Covering Uxbridge and nearby
From shops and surgeries to schools, care homes and private houses, any building in the UB8 postcode district can be covered for sensor upgrades and replacement. Specialist engineers working under our management carry out the work, and you deal with us as the contracting party from start to finish.
Transport hubs, large stations and busy retail streets in and around Uxbridge put automatic doors under near-constant use. Heavy-duty operators, break-out leaves on escape routes and regular servicing are typical requirements at entrances this busy.
Nearby towns we also list for sensor upgrades and replacement (straight-line distance): Ruislip (3.0 miles), Hayes (3.4 miles), Gerrards Cross (4.1 miles), Chalfont St Peter (5.2 miles), Southall (5.5 miles), Slough (5.6 miles).
What to think about for sensor upgrades and replacement in Uxbridge
- Doors with side screens may need a light curtain on the leaf edge or post to protect the gap. This is one of the most common upgrades on older sliding doors.
- Shiny, wet or newly polished floors can confuse infrared safety sensors. Mention any recent floor changes at your building in Uxbridge so the zones can be set for the new surface.
- After a near miss at a door in Uxbridge, keep a note of what happened and where the person was standing. It helps the engineer judge which zone the sensor failed to cover.
- Shopping parades and older shopfronts in Uxbridge sometimes have low transoms or canopies that limit where a sensor can be mounted. The engineer checks height and angle first.
- Swing doors in narrow corridors need sensors on the leaf to protect people on both sides. The engineer checks the swing path and any walls or fittings close by.
Sensor upgrades and replacement in Uxbridge: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: typically £195 to £495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Add or replace a safety or activation sensor | £195 – £495 | per sensor fitted, ex VAT |
| Touch-free switch or push pad | £145 – £395 | per switch, ex VAT |
| Side-screen or light-curtain protection | from £295 | per door, ex VAT; on survey |
Sensor prices cover the part, fitting and set-up. If a sensor is fitted on a visit of its own, the visit charge (from £95 ex VAT) is added, and we confirm the total in writing before an engineer attends. Each sensor is set up for the door and tested before the engineer leaves.
Standards and rules in England
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
How it works
- Report the fault or service. Let us know whether the door has failed, is behaving oddly or is simply due a service or safety inspection. A short video of the problem helps the engineer prepare for the visit.
- Agree the price first. Before anyone travels to Uxbridge, the visit price is set out in writing. It is based on the door type, the work requested and the location, so you know the cost in advance.
- Diagnose, repair, test. On site, the engineer finds the cause and puts it right where the parts are to hand, or completes the planned service. Sensors, safety functions and emergency behaviour are checked before the door returns to use.
- Paperwork and next steps. A written record of the visit is left with you or sent afterwards. If parts must be ordered or more work is advisable, it is quoted separately and only goes ahead once you accept.
Upgrade the sensors on an older automatic door in Uxbridge. Tell us the door type and what it is doing, and we will price the work in writing.
Sensor upgrades and replacement in Uxbridge: questions
Our door in Uxbridge closes on people. Is that a sensor fault?
It is likely, and the door should be treated as unsafe. Switch it to a safe mode, such as manual or open, and keep people away from the leaves. Tell us it is unsafe and we will give you the earliest visit we can offer, then the engineer will check the safety sensors and their zones.
How much should I budget for sensor upgrades and replacement in Uxbridge?
Our guide is £195 to £495 excluding VAT (per sensor fitted), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in Uxbridge, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Will you record the sensor settings for our building in Uxbridge?
Yes. The job report lists each sensor fitted, its position, the settings used and the test results. Keep it with your service records, as it helps future engineers and shows the door's safety set-up was checked after the work. The same details are useful if an insurer or inspector asks.
Will new sensors stop false openings at our entrance in Uxbridge?
Usually. Modern sensors can ignore cross traffic and detect only people moving towards the door, and the zone can be narrowed. If the entrance faces a busy street or catches heavy weather, the engineer may suggest a sensor that filters those conditions better.
Do you leave a written record after each visit in Uxbridge?
Yes. Every visit ends with a written record of what was checked, what was done and anything that still needs attention. For safety inspections you receive a report of the findings and a site-specific risk assessment. Keeping these on file is the usual way to show that a workplace door is maintained and in good working order.
Are parts quoted before they are fitted?
Always. If a repair or service in Uxbridge needs parts, such as rollers, belts, sensors, a control board or a motor, we quote them in writing first. Some common parts may be on the engineer's van; others are ordered once you accept the quote and fitted on a return visit at a price already agreed.
Do businesses in Uxbridge have to fit automatic doors?
No law says every building must have automatic doors. Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, and building regulations guidance in England calls for a powered door where an entrance door would otherwise be too heavy to open. An automatic door is often the simplest way to meet both.