Coverage across the Isle of Wight
Here is how coverage works on the Isle of Wight. You contact us with the address and what the door needs, we confirm the price in writing, and a specialist engineer working under our management attends on an agreed date. That applies to sensor upgrades and replacement at a single shop door or across a whole estate of buildings, in any of the towns below or between them.
Towns listed on the Isle of Wight: Newport, Ryde, Cowes, Sandown.
What to think about for sensor upgrades and replacement on the Isle of Wight
- Doors with side screens may need a light curtain on the leaf edge or post to protect the gap. This is one of the most common upgrades on older sliding doors.
- Care settings on the Isle of Wight often need longer hold-open times and wider safety zones for residents who move slowly, use walking frames or pause in the doorway.
- Shopping parades and older shopfronts on the Isle of Wight sometimes have low transoms or canopies that limit where a sensor can be mounted. The engineer checks height and angle first.
- Corridor doors that people walk past rather than through may work better on a touch-free switch than a motion sensor, cutting needless openings and heat loss.
- Entrances facing busy roads on the Isle of Wight can see false openings from passing vehicles and cyclists. A sensor with direction detection and a tighter zone usually helps.
Sensor upgrades and replacement on the Isle of Wight: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. For island addresses, travel is included in the agreed visit price. Guide price: typically £195 to £495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Add or replace a safety or activation sensor | £195 – £495 | per sensor fitted, ex VAT |
| Touch-free switch or push pad | £145 – £395 | per switch, ex VAT |
| Side-screen or light-curtain protection | from £295 | per door, ex VAT; on survey |
Sensor prices cover the part, fitting and set-up. If a sensor is fitted on a visit of its own, the visit charge (from £95 ex VAT) is added, and we confirm the total in writing before an engineer attends. Each sensor is set up for the door and tested before the engineer leaves.
Standards and rules in England
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
How it works
- Explain the problem. Whether the door is stuck, slow, noisy or due its next check, a short description and a few photos tell us which kind of visit to book for sensor upgrades and replacement and what to bring.
- Visit cost agreed. You get the visit price in writing before we book the engineer. There are no hidden extras: parts and further work are always quoted separately and in advance.
- Engineer on site. The engineer inspects the operator, sensors, tracks and leaves, carries out the repair or service, and runs the door through its safety tests before it goes back into use.
- Follow-up quoted. You are sent a record of the visit. If something else needs attention, we quote it in writing; for doors on a service plan, the next visit date is noted on the record.
Has a risk assessment on the Isle of Wight listed sensor upgrades? Send us the report and we will quote each item before any work is done.
Sensor upgrades and replacement on the Isle of Wight: questions
Do you replace automatic door sensors on the Isle of Wight?
Yes. Sensor replacement and upgrades on the Isle of Wight are booked and managed by us and carried out by engineers who specialise in automatic doors. They work on sensors for sliding, swing, folding and revolving doors from most makers. The visit cost is set in writing before they attend, and each new sensor is tested before they leave.
How are prices worked out for sensor upgrades and replacement on the Isle of Wight?
Our guide is £195 to £495 excluding VAT (per sensor fitted), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends on the Isle of Wight, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Our door on the Isle of Wight closes on people. Is that a sensor fault?
It is likely, and the door should be treated as unsafe. Switch it to a safe mode, such as manual or open, and keep people away from the leaves. Tell us it is unsafe and we will give you the earliest visit we can offer, then the engineer will check the safety sensors and their zones.
Do engineers carry sensors for doors on the Isle of Wight?
Engineers carry common combined and safety sensors, so many replacements can be fitted at the first visit. Light curtains and specialist sensors are ordered once the door is identified, with delivery typically 1 to 2 weeks. Photos in advance help us bring the right part first time.
Can you price a repair on the Isle of Wight from photos?
Sometimes. Clear photos of the door, the operator cover and any label showing the make and model, plus a description of what the door is doing, can let us price a likely repair before a visit. Where the cause is not obvious, we agree a diagnostic visit price in writing first and quote the repair afterwards.
What if a door on the Isle of Wight is found to be unsafe?
The engineer explains the problem and, where needed, leaves the door in a safe state, for example switched off or set so it cannot trap or strike anyone. You receive a written note of the issue. The repair or upgrade that would put it right is quoted before any further work is carried out.
Do businesses on the Isle of Wight have to fit automatic doors?
No law says every building must have automatic doors. Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, and building regulations guidance in England calls for a powered door where an entrance door would otherwise be too heavy to open. An automatic door is often the simplest way to meet both.