Coverage across Cornwall
Coverage for automatic door refurbishment extends across all of Cornwall, including addresses some distance from the towns listed below. We are the contracting party, the engineers work under our management, and the price is agreed in writing first. If your town is not among the 8 we list, contact us anyway; the process and guide prices do not change.
Towns listed in Cornwall: Redruth, Falmouth, St Austell, Truro, Camborne, Newquay, Penzance, Hugh Town.
What to think about for automatic door refurbishment in Cornwall
- Frames near the coast or busy roads can corrode faster. The survey checks fixings and the bottom of the frame, where water and grit tend to collect.
- Floors around the door in Cornwall may be worn or uneven. New floor guides and thresholds sometimes need small areas of making good, which the quote lists separately.
- After refurbishment, sensors and speeds are reset to suit the new parts. Keep the test record with your service history so later engineers can see what was done.
- Exposed entrances in Cornwall suffer most from worn seals and brush strips. New weatherproofing can cut draughts and noise noticeably, especially on doors facing the prevailing wind.
- Busy retail units in Cornwall may prefer the work done in stages, one leaf at a time, so the entrance stays open throughout trading hours.
Automatic door refurbishment in Cornwall: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £395 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Running gear refresh: rollers, guides, brushes and seals | £395 – £895 | per door, ex VAT |
| Track overhaul | £395 – £895 | per door, ex VAT |
| Replacement glass leaf | from £495 | each, ex VAT; size and glass type on survey |
| Full refurbishment of a sliding door | £1,495 – £2,995 | running gear, seals, guides and one leaf, ex VAT |
Standards and rules in England
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Tell us about the entrance. Send the address, a few photos and a rough size of the opening, and say how the door is used. That is enough for us to suggest options for automatic door refurbishment and book a survey in Cornwall.
- Free site survey. A specialist engineer working under our management measures the opening, checks the frame, floor, head height and power, and talks through how people use the entrance. There is no charge and no obligation.
- Fixed written quote. You receive a fixed, itemised written quote with the specification, lead time, payment stages and warranty terms. The price does not change unless the scope does, and any change is agreed in writing first.
- Installation and handover. The door is fitted on the agreed dates, then set up, tested and documented with reference to BS EN 16005. You are shown the controls and the simple checks to make, and receive the handover paperwork.
Send us photos of the door that needs attention in Cornwall, and we will arrange a survey at no cost and an itemised quote for the work.
Automatic door refurbishment in Cornwall: questions
Can you replace a single broken glass leaf in Cornwall?
Yes. The leaf is made safe, measured and reglazed with new safety glass, or replaced completely if its frame is damaged. New glass is typically 2 to 4 weeks from order. Once the leaf is rehung, the door is set up again and the track and floor guide are checked.
What will automatic door refurbishment in Cornwall cost?
Our guide starts from £395 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Cornwall confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Do you refurbish automatic doors in Cornwall?
Yes. Refurbishment work in Cornwall is planned and priced by us, then carried out by automatic door engineers and glaziers working under our management. There is no charge for the survey, and you receive a fixed quote with each item priced separately, from new glass and rollers to seals, floor guides, the threshold and frame refinishing.
Will our entrance in Cornwall stay open during refurbishment?
Often, at least in part. Many jobs can be done one leaf at a time, and the work can be planned for quieter hours. If the entrance does need to close, the quote says for how long, so you can arrange another way in for staff and visitors.
What power supply is needed for automatic door refurbishment in Cornwall?
Most powered doors need a fused spur close to the operator, and some activation and access control devices also need a low-voltage link. The survey checks what is already there. If a new supply is required, the quote says whether we arrange it or your own electrician does, so nothing is left unclear on the day.
Can automatic doors be fitted to a listed building in Cornwall?
Often, yes, but listed building consent is normally needed for changes that affect the character of the building, inside or out. Slim operators, concealed fixings and automating the existing door can all reduce the visual impact. Speak to the conservation officer at the local planning authority early; we can provide drawings and specifications to help.
Who is responsible for automatic doors on escape routes in Cornwall?
Under the Regulatory Reform (Fire Safety) Order 2005 the responsible person for the premises must make sure escape routes work and fire safety equipment is maintained. Automatic doors on an escape route need fail-safe opening or break-out, set by the fire strategy.