UK-wide · Free site survey and fixed written quote for new doors · Repair and service visits priced before we attend

Call 0800 088 6248

Automatic Door Installers

Fire door hold-open devices · Scotland

Fire door hold-open devices in Perth and Kinross

Specialist engineers working under our management fit hold-open devices for property managers, care providers and businesses in Perth and Kinross. They look at the door, the closer and the fire alarm first, and the fixed price includes any repair needed to make a door close properly.

Area
Perth and Kinross
Nation
Scotland
Towns listed
3
Guide price
From £145 ex VAT
  • Free site survey for new doors
  • Fixed, itemised written quote
  • Set up with reference to BS EN 16005
  • England, Wales, Scotland and NI
  • Guide prices published

Coverage across Perth and Kinross

There is no branch to visit in Perth and Kinross; instead, specialist engineers working under our management travel to you. That keeps fire door hold-open devices available across the whole area, including smaller towns and rural addresses. The page for each of the 3 towns we list below sets out nearby places, guide prices and the questions people usually ask.

Towns listed in Perth and Kinross: Perth, Blairgowrie, Crieff.

What to think about for fire door hold-open devices in Perth and Kinross

  • Fire doors on stairs and protected escape routes need particular care. The fire risk assessment may allow some of them to be held open and not others, so pricing is door by door.
  • Background noise matters for acoustic units. Kitchens, plant areas and busy receptions may be too loud for a unit that listens for the alarm, so a wired or radio device is often better there.
  • If the alarm panel has no spare outputs, a relay or an extra interface may be needed. Your alarm engineer can confirm this, and it is added to the quote once agreed.
  • Listed buildings and conservation areas can make new cable runs difficult. Radio-triggered battery units avoid most wiring, although the transmitter still needs a connection at the alarm panel.
  • Residential blocks often have communal corridor doors that residents prop open. Hold-open devices give the same convenience while letting the doors close when the alarm sounds.

Fire door hold-open devices in Perth and Kinross: guide prices

The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £145 ex VAT.

ItemGuide priceNotes
Battery acoustic hold-open unit£145 – £295per door, fitted, ex VAT
Hard-wired hold-open magnet linked to the fire alarm£245 – £595per door, ex VAT; alarm panel work extra
Free-swing door closer linked to the fire alarm£395 – £895per door, fitted, ex VAT

Which hold-open device is suitable depends on your fire risk assessment. Linking to the fire alarm may need work by your alarm engineer.

Standards and rules in Scotland

Fire doors that are held open must close automatically when the fire alarm operates. Where hold-open devices can be used is decided by the fire risk assessment, which is the job of the person responsible for fire safety under the Fire (Scotland) Act 2005.

Hold-open devices and door release units linked to the fire alarm need regular testing as part of the building’s fire safety checks, and the results should be recorded.

Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.

How it works

  1. Get in touch. Call, email or use the form with the address and what you have in mind. If you are not sure which type of door suits, describe the entrance and we will suggest the options worth considering.
  2. Survey and advice. The survey costs nothing and carries no obligation. The engineer checks the site and explains which options suit the entrance, the people using it and the budget, before anything is priced.
  3. Quote in writing. You receive a fixed, itemised quote for fire door hold-open devices in Perth and Kinross, covering equipment, installation, testing and handover, with the lead time and payment stages set out clearly.
  4. Install, test, explain. The engineer installs and commissions the door, tests the sensors, safety functions and emergency behaviour, and walks you through the controls. The handover pack records what was installed and tested.

Ask for a hold-open survey in Perth and Kinross. We will check each door and the alarm system, then quote a fixed price with the right device for every opening.

Fire door hold-open devices in Perth and Kinross: questions

Are battery hold-open units a good choice for older buildings in Perth and Kinross?

Often they are. Radio and acoustic battery units avoid long cable runs, which helps in older or listed buildings and finished corridors. Acoustic units are only suitable where the fire risk assessment allows them and the alarm can be heard clearly at the door. Batteries need replacing at the interval the maker states.

What is the guide price for fire door hold-open devices in Perth and Kinross?

Our guide starts from £145 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Perth and Kinross confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.

What will the survey in Perth and Kinross look at?

The engineer checks that each door closes and latches from fully open, the condition of the closer and seals, where the door rests when open, nearby power supplies and the alarm panel or radio options. We also ask to see the relevant part of the fire risk assessment, so the quote covers only doors that can be held open.

Do care homes in Perth and Kinross use free-swing closers?

Many do. A free-swing closer lets residents open their bedroom door without pushing against a closer, and it still shuts the door when the fire alarm operates. Whether it suits each room depends on the home's fire risk assessment and evacuation strategy, which we read before recommending any device.

Will the building stay secure while the entrance is being changed?

We plan to keep the entrance usable or secure throughout. Where a door has to come out, the work is sequenced so the opening is closed up before the engineer leaves, or a temporary door or hoarding is arranged when a longer gap cannot be avoided. How this is handled for your site in Perth and Kinross is agreed before work starts.

What do you need from us for parking and access in Perth and Kinross?

Somewhere for the engineer's van as close to the entrance as possible, and a clear working area around the door. If parking is restricted, loading rules apply or the site has security procedures, tell us when you book. Those details go into the plan so the visit is not held up on the day.

Do businesses in Perth and Kinross have to fit automatic doors?

No law requires automatic doors everywhere. Under the Equality Act 2010 service providers and employers must make reasonable adjustments for disabled people, and Scottish guidance says powered doors improve accessibility at entrances. An automatic door is often the practical answer.

Next step

Fire door hold-open devices in Perth and Kinross

Send the address, a photo if you have one and what the door needs to do. New installations get a free site survey and a fixed written quote; repairs and servicing are priced in writing before we attend.