Covering Leatherhead and nearby
Our coverage of Leatherhead takes in the KT22 postcode district and the neighbouring parts of Surrey. If your address sits close to a boundary, it is still covered: send the postcode with your enquiry about sensor upgrades and replacement and we will confirm the arrangements and the price in writing.
Many buildings in Leatherhead are older, with timber frames, thick walls, steps or uneven thresholds. These affect where an operator and sensors can go, and the engineer checks them on site before anything is fitted or adjusted.
Nearby towns we also list for sensor upgrades and replacement (straight-line distance): Epsom (3.6 miles), Dorking (4.4 miles), Ewell (5.2 miles), Surbiton (6.7 miles), Sutton (6.9 miles), Reigate (6.9 miles).
What to think about for sensor upgrades and replacement in Leatherhead
- Care settings in Leatherhead often need longer hold-open times and wider safety zones for residents who move slowly, use walking frames or pause in the doorway.
- Swing doors in narrow corridors need sensors on the leaf to protect people on both sides. The engineer checks the swing path and any walls or fittings close by.
- Corridor doors that people walk past rather than through may work better on a touch-free switch than a motion sensor, cutting needless openings and heat loss.
- Entrances facing busy roads in Leatherhead can see false openings from passing vehicles and cyclists. A sensor with direction detection and a tighter zone usually helps.
- Sites in Leatherhead that open early or close late may want sensor work done outside trading hours. Tell us the quieter times when you book the visit.
Sensor upgrades and replacement in Leatherhead: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: typically £195 to £495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Add or replace a safety or activation sensor | £195 – £495 | per sensor fitted, ex VAT |
| Touch-free switch or push pad | £145 – £395 | per switch, ex VAT |
| Side-screen or light-curtain protection | from £295 | per door, ex VAT; on survey |
Sensor prices cover the part, fitting and set-up. If a sensor is fitted on a visit of its own, the visit charge (from £95 ex VAT) is added, and we confirm the total in writing before an engineer attends. Each sensor is set up for the door and tested before the engineer leaves.
Standards and rules in England
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
How it works
- Tell us what is happening. Describe the fault, or the service or inspection that is due, and send photos of the door and any label on the operator. Include the address in Leatherhead and how much the site depends on the door.
- Visit price agreed in writing. We confirm the price of the visit in writing before an engineer attends. If the door can be priced from photos and its make and model, we say so at this stage.
- Engineer visit. A specialist engineer working under our management diagnoses the fault or carries out the service, then tests the operation of the door and its safety sensors before leaving the site.
- Findings and follow-up. You receive a written record of what was found and done. Any parts or further work needed are quoted in writing before they go ahead, and nothing is added without your agreement.
For doors that open for passers-by or close too soon in Leatherhead, talk to us about new sensors and detection zones set for your entrance.
Sensor upgrades and replacement in Leatherhead: questions
Our door in Leatherhead closes on people. Is that a sensor fault?
It is likely, and the door should be treated as unsafe. Switch it to a safe mode, such as manual or open, and keep people away from the leaves. Tell us it is unsafe and we will give you the earliest visit we can offer, then the engineer will check the safety sensors and their zones.
Can you give me a price for sensor upgrades and replacement in Leatherhead?
Our guide is £195 to £495 excluding VAT (per sensor fitted), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in Leatherhead, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Will you record the sensor settings for our building in Leatherhead?
Yes. The job report lists each sensor fitted, its position, the settings used and the test results. Keep it with your service records, as it helps future engineers and shows the door's safety set-up was checked after the work. The same details are useful if an insurer or inspector asks.
Will new sensors stop false openings at our entrance in Leatherhead?
Usually. Modern sensors can ignore cross traffic and detect only people moving towards the door, and the zone can be narrowed. If the entrance faces a busy street or catches heavy weather, the engineer may suggest a sensor that filters those conditions better.
Are parts quoted before they are fitted?
Always. If a repair or service in Leatherhead needs parts, such as rollers, belts, sensors, a control board or a motor, we quote them in writing first. Some common parts may be on the engineer's van; others are ordered once you accept the quote and fitted on a return visit at a price already agreed.
How is the visit price set for work in Leatherhead?
We agree the visit price with you in writing before an engineer attends. It is based on the type of door, the work requested and the location. If parts or further work are needed once the engineer has found the cause, those are quoted before they are done, so the cost never moves without your agreement.
Which building regulations apply to a new automatic entrance in Leatherhead?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.