Coverage across Lincolnshire
Enquiries about drive unit replacement come to us from right across Lincolnshire, and each one is handled the same way. Specialist automatic door engineers working under our management travel to the address, and we remain your contracting party throughout. The 12 towns we list below are a starting point, not a boundary: villages, business parks and rural sites in between are covered as well.
Towns listed in Lincolnshire: Lincoln, Grimsby, Scunthorpe, Boston, Grantham, Cleethorpes, Spalding, Skegness, Stamford, Gainsborough, Louth, Sleaford.
What to think about for drive unit replacement in Lincolnshire
- Worn floor guides and rollers can shorten the life of a new operator. It is often worth replacing them during the same visit rather than coming back later.
- Check the power supply. A dedicated fused spur and isolator near the door is usually needed, and older installations sometimes need electrical work before the new operator goes in.
- If the door is on an escape route, the new drive unit must be set up to open, break out or be openable by hand, as the building's fire strategy requires.
- Busy retail entrances in Lincolnshire may prefer the changeover after closing time or on a quiet trading day. Tell us your hours when you book the survey.
- Listed buildings and conservation areas in Lincolnshire make it attractive to keep the existing frame. A new operator inside the existing header changes little that can be seen.
Drive unit replacement in Lincolnshire: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: typically £1,995 to £3,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| New drive unit on an existing automatic sliding door | £1,995 – £3,995 | existing leaves kept, installed, ex VAT |
| New operator on an existing automatic swing door | £1,795 – £3,995 | installed, ex VAT |
| Sensors replaced at the same time | £195 – £495 | per sensor, ex VAT |
Standards and rules in England
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Tell us about the entrance. Send the address, a few photos and a rough size of the opening, and say how the door is used. That is enough for us to suggest options for drive unit replacement and book a survey in Lincolnshire.
- Free site survey. A specialist engineer working under our management measures the opening, checks the frame, floor, head height and power, and talks through how people use the entrance. There is no charge and no obligation.
- Fixed written quote. You receive a fixed, itemised written quote with the specification, lead time, payment stages and warranty terms. The price does not change unless the scope does, and any change is agreed in writing first.
- Installation and handover. The door is fitted on the agreed dates, then set up, tested and documented with reference to BS EN 16005. You are shown the controls and the simple checks to make, and receive the handover paperwork.
Book a free survey in Lincolnshire to find out whether a new drive unit will bring your automatic door back to reliable use. The quote is fixed and itemised.
Drive unit replacement in Lincolnshire: questions
Can you fit a new operator to a door another company installed in Lincolnshire?
Yes. We replace drive units on doors whoever fitted them. The survey identifies the existing header, leaves and track, and adapter plates usually let a new drive unit from one of the major European operator brands fit without changing the frame.
How are prices worked out for drive unit replacement in Lincolnshire?
Our guide is £1,995 to £3,995 excluding VAT (per door), the same guide prices we use across the UK. The free site survey in Lincolnshire confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Will you remove the old operator from our premises in Lincolnshire?
Yes. The old drive unit, sensors and any other replaced parts are taken away as part of the job, and the work area is left clean. Disposal is included in the fixed quote, so there is nothing extra to arrange or pay for afterwards.
Do you provide paperwork for the converted door in Lincolnshire?
Yes. When we fit a new drive unit we prepare the paperwork for the finished door, including the risk assessment, Declaration of Conformity and user instructions, and hand it over with the test results and settings. It belongs with your building records.
How much disruption should we expect while the work is done in Lincolnshire?
Most installations take one visit or a short series of visits, with dust and noise kept to the area around the door. The engineer screens off the work area, keeps a route in or out where possible and clears up before leaving. Larger entrances, lobbies or structural changes take longer, and the quote explains how that work is phased.
Can installation in Lincolnshire happen outside opening hours?
Yes. Many shops, surgeries and offices prefer work early in the morning, in the evening or at weekends, when the entrance is quietest. Tell us your constraints when you enquire and they are built into the plan. Any extra cost for out-of-hours work is shown in the written quote rather than added afterwards.
Who is responsible for automatic doors on escape routes in Lincolnshire?
Under the Regulatory Reform (Fire Safety) Order 2005 the responsible person for the premises must make sure escape routes work and fire safety equipment is maintained. Automatic doors on an escape route need fail-safe opening or break-out, set by the fire strategy.