Coverage across Gloucestershire
Here is how coverage works in Gloucestershire. You contact us with the address and what the door needs, we confirm the price in writing, and a specialist engineer working under our management attends on an agreed date. That applies to automatic door refurbishment at a single shop door or across a whole estate of buildings, in any of the towns below or between them.
Towns listed in Gloucestershire: Gloucester, Cheltenham, Stroud, Kingswood, Yate, Tewkesbury, Cirencester.
What to think about for automatic door refurbishment in Gloucestershire
- After refurbishment, sensors and speeds are reset to suit the new parts. Keep the test record with your service history so later engineers can see what was done.
- Exposed entrances in Gloucestershire suffer most from worn seals and brush strips. New weatherproofing can cut draughts and noise noticeably, especially on doors facing the prevailing wind.
- Care settings in Gloucestershire benefit from level thresholds and smooth-running leaves that do not snag walking frames, trolleys or wheelchair footplates as people pass through.
- Frames near the coast or busy roads can corrode faster. The survey checks fixings and the bottom of the frame, where water and grit tend to collect.
- High street doors in Gloucestershire often have scratched or etched glass from years of cleaning and graffiti. Replacing leaves with new safety glass restores a clean look.
Automatic door refurbishment in Gloucestershire: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £395 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Running gear refresh: rollers, guides, brushes and seals | £395 – £895 | per door, ex VAT |
| Track overhaul | £395 – £895 | per door, ex VAT |
| Replacement glass leaf | from £495 | each, ex VAT; size and glass type on survey |
| Full refurbishment of a sliding door | £1,495 – £2,995 | running gear, seals, guides and one leaf, ex VAT |
Standards and rules in England
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in Gloucestershire.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Get in touch about automatic door refurbishment in Gloucestershire. The work can be planned in stages to keep your entrance open while it is done.
Automatic door refurbishment in Gloucestershire: questions
Do you refurbish automatic doors in Gloucestershire?
Yes. Refurbishment work in Gloucestershire is planned and priced by us, then carried out by automatic door engineers and glaziers working under our management. There is no charge for the survey, and you receive a fixed quote with each item priced separately, from new glass and rollers to seals, floor guides, the threshold and frame refinishing.
What will automatic door refurbishment in Gloucestershire cost?
Our guide starts from £395 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Gloucestershire confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Do you set up the door again after refurbishing it in Gloucestershire?
Yes. New running parts change how the leaves move, so speeds, sensor zones and obstacle detection are checked and reset before handover. You receive a record of the parts fitted and the test results to keep with the door's service history.
Will our entrance in Gloucestershire stay open during refurbishment?
Often, at least in part. Many jobs can be done one leaf at a time, and the work can be planned for quieter hours. If the entrance does need to close, the quote says for how long, so you can arrange another way in for staff and visitors.
What should I send before the survey in Gloucestershire?
A few photos of the door from inside and outside, rough measurements of the opening, the address and a note of how the entrance is used. If the door already has an operator, a photo of any label on it helps. With that, the engineer arrives prepared, the survey takes less of your time and we can put the quote for automatic door refurbishment together more easily.
What does the written quote for automatic door refurbishment in Gloucestershire include?
The quote lists each item separately: the door or equipment, installation, electrical connections where we provide them, removal of anything being replaced, testing and handover. It is a fixed price for the work described, so it does not change unless the scope changes, and any change is agreed with you in writing first.
Which building regulations apply to a new automatic entrance in Gloucestershire?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.