Coverage across Hampshire
Wherever you are in Hampshire, we need the same three things to get started on fire door hold-open devices: a short description of the door, a few photos if you have them, and the address. From there we agree the price in writing and book a specialist engineer working under our management. Every town listed below has a page of its own, 23 in total.
Towns listed in Hampshire: Southampton, Portsmouth, Basingstoke, Gosport, Waterlooville, Farnborough, Eastleigh, Winchester, Havant, Andover, Fareham, Aldershot, Fleet, Totton, Chandler's Ford, New Milton, Bordon, Hythe, Yateley, Alton, Emsworth, Hedge End, Romsey.
What to think about for fire door hold-open devices in Hampshire
- Schools and colleges in Hampshire may want hold-open devices fitted during the holidays so corridors are not disrupted in term time. Fitting can be planned around term dates.
- Residential blocks often have communal corridor doors that residents prop open. Hold-open devices give the same convenience while letting the doors close when the alarm sounds.
- Doors that open too far from a wall for a wall magnet can use a floor-mounted unit or a magnet on an extension arm. The survey measures where each door rests when open.
- Listed buildings and conservation areas can make new cable runs difficult. Radio-triggered battery units avoid most wiring, although the transmitter still needs a connection at the alarm panel.
- Hard-wired magnets need a power supply near each door. In buildings in Hampshire where that is awkward, battery units avoid running new cables along finished corridors.
Fire door hold-open devices in Hampshire: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £145 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Battery acoustic hold-open unit | £145 – £295 | per door, fitted, ex VAT |
| Hard-wired hold-open magnet linked to the fire alarm | £245 – £595 | per door, ex VAT; alarm panel work extra |
| Free-swing door closer linked to the fire alarm | £395 – £895 | per door, fitted, ex VAT |
Which hold-open device is suitable depends on your fire risk assessment. Linking to the fire alarm may need work by your alarm engineer.
Standards and rules in England
Fire doors that are held open must close automatically when the fire alarm operates. Where hold-open devices can be used is decided by the fire risk assessment, which is the job of the responsible person under the Regulatory Reform (Fire Safety) Order 2005.
Hold-open devices and door release units linked to the fire alarm need regular testing as part of the building’s fire safety checks, and the results should be recorded.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Send photos and the address. A few pictures of the door from both sides, the address in Hampshire and a note of who uses the entrance help us understand the job before anyone visits the site.
- No-cost survey on site. We arrange a survey at a time that suits the building. The engineer records measurements, fixings and power, plus any constraints such as listed status, opening hours or access for deliveries.
- Itemised quote to approve. We price every element of the work on fire door hold-open devices separately in a written quote that you can check, share and approve. Lead time and payment stages are stated, and nothing is ordered until you accept.
- Fit, test and hand over. On the agreed dates the engineer installs the equipment, commissions the operator and tests each safety function. You get a demonstration, the test record and any conformity paperwork that applies to the work.
Arrange your free hold-open device survey in Hampshire today and receive a written quote with a fixed price. Nothing is fitted until you have accepted it.
Fire door hold-open devices in Hampshire: questions
Are battery hold-open units a good choice for older buildings in Hampshire?
Often they are. Radio and acoustic battery units avoid long cable runs, which helps in older or listed buildings and finished corridors. Acoustic units are only suitable where the fire risk assessment allows them and the alarm can be heard clearly at the door. Batteries need replacing at the interval the maker states.
Is there a guide price for fire door hold-open devices in Hampshire?
Our guide starts from £145 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Hampshire confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Will you test the hold-open devices before leaving our site in Hampshire?
Yes. Every door is released from fully open and checked to close and latch. Where the alarm connection is complete, the doors are also tested with the alarm itself. You receive a schedule of the doors and devices fitted, ready to keep with your fire safety records and weekly alarm test log.
What will the survey in Hampshire look at?
The engineer checks that each door closes and latches from fully open, the condition of the closer and seals, where the door rests when open, nearby power supplies and the alarm panel or radio options. We also ask to see the relevant part of the fire risk assessment, so the quote covers only doors that can be held open.
Can automatic doors be fitted to a listed building in Hampshire?
Often, yes, but listed building consent is normally needed for changes that affect the character of the building, inside or out. Slim operators, concealed fixings and automating the existing door can all reduce the visual impact. Speak to the conservation officer at the local planning authority early; we can provide drawings and specifications to help.
What power supply is needed for fire door hold-open devices in Hampshire?
Most powered doors need a fused spur close to the operator, and some activation and access control devices also need a low-voltage link. The survey checks what is already there. If a new supply is required, the quote says whether we arrange it or your own electrician does, so nothing is left unclear on the day.
Which building regulations apply to a new automatic entrance in Hampshire?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.