Coverage across West Glamorgan
Wherever you are in West Glamorgan, we need the same three things to get started on drive unit replacement: a short description of the door, a few photos if you have them, and the address. From there we agree the price in writing and book a specialist engineer working under our management. Every town listed below has a page of its own, 4 in total.
Towns listed in West Glamorgan: Swansea, Neath, Port Talbot, Gorseinon.
What to think about for drive unit replacement in West Glamorgan
- Older shopfronts in West Glamorgan may have headers made for discontinued operators. Adapter plates usually allow a new drive unit to fit, which the survey confirms before you commit.
- Busy retail entrances in West Glamorgan may prefer the changeover after closing time or on a quiet trading day. Tell us your hours when you book the survey.
- Ask for the paperwork. A converted door should come with its risk assessment, Declaration of Conformity and user instructions, which belong with your building and maintenance records.
- Check the power supply. A dedicated fused spur and isolator near the door is usually needed, and older installations sometimes need electrical work before the new operator goes in.
- If the door is on an escape route, the new drive unit must be set up to open, break out or be openable by hand, as the building's fire strategy requires.
Drive unit replacement in West Glamorgan: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: typically £1,995 to £3,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| New drive unit on an existing automatic sliding door | £1,995 – £3,995 | existing leaves kept, installed, ex VAT |
| New operator on an existing automatic swing door | £1,795 – £3,995 | installed, ex VAT |
| Sensors replaced at the same time | £195 – £495 | per sensor, ex VAT |
Standards and rules in Wales
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Send photos and the address. A few pictures of the door from both sides, the address in West Glamorgan and a note of who uses the entrance help us understand the job before anyone visits the site.
- No-cost survey on site. We arrange a survey at a time that suits the building. The engineer records measurements, fixings and power, plus any constraints such as listed status, opening hours or access for deliveries.
- Itemised quote to approve. We price every element of the work on drive unit replacement separately in a written quote that you can check, share and approve. Lead time and payment stages are stated, and nothing is ordered until you accept.
- Fit, test and hand over. On the agreed dates the engineer installs the equipment, commissions the operator and tests each safety function. You get a demonstration, the test record and any conformity paperwork that applies to the work.
Get in touch about drive unit replacement in West Glamorgan. The door is surveyed free of charge and the changeover planned around your opening hours.
Drive unit replacement in West Glamorgan: questions
Will you remove the old operator from our premises in West Glamorgan?
Yes. The old drive unit, sensors and any other replaced parts are taken away as part of the job, and the work area is left clean. Disposal is included in the fixed quote, so there is nothing extra to arrange or pay for afterwards.
What is the guide price for drive unit replacement in West Glamorgan?
Our guide is £1,995 to £3,995 excluding VAT (per door), the same guide prices we use across the UK. The free site survey in West Glamorgan confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
How long will our entrance in West Glamorgan be closed for the changeover?
A standard sliding door changeover typically takes a day, and a swing operator often less. The work can be scheduled early, after closing or at a weekend so it causes less disruption. Your quote shows the planned date and how long the entrance will be out of use.
Do you replace automatic door drive units in West Glamorgan?
Yes. We are the contracting party for drive unit replacements in West Glamorgan, and the survey and changeover are carried out by specialist engineers we manage. The survey is free and checks that the frame and leaves are worth keeping. You then receive a fixed, itemised quote for the new operator, sensors and any other parts the door needs.
What happens once the installation in West Glamorgan is finished?
The engineer tests every function, including the safety sensors and the behaviour on power loss, and sets the door up with reference to BS EN 16005. You are shown how to use the controls and which simple checks to make, and you receive the handover documents, including the test record and any conformity paperwork that applies to the work.
Will the building stay secure while the entrance is being changed?
We plan to keep the entrance usable or secure throughout. Where a door has to come out, the work is sequenced so the opening is closed up before the engineer leaves, or a temporary door or hoarding is arranged when a longer gap cannot be avoided. How this is handled for your site in West Glamorgan is agreed before work starts.
Who is responsible for automatic doors on escape routes in West Glamorgan?
The responsible person under the Regulatory Reform (Fire Safety) Order 2005. Automatic doors on an escape route need fail-safe opening or break-out, and sliding or revolving doors must not be used for exits specifically intended as emergency exits.