Covering Newcastle upon Tyne and nearby
Coverage for drive unit replacement runs across the NE1, NE2, NE3, NE4, NE6 and NE7 postcode districts and out into the surrounding parts of Tyne and Wear. Wherever the building is, the arrangements stay the same: one contracting party, a written price before work, and a specialist engineer working under our management on site.
Universities, colleges and city hotels see sharp peaks of traffic at changeover times and check-in hours. For entrances like these in Newcastle upon Tyne, opening width, hold-open time and sensor range are set so the door copes with crowds without wasting heat.
Nearby towns we also list for drive unit replacement (straight-line distance): Gateshead (0.9 miles), Wallsend (3.4 miles), Hebburn (3.9 miles), Jarrow (5.2 miles), Washington (6.4 miles), North Shields (7.2 miles).
What to think about for drive unit replacement in Newcastle upon Tyne
- Hospitals and care homes in Newcastle upon Tyne may need an alternative entrance during the changeover. Plan signs and step-free access for wheelchair users before work starts.
- Listed buildings and conservation areas in Newcastle upon Tyne make it attractive to keep the existing frame. A new operator inside the existing header changes little that can be seen.
- If the door is on an escape route, the new drive unit must be set up to open, break out or be openable by hand, as the building's fire strategy requires.
- Check the power supply. A dedicated fused spur and isolator near the door is usually needed, and older installations sometimes need electrical work before the new operator goes in.
- Busy retail entrances in Newcastle upon Tyne may prefer the changeover after closing time or on a quiet trading day. Tell us your hours when you book the survey.
Drive unit replacement in Newcastle upon Tyne: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: typically £1,995 to £3,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| New drive unit on an existing automatic sliding door | £1,995 – £3,995 | existing leaves kept, installed, ex VAT |
| New operator on an existing automatic swing door | £1,795 – £3,995 | installed, ex VAT |
| Sensors replaced at the same time | £195 – £495 | per sensor, ex VAT |
Standards and rules in England
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Tell us about the entrance. Send the address, a few photos and a rough size of the opening, and say how the door is used. That is enough for us to suggest options for drive unit replacement and book a survey in Newcastle upon Tyne.
- Free site survey. A specialist engineer working under our management measures the opening, checks the frame, floor, head height and power, and talks through how people use the entrance. There is no charge and no obligation.
- Fixed written quote. You receive a fixed, itemised written quote with the specification, lead time, payment stages and warranty terms. The price does not change unless the scope does, and any change is agreed in writing first.
- Installation and handover. The door is fitted on the agreed dates, then set up, tested and documented with reference to BS EN 16005. You are shown the controls and the simple checks to make, and receive the handover paperwork.
Tired of repeat breakdowns at your entrance in Newcastle upon Tyne? Ask us to compare a new operator with a new door, so you can choose with both prices in front of you.
Drive unit replacement in Newcastle upon Tyne: questions
Will you remove the old operator from our premises in Newcastle upon Tyne?
Yes. The old drive unit, sensors and any other replaced parts are taken away as part of the job, and the work area is left clean. Disposal is included in the fixed quote, so there is nothing extra to arrange or pay for afterwards.
What do you charge for drive unit replacement in Newcastle upon Tyne?
Our guide is £1,995 to £3,995 excluding VAT (per door), the same guide prices we use across the UK. The free site survey in Newcastle upon Tyne confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Can the replacement in Newcastle upon Tyne include a service plan?
It can. After the changeover we recommend a service interval based on how heavily the door is used, and a service contract can be set up with a written record of each visit. Servicing is priced separately and agreed in writing before any visit takes place.
Do you provide paperwork for the converted door in Newcastle upon Tyne?
Yes. When we fit a new drive unit we prepare the paperwork for the finished door, including the risk assessment, Declaration of Conformity and user instructions, and hand it over with the test results and settings. It belongs with your building records.
What happens once the installation in Newcastle upon Tyne is finished?
The engineer tests every function, including the safety sensors and the behaviour on power loss, and sets the door up with reference to BS EN 16005. You are shown how to use the controls and which simple checks to make, and you receive the handover documents, including the test record and any conformity paperwork that applies to the work.
Will the building stay secure while the entrance is being changed?
We plan to keep the entrance usable or secure throughout. Where a door has to come out, the work is sequenced so the opening is closed up before the engineer leaves, or a temporary door or hoarding is arranged when a longer gap cannot be avoided. How this is handled for your site in Newcastle upon Tyne is agreed before work starts.
Which building regulations apply to a new automatic entrance in Newcastle upon Tyne?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.