Coverage across Lanarkshire
Here is how coverage works in Lanarkshire. You contact us with the address and what the door needs, we confirm the price in writing, and a specialist engineer working under our management attends on an agreed date. That applies to sensor upgrades and replacement at a single shop door or across a whole estate of buildings, in any of the towns below or between them.
Towns listed in Lanarkshire: East Kilbride, Hamilton, Cumbernauld, Coatbridge, Airdrie, Motherwell, Rutherglen, Cambuslang, Wishaw, Bellshill, Blantyre, Larkhall, Carluke, Kilsyth.
What to think about for sensor upgrades and replacement in Lanarkshire
- Shiny, wet or newly polished floors can confuse infrared safety sensors. Mention any recent floor changes at your building in Lanarkshire so the zones can be set for the new surface.
- Corridor doors that people walk past rather than through may work better on a touch-free switch than a motion sensor, cutting needless openings and heat loss.
- Doors with side screens may need a light curtain on the leaf edge or post to protect the gap. This is one of the most common upgrades on older sliding doors.
- Sensor changes on escape route doors must never stop the door opening when it needs to. The engineer checks the door's escape mode after any sensor work.
- Care settings in Lanarkshire often need longer hold-open times and wider safety zones for residents who move slowly, use walking frames or pause in the doorway.
Sensor upgrades and replacement in Lanarkshire: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: typically £195 to £495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Add or replace a safety or activation sensor | £195 – £495 | per sensor fitted, ex VAT |
| Touch-free switch or push pad | £145 – £395 | per switch, ex VAT |
| Side-screen or light-curtain protection | from £295 | per door, ex VAT; on survey |
Sensor prices cover the part, fitting and set-up. If a sensor is fitted on a visit of its own, the visit charge (from £95 ex VAT) is added, and we confirm the total in writing before an engineer attends. Each sensor is set up for the door and tested before the engineer leaves.
Standards and rules in Scotland
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
How it works
- Explain the problem. Whether the door is stuck, slow, noisy or due its next check, a short description and a few photos tell us which kind of visit to book for sensor upgrades and replacement and what to bring.
- Visit cost agreed. You get the visit price in writing before we book the engineer. There are no hidden extras: parts and further work are always quoted separately and in advance.
- Engineer on site. The engineer inspects the operator, sensors, tracks and leaves, carries out the repair or service, and runs the door through its safety tests before it goes back into use.
- Follow-up quoted. You are sent a record of the visit. If something else needs attention, we quote it in writing; for doors on a service plan, the next visit date is noted on the record.
Ask for a price on new safety or activation sensors in Lanarkshire. Each one is set up for the door's hazard zones and tested before the engineer leaves.
Sensor upgrades and replacement in Lanarkshire: questions
Will you record the sensor settings for our building in Lanarkshire?
Yes. The job report lists each sensor fitted, its position, the settings used and the test results. Keep it with your service records, as it helps future engineers and shows the door's safety set-up was checked after the work. The same details are useful if an insurer or inspector asks.
What do you charge for sensor upgrades and replacement in Lanarkshire?
Our guide is £195 to £495 excluding VAT (per sensor fitted), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in Lanarkshire, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Can you upgrade sensors on an old door in Lanarkshire?
Most older doors can take modern sensors. A few very old controllers cannot monitor current safety sensors. If yours is one of them, we explain whether a controller upgrade or a new drive unit is the better option, and quote it, before any work is done.
Do engineers carry sensors for doors in Lanarkshire?
Engineers carry common combined and safety sensors, so many replacements can be fitted at the first visit. Light curtains and specialist sensors are ordered once the door is identified, with delivery typically 1 to 2 weeks. Photos in advance help us bring the right part first time.
Are parts quoted before they are fitted?
Always. If a repair or service in Lanarkshire needs parts, such as rollers, belts, sensors, a control board or a motor, we quote them in writing first. Some common parts may be on the engineer's van; others are ordered once you accept the quote and fitted on a return visit at a price already agreed.
Can visits in Lanarkshire be arranged outside working hours?
Yes, where the site needs it. Early-morning, evening and weekend visits can be arranged for shops, surgeries and offices that cannot lose their entrance during the day. Any difference in price for out-of-hours attendance is agreed in writing before the visit is booked, alongside the standard visit price.
Is a building warrant needed for a new automatic entrance in Lanarkshire?
Often, yes. Most building work in Scotland needs a building warrant before it starts, and the non-domestic Technical Handbook sets out what an accessible entrance should provide, including a clear opening of at least 800 mm. We tell you at the survey if your job is likely to need one.