Coverage across Bedfordshire
Booking curved automatic doors in Bedfordshire does not depend on being close to a particular town. Engineers working under our management travel throughout the area, and nothing goes ahead until the price has been agreed in writing. Below are the towns we list here, 5 at present, each linking to a page with nearby places and guide prices.
Towns listed in Bedfordshire: Luton, Bedford, Dunstable, Leighton Buzzard, Kempston.
What to think about for curved automatic doors in Bedfordshire
- A full-round door needs a roof or canopy that can be supported and drained. On exposed sites across Bedfordshire, think about how rainwater will leave the canopy without running down the glass into the threshold.
- If the entrance is on an escape route, the fire strategy decides how the door must behave when the alarm sounds or the power fails. Confirm this with your fire risk assessor before the design is fixed.
- Listed buildings and conservation areas in Bedfordshire may need consent for a curved entrance. Drawings showing the radius, frame colour and canopy detail help the planning authority understand the proposal.
- Curved doors on landmark buildings in Bedfordshire are often lit at night. Plan canopy lighting, signage and any warm air curtain alongside the door, so cables and fixings are in place before the glass goes in.
- The floor must be level across the whole arc, and the matwell and floor finish need cutting to the same radius as the guides. Coordinate the floor layer with the door programme so the curves match.
Curved automatic doors in Bedfordshire: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £14,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Half-round curved sliding entrance | from £14,995 | installed, ex VAT; priced on survey |
| Full-round curved entrance or large radius | Priced on survey | glass and track are made to the radius |
| Battery backup for power-cut operation | £395 – £695 | per door, ex VAT |
| Card or fob reader tied into the door | £795 – £2,495 | per door, ex VAT |
Curved doors are designed and priced after a free site survey, because the glass, track and screens are made to the radius of your entrance.
Standards and rules in England
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking. Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, which can include altering a physical feature such as a heavy entrance door. New entrances and some alterations count as building work, so check with building control before the work is ordered.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in Bedfordshire.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Planning a landmark entrance in Bedfordshire? Contact us early, so the survey, drawings and curved glass all fit your programme.
Curved automatic doors in Bedfordshire: questions
Who looks after a curved door in Bedfordshire once it is fitted?
You can arrange servicing with us, with each visit priced in writing beforehand. Curved doors need regular attention to the floor guides and carriages that follow the arc. A trained engineer should check the safety functions at least once a year, and busy hotel or store entrances are usually serviced more often.
How much should I budget for curved automatic doors in Bedfordshire?
Our guide starts from £14,995 excluding VAT (per entrance), the same guide price we use across the UK. The free site survey in Bedfordshire confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Will we need planning permission for a curved entrance in Bedfordshire?
Possibly. A curved door that changes the look of the frontage or projects beyond the building line may need planning permission, and listed buildings may need listed building consent. Your local planning authority decides. We raise the question at survey and can supply drawings and product details for an application.
Can a curved door in Bedfordshire replace a revolving door?
In many cases, yes. A full-round curved door gives similar draught protection with a straight, open path through, which many visitors find easier than a revolving door. The survey checks whether the existing drum position, floor recess and canopy can be reused or need altering.
What does the free site survey in Bedfordshire involve?
An engineer working under our management visits the building, measures the opening, checks the frame, floor, head height and power supply, and looks at how people use the entrance. The survey is free and carries no obligation. Afterwards you receive a fixed, itemised written quote for curved automatic doors, with drawings where the door type needs them.
Can automatic doors be fitted to a listed building in Bedfordshire?
Often, yes, but listed building consent is normally needed for changes that affect the character of the building, inside or out. Slim operators, concealed fixings and automating the existing door can all reduce the visual impact. Speak to the conservation officer at the local planning authority early; we can provide drawings and specifications to help.
Who is responsible for automatic doors on escape routes in Bedfordshire?
Under the Regulatory Reform (Fire Safety) Order 2005 the responsible person for the premises must make sure escape routes work and fire safety equipment is maintained. Automatic doors on an escape route need fail-safe opening or break-out, set by the fire strategy.