Coverage across Mid Glamorgan
Not every part of Mid Glamorgan is easy to reach, and some sites need planning around access, parking or opening hours. We take that into account when arranging drive unit replacement, and the engineer, working under our management, arrives with what the job is likely to need. The towns below, 10 in all, each have their own page, but any address in the area can be covered.
Towns listed in Mid Glamorgan: Bridgend, Merthyr Tydfil, Pontypridd, Aberdare, Maesteg, Porthcawl, Porth, Mountain Ash, Tonyrefail, Pencoed.
What to think about for drive unit replacement in Mid Glamorgan
- If the door is on an escape route, the new drive unit must be set up to open, break out or be openable by hand, as the building's fire strategy requires.
- Worn floor guides and rollers can shorten the life of a new operator. It is often worth replacing them during the same visit rather than coming back later.
- Ask for the paperwork. A converted door should come with its risk assessment, Declaration of Conformity and user instructions, which belong with your building and maintenance records.
- Busy retail entrances in Mid Glamorgan may prefer the changeover after closing time or on a quiet trading day. Tell us your hours when you book the survey.
- Battery backup is easier to add with a new drive unit. It lets the door open or close safely in a power cut, which matters most on escape routes.
Drive unit replacement in Mid Glamorgan: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: typically £1,995 to £3,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| New drive unit on an existing automatic sliding door | £1,995 – £3,995 | existing leaves kept, installed, ex VAT |
| New operator on an existing automatic swing door | £1,795 – £3,995 | installed, ex VAT |
| Sensors replaced at the same time | £195 – £495 | per sensor, ex VAT |
Standards and rules in Wales
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Get in touch. Call, email or use the form with the address and what you have in mind. If you are not sure which type of door suits, describe the entrance and we will suggest the options worth considering.
- Survey and advice. The survey costs nothing and carries no obligation. The engineer checks the site and explains which options suit the entrance, the people using it and the budget, before anything is priced.
- Quote in writing. You receive a fixed, itemised quote for drive unit replacement in Mid Glamorgan, covering equipment, installation, testing and handover, with the lead time and payment stages set out clearly.
- Install, test, explain. The engineer installs and commissions the door, tests the sensors, safety functions and emergency behaviour, and walks you through the controls. The handover pack records what was installed and tested.
Keep the frame, replace the drive. Arrange a free survey in Mid Glamorgan and receive a fixed quote covering the new operator, sensors and paperwork.
Drive unit replacement in Mid Glamorgan: questions
Will you remove the old operator from our premises in Mid Glamorgan?
Yes. The old drive unit, sensors and any other replaced parts are taken away as part of the job, and the work area is left clean. Disposal is included in the fixed quote, so there is nothing extra to arrange or pay for afterwards.
What do you charge for drive unit replacement in Mid Glamorgan?
Our guide is £1,995 to £3,995 excluding VAT (per door), the same guide prices we use across the UK. The free site survey in Mid Glamorgan confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Do you replace automatic door drive units in Mid Glamorgan?
Yes. We are the contracting party for drive unit replacements in Mid Glamorgan, and the survey and changeover are carried out by specialist engineers we manage. The survey is free and checks that the frame and leaves are worth keeping. You then receive a fixed, itemised quote for the new operator, sensors and any other parts the door needs.
Can you fit a new operator to a door another company installed in Mid Glamorgan?
Yes. We replace drive units on doors whoever fitted them. The survey identifies the existing header, leaves and track, and adapter plates usually let a new drive unit from one of the major European operator brands fit without changing the frame.
How do you make sure the door works for disabled visitors in Mid Glamorgan?
We look at who uses the entrance: wheelchair users, people with walking aids, parents with buggies and older visitors. That shapes the opening width, the opening speed, the hold-open time and where push pads or sensors go. Service providers and employers have duties to make reasonable adjustments under equality and accessibility law, and an automatic door is a common one.
Can automatic doors be fitted to a listed building in Mid Glamorgan?
Often, yes, but listed building consent is normally needed for changes that affect the character of the building, inside or out. Slim operators, concealed fixings and automating the existing door can all reduce the visual impact. Speak to the conservation officer at the local planning authority early; we can provide drawings and specifications to help.
Who is responsible for automatic doors on escape routes in Mid Glamorgan?
The responsible person under the Regulatory Reform (Fire Safety) Order 2005. Automatic doors on an escape route need fail-safe opening or break-out, and sliding or revolving doors must not be used for exits specifically intended as emergency exits.