Coverage across Lancashire
There is no branch to visit in Lancashire; instead, specialist engineers working under our management travel to you. That keeps telescopic sliding doors available across the whole area, including smaller towns and rural addresses. The page for each of the 21 towns we list below sets out nearby places, guide prices and the questions people usually ask.
Towns listed in Lancashire: Preston, Burnley, Blackburn, Blackpool, Morecambe, Lancaster, Lytham St Annes, Skelmersdale, Bamber Bridge, Leyland, Accrington, Chorley, Darwen, Thornton-Cleveleys, Nelson, Fleetwood, Ormskirk, Rawtenstall, Colne, Poulton-le-Fylde, Heysham.
What to think about for telescopic sliding doors in Lancashire
- Floor guides on two sets of leaves need a level, firm floor. Cracked screed, rocking tiles or a sloping threshold should be put right before fitting, and the quote will say who does it.
- Measure the widest thing that has to pass through, whether that is a hospital bed, a mobility scooter or a cage of stock. The clear opening of a telescopic door is chosen from that figure, not from the size of the old doorway.
- A telescopic header is deeper than a standard one. In older buildings in Lancashire with low ceilings or decorative fanlights, the survey checks whether the header can sit above the opening or needs to be recessed.
- Grit and leaves blown into the threshold collect in floor guide channels. Entrances facing a car park or open ground benefit from a matwell or canopy, which also keeps rain off the sensors.
- Care homes and supported living buildings in Lancashire may want the main door to open freely for visitors but stay locked for some residents. A keypad or fob reader on the inside can be wired to the operator.
Telescopic sliding doors in Lancashire: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £6,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Telescopic single-slide, two leaves | £6,995 – £9,995 | installed, ex VAT |
| Telescopic bi-parting, four leaves | £8,995 – £13,995 | installed, ex VAT |
| Very wide or full-height openings | Priced on survey | measured and designed at the survey |
| Touch-free switch or push pad, fitted | £145 – £395 | per switch, ex VAT |
| Card or fob reader tied into the door | £795 – £2,495 | per door, ex VAT |
Standards and rules in England
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking. Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, which can include altering a physical feature such as a heavy entrance door. New entrances and some alterations count as building work, so check with building control before the work is ordered.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in Lancashire.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Book a free site survey in Lancashire, and an engineer will measure the opening and send a drawing with a fixed, itemised quote for telescopic sliding doors.
Telescopic sliding doors in Lancashire: questions
Will a telescopic door in Lancashire work with our fire alarm?
It can. The operator can take a signal from the fire alarm panel so the door opens and stays open, or does whatever the fire strategy for the building requires. The panel connection is usually made by your alarm engineer, and the quote shows who is responsible for each part of the work.
What is the guide price for telescopic sliding doors in Lancashire?
Our guide starts from £6,995 excluding VAT (per door set), the same guide price we use across the UK. The free site survey in Lancashire confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
What paperwork do we get after installation in Lancashire?
You receive the commissioning and test record, a site-specific risk assessment, user instructions and the conformity paperwork for the door. Keep them with your building records. They are the starting point for later servicing and safety inspections, and they show how the door was set up with reference to BS EN 16005.
Do we need to close our building in Lancashire while the door is fitted?
Usually not for long. Most telescopic entrances take one to two days on site, and the opening can be secured overnight. Where the entrance is the only way in, we plan the work around your hours, use another entrance if there is one, or work early or at weekends, with any extra cost shown in the quote.
What is the lead time for telescopic sliding doors in Lancashire?
Lead times depend on the door type and what has to be made to order. As a guide, operators and accessible door kits are typically two to four weeks from order, and complete sliding entrances typically four to eight weeks from drawing approval. Curved, revolving and hermetic doors usually take longer. The expected lead time is stated in your quote.
How are payments structured for work in Lancashire?
Payment stages are set out in the quote before you accept it. Larger or made-to-order jobs may involve a deposit and a balance on completion, while smaller jobs may be invoiced once the work is finished. Nothing is charged for the survey itself, and the terms you accept are the terms that apply.
Do businesses in Lancashire have to fit automatic doors?
No law says every building must have automatic doors. Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, and building regulations guidance in England calls for a powered door where an entrance door would otherwise be too heavy to open. An automatic door is often the simplest way to meet both.