Coverage across Argyll and Bute
Our coverage of Argyll and Bute is not tied to a depot or a showroom. Engineers who carry out automatic door repairs for us travel to each site, so a farm shop down a country lane goes through the same process as a city-centre office. Every job is priced in writing before work starts, and the town list below currently numbers 7.
Towns listed in Argyll and Bute: Helensburgh, Dunoon, Oban, Campbeltown, Rothesay, Tobermory, Bowmore.
What to think about for automatic door repairs in Argyll and Bute
- Glass damage needs prompt action to keep people safe. Switch the door off, keep people back from the broken leaf and tape or board the glass if that can be done safely.
- For surgeries, clinics and care settings in Argyll and Bute, a door that will not open can stop wheelchair users getting in. Plan an alternative accessible entrance and clear signs while the repair is arranged.
- Busy high street shops in Argyll and Bute lose trade quickly when the entrance fails. Keep the programme switch key where staff can find it, so the door can be set to a safe mode while you wait.
- Opening hours matter when booking a repair in Argyll and Bute. If your premises close early or open late, mention it so the engineer can work while the entrance is quiet.
- Wet and windy weather causes many false openings. Sensors over exposed entrances can react to rain and blowing leaves, and a small change to the detection zone often cures it.
Automatic door repairs in Argyll and Bute: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: from £95 ex VAT (£114 inc VAT).
| Item | Guide price | Notes |
|---|---|---|
| Repair visit including the first hour, standard hours | £95 – £195 | ex VAT; homes £114 – £234 inc VAT |
| Repair visit, evenings and weekends | £195 – £300 | ex VAT; homes £234 – £360 inc VAT |
| Additional labour | £65 – £95 | per hour, ex VAT; homes £78 – £114 inc VAT |
| Sensor replacement | £195 – £495 | fitted, ex VAT; homes £234 – £594 inc VAT |
| Drive belt replacement | £145 – £345 | fitted, ex VAT; homes £174 – £414 inc VAT |
| Rollers, carriage wheels or floor guides | £195 – £495 | fitted, ex VAT; homes £234 – £594 inc VAT |
| Door off track or realignment | £125 – £345 | ex VAT; homes £150 – £414 inc VAT |
| Controller (control board) replacement | £395 – £895 | fitted, ex VAT; homes £474 – £1,074 inc VAT |
| Motor or gearbox replacement | £695 – £1,395 | fitted, ex VAT; homes £834 – £1,674 inc VAT |
The visit price is agreed in writing before an engineer attends. Parts and further work are quoted before they are done. Prices for faulty parts depend on the make and model of the door.
Standards and rules in Scotland
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
How it works
- Tell us what is happening. Describe the fault, or the service or inspection that is due, and send photos of the door and any label on the operator. Include the address in Argyll and Bute and how much the site depends on the door.
- Visit price agreed in writing. We confirm the price of the visit in writing before an engineer attends. If the door can be priced from photos and its make and model, we say so at this stage.
- Engineer visit. A specialist engineer working under our management diagnoses the fault or carries out the service, then tests the operation of the door and its safety sensors before leaving the site.
- Findings and follow-up. You receive a written record of what was found and done. Any parts or further work needed are quoted in writing before they go ahead, and nothing is added without your agreement.
Managing doors across several sites in and around Argyll and Bute? Send us the list of faults and we will price each visit in writing before booking engineers.
Automatic door repairs in Argyll and Bute: questions
Do engineers carry spare parts for doors in Argyll and Bute?
Engineers carry common parts such as sensors, belts and some rollers. Controllers, motors and parts for less common doors are ordered once the fault is confirmed, and delivery is typically 1 to 3 weeks. Knowing the make and model in advance improves the chance of a repair during the first visit.
How much should I budget for automatic door repairs in Argyll and Bute?
Our guide starts from £95 excluding VAT (visit including the first hour), the same guide price we use across the UK. For homes that is from £114 including VAT. We agree the visit price in writing before an engineer attends in Argyll and Bute, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Do you keep records of repairs for buildings in Argyll and Bute?
Yes. Each visit produces a written report of the fault found, the work done and any parts fitted or recommended. Facilities teams can keep these with the door's service records, which helps show the door is being maintained and makes repeat faults easier to trace.
What if my door in Argyll and Bute cannot be repaired?
If a drive unit is obsolete, or a repair would cost close to a new operator, the engineer explains why. A new drive unit can usually be fitted to the existing frame and leaves, which costs far less than a whole new door. You receive a written quote for that, and whether to go ahead is entirely your choice.
Can you price a repair in Argyll and Bute from photos?
Sometimes. Clear photos of the door, the operator cover and any label showing the make and model, plus a description of what the door is doing, can let us price a likely repair before a visit. Where the cause is not obvious, we agree a diagnostic visit price in writing first and quote the repair afterwards.
Can you take over servicing of doors in Argyll and Bute from another company?
Yes. Send us the door details and, if you have them, previous service records or inspection reports. The first visit gives a baseline for each door, and its price is agreed in writing beforehand. From then on, records continue in one consistent format, whichever company looked after the doors before.
Who is responsible for automatic doors on escape routes in Argyll and Bute?
The person responsible for fire safety under the Fire (Scotland) Act 2005 for those premises. Scottish guidance allows automatic doors on escape routes only where they fail safely to outward opening or have a monitored fail-safe system that opens them on power failure, sensor failure and fire alarm.