Covering Wellington and nearby
For telescopic sliding doors, coverage around Wellington is set by postcode and includes the TF1 postcode district, as well as nearby addresses in Shropshire. Specialist engineers working under our management attend each site, and the price is agreed in writing beforehand.
Small offices, community centres and village halls around Wellington tend to have one main entrance, often used by visitors who need level access without steps. Automating the existing door, rather than replacing it, is frequently the most practical and affordable route.
Nearby towns we also list for telescopic sliding doors (straight-line distance): Telford (3.3 miles), Shrewsbury (9.9 miles), Stafford (18.3 miles), Wolverhampton (18.3 miles), Wednesfield (19.5 miles), Sedgley (19.8 miles).
What to think about for telescopic sliding doors in Wellington
- A telescopic header is deeper than a standard one. In older buildings in Wellington with low ceilings or decorative fanlights, the survey checks whether the header can sit above the opening or needs to be recessed.
- Care homes and supported living buildings in Wellington may want the main door to open freely for visitors but stay locked for some residents. A keypad or fob reader on the inside can be wired to the operator.
- If the entrance is on an escape route, ask your fire risk assessor what the door must do before ordering. Break-out telescopic leaves have to be chosen at the start, because they cannot be added afterwards.
- Measure the widest thing that has to pass through, whether that is a hospital bed, a mobility scooter or a cage of stock. The clear opening of a telescopic door is chosen from that figure, not from the size of the old doorway.
- Hospital and supermarket entrances in Wellington that run for long hours put more wear on the extra rollers and belts of a telescopic door. Plan a servicing arrangement from the start rather than waiting for the first fault.
Telescopic sliding doors in Wellington: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £6,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Telescopic single-slide, two leaves | £6,995 – £9,995 | installed, ex VAT |
| Telescopic bi-parting, four leaves | £8,995 – £13,995 | installed, ex VAT |
| Very wide or full-height openings | Priced on survey | measured and designed at the survey |
| Touch-free switch or push pad, fitted | £145 – £395 | per switch, ex VAT |
| Card or fob reader tied into the door | £795 – £2,495 | per door, ex VAT |
Standards and rules in England
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking. Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in Wellington.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Ready to widen the way in at your building in Wellington? Arrange a free survey and receive a fixed written quote with no obligation attached.
Telescopic sliding doors in Wellington: questions
Can our existing sliding door in Wellington be converted to telescopic?
Not usually by modifying the old door, because the header, tracks and leaves are different. It is normally replaced as a complete set within the same opening. The survey checks whether the existing structure and floor can take the new door, and the quote shows removal of the old one as a separate line.
How are prices worked out for telescopic sliding doors in Wellington?
Our guide starts from £6,995 excluding VAT (per door set), the same guide price we use across the UK. The free site survey in Wellington confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Can you fit telescopic sliding doors in Wellington?
Yes. We arrange supply and installation in Wellington and the rest of Shropshire. Specialist automatic door engineers working under our management carry out the survey and the fitting, and we stay the contracting party throughout, so one company is responsible for the drawing, the quote, the installation and the handover paperwork.
Can you look after the door in Wellington once it is installed?
Yes. We can quote planned servicing for the new door, with each visit priced in writing beforehand and the interval set by how heavily the door is used and the manufacturer's instructions. Busy entrances such as hospitals and supermarkets are usually serviced more often than quieter offices.
Can automatic doors be fitted to a listed building in Wellington?
Often, yes, but listed building consent is normally needed for changes that affect the character of the building, inside or out. Slim operators, concealed fixings and automating the existing door can all reduce the visual impact. Speak to the conservation officer at the local planning authority early; we can provide drawings and specifications to help.
What happens once the installation in Wellington is finished?
The engineer tests every function, including the safety sensors and the behaviour on power loss, and sets the door up with reference to BS EN 16005. You are shown how to use the controls and which simple checks to make, and you receive the handover documents, including the test record and any conformity paperwork that applies to the work.
Who is responsible for automatic doors on escape routes in Wellington?
Under the Regulatory Reform (Fire Safety) Order 2005 the responsible person for the premises must make sure escape routes work and fire safety equipment is maintained. Automatic doors on an escape route need fail-safe opening or break-out, set by the fire strategy.