Coverage across Worcestershire
Not every part of Worcestershire is easy to reach, and some sites need planning around access, parking or opening hours. We take that into account when arranging automating an existing door, and the engineer, working under our management, arrives with what the job is likely to need. The towns below, 8 in all, each have their own page, but any address in the area can be covered.
Towns listed in Worcestershire: Worcester, Redditch, Kidderminster, Malvern, Bromsgrove, Evesham, Droitwich Spa, Stourport-on-Severn.
What to think about for automating an existing door in Worcestershire
- Older buildings in Worcestershire often have heavy timber doors on floor springs. Some floor springs can be adapted, but many need replacing with hinges, which adds to the cost.
- If the door is on an escape route, keep the existing panic or emergency hardware working. The operator should not stop the door opening by hand in an emergency.
- Power is needed at the head of the door. If there is no supply close by, an electrician will need to run one, ideally hidden in trunking or the wall.
- Schools and community buildings in Worcestershire may prefer the work done in holidays or after hours. Ask for any out-of-hours working to be priced in the quote.
- Find out whether the door is a fire door. If it is, the operator must suit fire doors and be wired so the door closes when the alarm sounds.
Automating an existing door in Worcestershire: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £1,795 ex VAT (£2,154 inc VAT).
| Item | Guide price | Notes |
|---|---|---|
| Low-energy operator on an existing swing door | £1,795 – £2,995 | installed, ex VAT; homes £2,154 – £3,594 inc VAT |
| Full-energy operator on an existing swing door, with safety sensors | £2,495 – £3,995 | installed, ex VAT; homes £2,994 – £4,794 inc VAT |
| Operators on an existing pair of swing doors | £3,795 – £6,495 | installed, ex VAT; homes £4,554 – £7,794 inc VAT |
| Automating an existing manual sliding door or screen | £2,995 – £5,495 | installed, ex VAT; homes £3,594 – £6,594 inc VAT |
Standards and rules in England
Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, which can include altering a physical feature such as a heavy entrance door. Fitting an automatic door helps, but does not on its own guarantee those duties are met.
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
How it works
- Send photos and the address. A few pictures of the door from both sides, the address in Worcestershire and a note of who uses the entrance help us understand the job before anyone visits the site.
- No-cost survey on site. We arrange a survey at a time that suits the building. The engineer records measurements, fixings and power, plus any constraints such as listed status, opening hours or access for deliveries.
- Itemised quote to approve. We price every element of the work on automating an existing door separately in a written quote that you can check, share and approve. Lead time and payment stages are stated, and nothing is ordered until you accept.
- Fit, test and hand over. On the agreed dates the engineer installs the equipment, commissions the operator and tests each safety function. You get a demonstration, the test record and any conformity paperwork that applies to the work.
Keep the door you have and make it automatic. Book a free survey in Worcestershire and receive a written, itemised quote.
Automating an existing door in Worcestershire: questions
Can you automate the existing doors at our building in Worcestershire?
In most cases, yes. We check each door at a free survey, including the hinges, frame, glass, locks and power, and then quote a fixed price. If a door is not a good candidate, we explain why and what it would take to fix it, or quote a replacement instead.
What do you charge for automating an existing door in Worcestershire?
Our guide starts from £1,795 excluding VAT (per door), the same guide price we use across the UK. For homes that is from £2,154 including VAT. The free site survey in Worcestershire confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Can you automate a front door at a house in Worcestershire?
Yes. Front doors at home are often automated for wheelchair users and people with limited grip, usually with an electric keep or lock so the door locks itself as it closes. Home prices are quoted including VAT, and the survey is free.
How long will our door in Worcestershire be out of use?
Usually half a day to a day per door. Where hinges, locks or glass are being changed as well, it can take longer. We plan the work so the building stays usable, and agree any out-of-hours working in the quote.
What happens to the old door when a new one is fitted in Worcestershire?
If the work replaces an existing door, frame or operator, removal and disposal are listed in the quote. The old door comes out only when the new one is ready to go in, so the opening is not left empty for longer than necessary. Making good to the surrounding wall, floor or ceiling is included where the quote says so.
Do I need permission from a landlord or the council before work in Worcestershire?
It depends on the building. Tenants usually need the landlord's written consent before changing an entrance, and some changes to a shopfront or external door need planning permission. The survey notes anything that may need consent. We can supply drawings and product details to support an application, but the owner or tenant makes it.
Do businesses in Worcestershire have to fit automatic doors?
No law says every building must have automatic doors. Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, and building regulations guidance in England calls for a powered door where an entrance door would otherwise be too heavy to open. An automatic door is often the simplest way to meet both.