Covering Epsom and nearby
We do not keep premises in Epsom. Instead, enquiries about sensor upgrades and replacement come to us, we agree the price in writing, and a specialist engineer working under our management travels to the address in the KT18 and KT19 postcode districts on a date that suits the site.
Small offices, community centres and village halls around Epsom tend to have one main entrance, often used by visitors who need level access without steps. Automating the existing door, rather than replacing it, is frequently the most practical and affordable route.
Nearby towns we also list for sensor upgrades and replacement (straight-line distance): Ewell (1.6 miles), Sutton (3.3 miles), Leatherhead (3.6 miles), Surbiton (4.4 miles), Carshalton (5.1 miles), Morden (5.6 miles).
What to think about for sensor upgrades and replacement in Epsom
- Corridor doors that people walk past rather than through may work better on a touch-free switch than a motion sensor, cutting needless openings and heat loss.
- After a near miss at a door in Epsom, keep a note of what happened and where the person was standing. It helps the engineer judge which zone the sensor failed to cover.
- Shopping parades and older shopfronts in Epsom sometimes have low transoms or canopies that limit where a sensor can be mounted. The engineer checks height and angle first.
- Entrances facing busy roads in Epsom can see false openings from passing vehicles and cyclists. A sensor with direction detection and a tighter zone usually helps.
- Rain, snow and blowing leaves can trigger radar sensors over exposed doors. Some sensors filter weather better than others, which the engineer weighs up when choosing a replacement.
Sensor upgrades and replacement in Epsom: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: typically £195 to £495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Add or replace a safety or activation sensor | £195 – £495 | per sensor fitted, ex VAT |
| Touch-free switch or push pad | £145 – £395 | per switch, ex VAT |
| Side-screen or light-curtain protection | from £295 | per door, ex VAT; on survey |
Sensor prices cover the part, fitting and set-up. If a sensor is fitted on a visit of its own, the visit charge (from £95 ex VAT) is added, and we confirm the total in writing before an engineer attends. Each sensor is set up for the door and tested before the engineer leaves.
Standards and rules in England
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
How it works
- Make contact. Phone, email or use the form. Tell us the type of door, what it is doing and whether it is safe to use, so the right visit for sensor upgrades and replacement can be planned.
- Written visit price. The cost of attending is agreed in writing before the visit is booked. For a planned service or inspection, the price per door and what each visit includes are set out at the same time.
- On-site work. The engineer, working under our management, checks the door from end to end, deals with the fault or the service, and tests every safety function and sensor setting before signing the door off.
- Report and quote. You receive a report of the findings. Where a repair, part or upgrade is recommended, it is quoted in writing so you can decide, and the door is left in a safe state if it cannot be used.
Get your door detecting people properly again. Contact us about sensor replacement in Epsom, with the visit cost confirmed before anyone attends.
Sensor upgrades and replacement in Epsom: questions
Can you price new sensors for my door in Epsom from photos?
Often, yes. Photos of the sensor, the door from both sides and the label on the operator cover usually tell us which sensor is needed and whether it suits the controller. We can then quote the sensor and fitting in advance, with the visit price confirmed before anyone travels.
What do you charge for sensor upgrades and replacement in Epsom?
Our guide is £195 to £495 excluding VAT (per sensor fitted), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in Epsom, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Will new sensors stop false openings at our entrance in Epsom?
Usually. Modern sensors can ignore cross traffic and detect only people moving towards the door, and the zone can be narrowed. If the entrance faces a busy street or catches heavy weather, the engineer may suggest a sensor that filters those conditions better.
Can a risk assessment in Epsom tell us which sensors we need?
Yes. A safety inspection tests each hazard zone and records where sensor coverage is missing or poor. The report then lists the sensors or light curtains needed, and we can quote those items exactly as listed, or you can pass the report to another competent installer.
Can you take over servicing of doors in Epsom from another company?
Yes. Send us the door details and, if you have them, previous service records or inspection reports. The first visit gives a baseline for each door, and its price is agreed in writing beforehand. From then on, records continue in one consistent format, whichever company looked after the doors before.
How often should automatic doors in Epsom be serviced?
No law sets a fixed interval. We recommend a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer's instructions and how heavily the door is used; busy doors are often serviced more often. Site staff should also carry out simple regular checks and keep a record of them.
Which building regulations apply to a new automatic entrance in Epsom?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.