Coverage across Tyne and Wear
There is no branch to visit in Tyne and Wear; instead, specialist engineers working under our management travel to you. That keeps automatic door refurbishment available across the whole area, including smaller towns and rural addresses. The page for each of the 12 towns we list below sets out nearby places, guide prices and the questions people usually ask.
Towns listed in Tyne and Wear: Newcastle upon Tyne, Sunderland, South Shields, Gateshead, Washington, Tynemouth, Wallsend, North Shields, Whitley Bay, Houghton-le-Spring, Jarrow, Hebburn.
What to think about for automatic door refurbishment in Tyne and Wear
- Older shopfronts with discontinued door systems may need equivalent parts rather than exact matches. The survey identifies what is still available before anything is ordered.
- Busy retail units in Tyne and Wear may prefer the work done in stages, one leaf at a time, so the entrance stays open throughout trading hours.
- High street doors in Tyne and Wear often have scratched or etched glass from years of cleaning and graffiti. Replacing leaves with new safety glass restores a clean look.
- If the operator is close to the end of its life, refurbishing the running gear while fitting a new drive unit saves a second visit and a second set-up.
- Frames near the coast or busy roads can corrode faster. The survey checks fixings and the bottom of the frame, where water and grit tend to collect.
Automatic door refurbishment in Tyne and Wear: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £395 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Running gear refresh: rollers, guides, brushes and seals | £395 – £895 | per door, ex VAT |
| Track overhaul | £395 – £895 | per door, ex VAT |
| Replacement glass leaf | from £495 | each, ex VAT; size and glass type on survey |
| Full refurbishment of a sliding door | £1,495 – £2,995 | running gear, seals, guides and one leaf, ex VAT |
Standards and rules in England
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in Tyne and Wear.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Book a free refurbishment survey in Tyne and Wear. We will check the frame, leaves and running gear, then price each item separately on a fixed quote.
Automatic door refurbishment in Tyne and Wear: questions
Will our entrance in Tyne and Wear stay open during refurbishment?
Often, at least in part. Many jobs can be done one leaf at a time, and the work can be planned for quieter hours. If the entrance does need to close, the quote says for how long, so you can arrange another way in for staff and visitors.
How much should I budget for automatic door refurbishment in Tyne and Wear?
Our guide starts from £395 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Tyne and Wear confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Do you refurbish automatic doors in Tyne and Wear?
Yes. Refurbishment work in Tyne and Wear is planned and priced by us, then carried out by automatic door engineers and glaziers working under our management. There is no charge for the survey, and you receive a fixed quote with each item priced separately, from new glass and rollers to seals, floor guides, the threshold and frame refinishing.
Is it worth refurbishing an old door at our premises in Tyne and Wear?
If the frame is sound and the opening size still works, usually yes, as refurbishment costs far less than a new door. If the frame is corroded, the glass is not safety glass or the opening is too narrow, a new door may be better value, and the survey tells you which.
Do I need permission from a landlord or the council before work in Tyne and Wear?
It depends on the building. Tenants usually need the landlord's written consent before changing an entrance, and some changes to a shopfront or external door need planning permission. The survey notes anything that may need consent. We can supply drawings and product details to support an application, but the owner or tenant makes it.
Is there a warranty on automatic door refurbishment?
Yes. The warranty terms for the equipment and the installation are set out in your written quote, so you can see exactly what is covered before you accept. Keeping the door serviced at the recommended intervals helps keep it in good order, and the quote explains any conditions that apply to the warranty.
Do businesses in Tyne and Wear have to fit automatic doors?
No law says every building must have automatic doors. Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, and building regulations guidance in England calls for a powered door where an entrance door would otherwise be too heavy to open. An automatic door is often the simplest way to meet both.