Coverage across Dunbartonshire
Booking safety inspections and risk assessments in Dunbartonshire does not depend on being close to a particular town. Engineers working under our management travel throughout the area, and nothing goes ahead until the price has been agreed in writing. Below are the towns we list here, 7 at present, each linking to a page with nearby places and guide prices.
Towns listed in Dunbartonshire: Bearsden, Clydebank, Bishopbriggs, Dumbarton, Kirkintilloch, Milngavie, Alexandria.
What to think about for safety inspections and risk assessments in Dunbartonshire
- Schools and nurseries need particular care with finger traps at hinges and beside side screens, because children are more likely to put their hands into gaps.
- Older shopfronts and listed buildings in Dunbartonshire may have narrow side screens and tight gaps that were thought acceptable when fitted. The report weighs what can reasonably be improved.
- Retail entrances in Dunbartonshire with heavy footfall can have sensors knocked out of alignment over time. The inspection checks that detection still covers the full closing edge.
- Programme switches left in the wrong mode cause many incidents. The inspection checks the switch is secure, labelled and set correctly for each time of day.
- Power failure behaviour is easy to overlook. The inspection tests what the door does when the mains supply or battery fails, which matters most on escape routes.
Safety inspections and risk assessments in Dunbartonshire: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: typically £125 to £250 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Safety inspection and risk assessment, existing door | £125 – £250 | per door, written report, ex VAT |
| Inspection added to a service visit | reduced | quoted with the service |
| Upgrades found by the inspection | quoted separately | see safety and compliance upgrades |
The inspection price is agreed in writing before the visit. Any upgrades the report recommends are quoted separately so you can plan them.
Standards and rules in Scotland
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
How it works
- Explain the problem. Whether the door is stuck, slow, noisy or due its next check, a short description and a few photos tell us which kind of visit to book for safety inspections and risk assessments and what to bring.
- Visit cost agreed. You get the visit price in writing before we book the engineer. There are no hidden extras: parts and further work are always quoted separately and in advance.
- Engineer on site. The engineer inspects the operator, sensors, tracks and leaves, carries out the repair or service, and runs the door through its safety tests before it goes back into use.
- Follow-up quoted. You are sent a record of the visit. If something else needs attention, we quote it in writing; for doors on a service plan, the next visit date is noted on the record.
Need a risk assessment for an insurer or landlord in Dunbartonshire? Send us their request and we will arrange an inspection and a written report.
Safety inspections and risk assessments in Dunbartonshire: questions
How long will our door in Dunbartonshire be out of use during the inspection?
Usually only for short periods while sensors are tested and the door is observed in different modes. A single door generally takes about an hour in total. For busy entrances the inspection can be planned for a quieter time, or one leaf tested at a time where the door allows it.
How are prices worked out for safety inspections and risk assessments in Dunbartonshire?
Our guide is £125 to £250 excluding VAT (per door), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in Dunbartonshire, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
How often should doors in Dunbartonshire be risk assessed?
There is no set legal frequency. Most owners assess each door once, then repeat the assessment when the door is altered, when the people using it change or after an incident. In between, regular servicing keeps the safety functions checked, which in our view should happen at least once a year.
Can you inspect all the doors on our site in Dunbartonshire in one visit?
Usually, yes. A whole-site inspection covers every automatic door in one visit and one report, with each door's findings ranked so you can compare priorities across the site. Larger sites may need more than one day, which we agree with you when the inspection is priced.
Can you price a repair in Dunbartonshire from photos?
Sometimes. Clear photos of the door, the operator cover and any label showing the make and model, plus a description of what the door is doing, can let us price a likely repair before a visit. Where the cause is not obvious, we agree a diagnostic visit price in writing first and quote the repair afterwards.
What happens during a visit in Dunbartonshire?
The engineer checks how the door is operating, diagnoses the fault or carries out the service, and tests the safety sensors and other functions before leaving. On a service visit that includes cleaning, adjustment and lubrication where needed. Anything that cannot be put right on the visit, or that needs parts, is explained and quoted before further work goes ahead.
Is a building warrant needed for a new automatic entrance in Dunbartonshire?
Often, yes. Most building work in Scotland needs a building warrant before it starts, and the non-domestic Technical Handbook sets out what an accessible entrance should provide, including a clear opening of at least 800 mm. We tell you at the survey if your job is likely to need one.