Portishead, Frome, Burnham-on-Sea, Clevedon, Nailsea, Keynsham.
What to think about for automatic door repairs in Somerset
- For surgeries, clinics and care settings in Somerset, a door that will not open can stop wheelchair users getting in. Plan an alternative accessible entrance and clear signs while the repair is arranged.
- Doors knocked by trolleys, pushchairs or deliveries often go out of line. Repeated impacts damage rollers and floor guides, so it helps to know roughly when the fault first appeared.
- Older shopfronts in Somerset may have automatic doors with discontinued drive units. Ask whether parts are still available before agreeing to a large repair, as a new operator may be better value.
- Leisure centres, schools and public buildings in Somerset may need a contractor induction or permit before work starts. Send any site rules with your booking so the visit can go ahead first time.
- A door with battery backup may show a fault, or fail to open in a power cut, when its battery is worn out. Batteries are a routine replacement part rather than a major repair.
Automatic door repairs in Somerset: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: from £95 ex VAT (£114 inc VAT).
| Item | Guide price | Notes |
|---|---|---|
| Repair visit including the first hour, standard hours | £95 – £195 | ex VAT; homes £114 – £234 inc VAT |
| Repair visit, evenings and weekends | £195 – £300 | ex VAT; homes £234 – £360 inc VAT |
| Additional labour | £65 – £95 | per hour, ex VAT; homes £78 – £114 inc VAT |
| Sensor replacement | £195 – £495 | fitted, ex VAT; homes £234 – £594 inc VAT |
| Drive belt replacement | £145 – £345 | fitted, ex VAT; homes £174 – £414 inc VAT |
| Rollers, carriage wheels or floor guides | £195 – £495 | fitted, ex VAT; homes £234 – £594 inc VAT |
| Door off track or realignment | £125 – £345 | ex VAT; homes £150 – £414 inc VAT |
| Controller (control board) replacement | £395 – £895 | fitted, ex VAT; homes £474 – £1,074 inc VAT |
| Motor or gearbox replacement | £695 – £1,395 | fitted, ex VAT; homes £834 – £1,674 inc VAT |
The visit price is agreed in writing before an engineer attends. Parts and further work are quoted before they are done. Prices for faulty parts depend on the make and model of the door.
Standards and rules in England
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
How it works
- Explain the problem. Whether the door is stuck, slow, noisy or due its next check, a short description and a few photos tell us which kind of visit to book for automatic door repairs and what to bring.
- Visit cost agreed. You get the visit price in writing before we book the engineer. There are no hidden extras: parts and further work are always quoted separately and in advance.
- Engineer on site. The engineer inspects the operator, sensors, tracks and leaves, carries out the repair or service, and runs the door through its safety tests before it goes back into use.
- Follow-up quoted. You are sent a record of the visit. If something else needs attention, we quote it in writing; for doors on a service plan, the next visit date is noted on the record.
For a written repair price in Somerset, tell us the make of the door, what it is doing and whether it is stuck open, stuck shut or unsafe.
Automatic door repairs in Somerset: questions
Can you repair revolving doors in Somerset?
Yes. The engineers we send work on automatic and manual revolving doors as well as sliding and swing doors. Revolving doors have extra safety devices, such as stop buttons and edge sensors, which are all tested after a repair. Parts for some revolving doors take longer to source, so photos of the drive and control panel help us prepare.
What will automatic door repairs in Somerset cost?
Our guide starts from £95 excluding VAT (visit including the first hour), the same guide price we use across the UK. For homes that is from £114 including VAT. We agree the visit price in writing before an engineer attends in Somerset, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Is it safe to keep using a faulty automatic door in Somerset?
It depends on the fault. A slow or noisy door may be safe to use until the visit, but a door that strikes people, closes unexpectedly or has damaged glass should be switched off and kept clear. If you are unsure, switch it off and use another entrance until an engineer has checked it.
Do you repair automatic doors in Somerset?
Yes. We take the booking, agree the price and manage the job, and the visit in Somerset is made by a specialist automatic door engineer working under our management. The engineers we send work on sliding, swing, folding and revolving doors from most makers, including doors we did not install. The visit price is confirmed with you in writing before the engineer is booked.
How is the visit price set for work in Somerset?
We agree the visit price with you in writing before an engineer attends. It is based on the type of door, the work requested and the location. If parts or further work are needed once the engineer has found the cause, those are quoted before they are done, so the cost never moves without your agreement.
How often should automatic doors in Somerset be serviced?
No law sets a fixed interval. We recommend a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer's instructions and how heavily the door is used; busy doors are often serviced more often. Site staff should also carry out simple regular checks and keep a record of them.
Which building regulations apply to a new automatic entrance in Somerset?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.