Coverage across Perth and Kinross
Not every part of Perth and Kinross is easy to reach, and some sites need planning around access, parking or opening hours. We take that into account when arranging safety and compliance upgrades, and the engineer, working under our management, arrives with what the job is likely to need. The towns below, 3 in all, each have their own page, but any address in the area can be covered.
Towns listed in Perth and Kinross: Perth, Blairgowrie, Crieff.
What to think about for safety and compliance upgrades in Perth and Kinross
- Programme switches within reach of the public in Perth and Kinross should be key-operated or protected, so the door cannot be left in an unsafe mode by mistake.
- Listed buildings and conservation areas in Perth and Kinross may limit visible changes. Slim sensors and discreet guards keep the look of the historic entrance largely unchanged.
- Escape route doors must open, break out or be openable by hand as the fire strategy requires. Check what yours says before choosing which upgrades to make.
- After upgrades, keep the record with your inspection report. Matching each change to its finding shows the actions have been closed off, which insurers often ask to see.
- Busy retail and public buildings in Perth and Kinross may prefer upgrade work out of hours. Most single-door upgrades are completed in one visit, so disruption is limited.
Safety and compliance upgrades in Perth and Kinross: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £195 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Add or replace a safety or activation sensor | £195 – £495 | per sensor fitted, ex VAT |
| Side-screen protection or guarding | from £295 | per door, ex VAT |
| Battery backup for power-cut operation | £395 – £695 | per door, ex VAT |
| Programme switch with key | £145 – £345 | fitted, ex VAT |
| Upgrade package for an older door | £795 – £2,495 | typical, after an inspection, ex VAT |
Standards and rules in Scotland
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Tell us about the entrance. Send the address, a few photos and a rough size of the opening, and say how the door is used. That is enough for us to suggest options for safety and compliance upgrades and book a survey in Perth and Kinross.
- Free site survey. A specialist engineer working under our management measures the opening, checks the frame, floor, head height and power, and talks through how people use the entrance. There is no charge and no obligation.
- Fixed written quote. You receive a fixed, itemised written quote with the specification, lead time, payment stages and warranty terms. The price does not change unless the scope does, and any change is agreed in writing first.
- Installation and handover. The door is fitted on the agreed dates, then set up, tested and documented with reference to BS EN 16005. You are shown the controls and the simple checks to make, and receive the handover paperwork.
Need battery backup, safety sensors or side-screen guarding in Perth and Kinross? Get in touch for a survey at no cost and a fixed price.
Safety and compliance upgrades in Perth and Kinross: questions
Can upgrades in Perth and Kinross be phased over time?
Yes. Each item is priced separately, so you can start with the high-priority findings and plan the rest for later, often at the next service visit. Your quote shows which items are urgent and which can sensibly wait, so you can budget for each phase.
How much should I budget for safety and compliance upgrades in Perth and Kinross?
Our guide starts from £195 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Perth and Kinross confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Do you need an inspection before upgrading a door in Perth and Kinross?
Not always. If you know what you need, such as a key switch or new signs, we can survey and quote for it directly. For a full picture of the door's risks, a documented safety inspection is the better starting point, and it is a separate service priced before the visit.
Do you carry out automatic door safety upgrades in Perth and Kinross?
Yes. We quote and manage upgrade work in Perth and Kinross, and the fitting is done by specialist automatic door engineers on our behalf. The survey is free, and each upgrade is priced separately on a fixed, itemised quote. After the work you receive a record of each change and its test results.
How do you make sure the door works for disabled visitors in Perth and Kinross?
We look at who uses the entrance: wheelchair users, people with walking aids, parents with buggies and older visitors. That shapes the opening width, the opening speed, the hold-open time and where push pads or sensors go. Service providers and employers have duties to make reasonable adjustments under equality and accessibility law, and an automatic door is a common one.
Can installation in Perth and Kinross happen outside opening hours?
Yes. Many shops, surgeries and offices prefer work early in the morning, in the evening or at weekends, when the entrance is quietest. Tell us your constraints when you enquire and they are built into the plan. Any extra cost for out-of-hours work is shown in the written quote rather than added afterwards.
Is a building warrant needed for a new automatic entrance in Perth and Kinross?
Often, yes. Most building work in Scotland needs a building warrant before it starts, and the non-domestic Technical Handbook sets out what an accessible entrance should provide, including a clear opening of at least 800 mm. We tell you at the survey if your job is likely to need one.