Covering Swindon and nearby
For drive unit replacement, coverage around Swindon is set by postcode and includes the SN1, SN2, SN3, SN5 and SN25 postcode districts, as well as nearby addresses in Wiltshire. Specialist engineers working under our management attend each site, and the price is agreed in writing beforehand.
Universities, colleges and city hotels see sharp peaks of traffic at changeover times and check-in hours. For entrances like these in Swindon, opening width, hold-open time and sensor range are set so the door copes with crowds without wasting heat.
Nearby towns we also list for drive unit replacement (straight-line distance): Calne (12.7 miles), Cirencester (13.8 miles), Chippenham (16.3 miles), Melksham (20.1 miles), Witney (20.1 miles), Stroud (22.3 miles).
What to think about for drive unit replacement in Swindon
- Listed buildings and conservation areas in Swindon make it attractive to keep the existing frame. A new operator inside the existing header changes little that can be seen.
- Worn floor guides and rollers can shorten the life of a new operator. It is often worth replacing them during the same visit rather than coming back later.
- Busy retail entrances in Swindon may prefer the changeover after closing time or on a quiet trading day. Tell us your hours when you book the survey.
- Check the power supply. A dedicated fused spur and isolator near the door is usually needed, and older installations sometimes need electrical work before the new operator goes in.
- Hospitals and care homes in Swindon may need an alternative entrance during the changeover. Plan signs and step-free access for wheelchair users before work starts.
Drive unit replacement in Swindon: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: typically £1,995 to £3,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| New drive unit on an existing automatic sliding door | £1,995 – £3,995 | existing leaves kept, installed, ex VAT |
| New operator on an existing automatic swing door | £1,795 – £3,995 | installed, ex VAT |
| Sensors replaced at the same time | £195 – £495 | per sensor, ex VAT |
Standards and rules in England
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in Swindon.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Get in touch about drive unit replacement in Swindon. The door is surveyed free of charge and the changeover planned around your opening hours.
Drive unit replacement in Swindon: questions
Do you replace automatic door drive units in Swindon?
Yes. We are the contracting party for drive unit replacements in Swindon, and the survey and changeover are carried out by specialist engineers we manage. The survey is free and checks that the frame and leaves are worth keeping. You then receive a fixed, itemised quote for the new operator, sensors and any other parts the door needs.
What price range should I expect for drive unit replacement in Swindon?
Our guide is £1,995 to £3,995 excluding VAT (per door), the same guide prices we use across the UK. The free site survey in Swindon confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Can you fit a new operator to a door another company installed in Swindon?
Yes. We replace drive units on doors whoever fitted them. The survey identifies the existing header, leaves and track, and adapter plates usually let a new drive unit from one of the major European operator brands fit without changing the frame.
Do you provide paperwork for the converted door in Swindon?
Yes. When we fit a new drive unit we prepare the paperwork for the finished door, including the risk assessment, Declaration of Conformity and user instructions, and hand it over with the test results and settings. It belongs with your building records.
How do you make sure the door works for disabled visitors in Swindon?
We look at who uses the entrance: wheelchair users, people with walking aids, parents with buggies and older visitors. That shapes the opening width, the opening speed, the hold-open time and where push pads or sensors go. Service providers and employers have duties to make reasonable adjustments under equality and accessibility law, and an automatic door is a common one.
What power supply is needed for drive unit replacement in Swindon?
Most powered doors need a fused spur close to the operator, and some activation and access control devices also need a low-voltage link. The survey checks what is already there. If a new supply is required, the quote says whether we arrange it or your own electrician does, so nothing is left unclear on the day.
Who is responsible for automatic doors on escape routes in Swindon?
Under the Regulatory Reform (Fire Safety) Order 2005 the responsible person for the premises must make sure escape routes work and fire safety equipment is maintained. Automatic doors on an escape route need fail-safe opening or break-out, set by the fire strategy.