Coverage across Warwickshire
Our coverage of Warwickshire is not tied to a depot or a showroom. Engineers who carry out sensor upgrades and replacement for us travel to each site, so a farm shop down a country lane goes through the same process as a city-centre office. Every job is priced in writing before work starts, and the town list below currently numbers 7.
Towns listed in Warwickshire: Nuneaton, Rugby, Leamington Spa, Warwick, Bedworth, Stratford-upon-Avon, Kenilworth.
What to think about for sensor upgrades and replacement in Warwickshire
- Care settings in Warwickshire often need longer hold-open times and wider safety zones for residents who move slowly, use walking frames or pause in the doorway.
- Shopping parades and older shopfronts in Warwickshire sometimes have low transoms or canopies that limit where a sensor can be mounted. The engineer checks height and angle first.
- Rain, snow and blowing leaves can trigger radar sensors over exposed doors. Some sensors filter weather better than others, which the engineer weighs up when choosing a replacement.
- Entrances facing busy roads in Warwickshire can see false openings from passing vehicles and cyclists. A sensor with direction detection and a tighter zone usually helps.
- Sensor changes on escape route doors must never stop the door opening when it needs to. The engineer checks the door's escape mode after any sensor work.
Sensor upgrades and replacement in Warwickshire: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: typically £195 to £495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Add or replace a safety or activation sensor | £195 – £495 | per sensor fitted, ex VAT |
| Touch-free switch or push pad | £145 – £395 | per switch, ex VAT |
| Side-screen or light-curtain protection | from £295 | per door, ex VAT; on survey |
Sensor prices cover the part, fitting and set-up. If a sensor is fitted on a visit of its own, the visit charge (from £95 ex VAT) is added, and we confirm the total in writing before an engineer attends. Each sensor is set up for the door and tested before the engineer leaves.
Standards and rules in England
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
How it works
- Make contact. Phone, email or use the form. Tell us the type of door, what it is doing and whether it is safe to use, so the right visit for sensor upgrades and replacement can be planned.
- Written visit price. The cost of attending is agreed in writing before the visit is booked. For a planned service or inspection, the price per door and what each visit includes are set out at the same time.
- On-site work. The engineer, working under our management, checks the door from end to end, deals with the fault or the service, and tests every safety function and sensor setting before signing the door off.
- Report and quote. You receive a report of the findings. Where a repair, part or upgrade is recommended, it is quoted in writing so you can decide, and the door is left in a safe state if it cannot be used.
Ask for a price on new safety or activation sensors in Warwickshire. Each one is set up for the door's hazard zones and tested before the engineer leaves.
Sensor upgrades and replacement in Warwickshire: questions
Will you record the sensor settings for our building in Warwickshire?
Yes. The job report lists each sensor fitted, its position, the settings used and the test results. Keep it with your service records, as it helps future engineers and shows the door's safety set-up was checked after the work. The same details are useful if an insurer or inspector asks.
What do you charge for sensor upgrades and replacement in Warwickshire?
Our guide is £195 to £495 excluding VAT (per sensor fitted), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in Warwickshire, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Do engineers carry sensors for doors in Warwickshire?
Engineers carry common combined and safety sensors, so many replacements can be fitted at the first visit. Light curtains and specialist sensors are ordered once the door is identified, with delivery typically 1 to 2 weeks. Photos in advance help us bring the right part first time.
Do you replace automatic door sensors in Warwickshire?
Yes. Sensor replacement and upgrades in Warwickshire are booked and managed by us and carried out by engineers who specialise in automatic doors. They work on sensors for sliding, swing, folding and revolving doors from most makers. The visit cost is set in writing before they attend, and each new sensor is tested before they leave.
How is the visit price set for work in Warwickshire?
We agree the visit price with you in writing before an engineer attends. It is based on the type of door, the work requested and the location. If parts or further work are needed once the engineer has found the cause, those are quoted before they are done, so the cost never moves without your agreement.
What should I tell you when reporting a fault in Warwickshire?
The address, the type of door, what it is doing or not doing, when the problem started and whether it is safe to use. A photo of the operator label showing the make, and a short video of the fault, help a great deal. With that, we can agree the visit price in writing and send an engineer with the right parts where possible.
Which building regulations apply to a new automatic entrance in Warwickshire?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.