Coverage across Bedfordshire
Here is how coverage works in Bedfordshire. You contact us with the address and what the door needs, we confirm the price in writing, and a specialist engineer working under our management attends on an agreed date. That applies to automatic swing doors at a single shop door or across a whole estate of buildings, in any of the towns below or between them.
Towns listed in Bedfordshire: Luton, Bedford, Dunstable, Leighton Buzzard, Kempston.
What to think about for automatic swing doors in Bedfordshire
- Schools in Bedfordshire often prefer installation during half-term or the summer holidays. Operators are typically 2 to 4 weeks from order, so book the survey a few weeks before the break.
- Hospital and care home corridors in Bedfordshire need doors that open early enough for beds and trolleys. Radar sensors set to the right range, or a push pad placed before the door, keep traffic moving.
- External swing doors facing the wind need stronger operators and careful set-up. On exposed sites across Bedfordshire, consider whether a canopy or a sliding door would work better.
- Doors that open into a corridor can strike people approaching from the side. Guard rails or extra sensors may be needed where the swing area meets a busy route.
- Fire doors need care. The operator must suit the door, keep its fire performance intact and close the door when the alarm sounds, so have the door's labels and records to hand for the survey.
Automatic swing doors in Bedfordshire: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £2,495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Full-energy operator on an existing single door, with safety sensors | £2,495 – £3,995 | installed, ex VAT |
| Operators on an existing pair of doors | £3,795 – £6,495 | installed, ex VAT |
| New single automatic swing door set (door, frame and operator) | £3,495 – £6,495 | installed, ex VAT |
| New double automatic swing door set | £7,995 – £9,995 | installed, ex VAT |
| Touch-free switch or push pad, fitted | £145 – £395 | per switch, ex VAT |
| Card or fob reader tied into the door | £795 – £2,495 | per door, ex VAT |
Standards and rules in England
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking. Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, which can include altering a physical feature such as a heavy entrance door. New entrances and some alterations count as building work, so check with building control before the work is ordered.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in Bedfordshire.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Ready to automate a busy door in Bedfordshire? There is no charge for the survey and no obligation once you have the quote.
Automatic swing doors in Bedfordshire: questions
How quickly can a swing operator be fitted in Bedfordshire?
Operators for existing doors are typically 2 to 4 weeks from order. On site, a single door usually takes half a day to a day, and a pair about a day. We can plan work for evenings, weekends or holidays where the building is busy, with any extra cost shown in the quote.
How are prices worked out for automatic swing doors in Bedfordshire?
Our guide starts from £2,495 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Bedfordshire confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Can our existing doors in Bedfordshire be automated?
Usually, if the doors, hinges and frames are in good condition. The survey checks the door weight, the hinges, what the operator will fix to and what sits in the swing path. Where a door is too worn, we will say so and quote a new doorset with the operator fitted instead.
What paperwork do we get for automated doors in Bedfordshire?
You receive the test record, a site-specific risk assessment, user instructions and the conformity paperwork for each door. When an existing manual door is motorised, whoever does it may take on the manufacturer's duties for the finished door, so the Declaration of Conformity and instructions are handed over at the end of the job.
What happens to the old door when a new one is fitted in Bedfordshire?
If the work replaces an existing door, frame or operator, removal and disposal are listed in the quote. The old door comes out only when the new one is ready to go in, so the opening is not left empty for longer than necessary. Making good to the surrounding wall, floor or ceiling is included where the quote says so.
What is the lead time for automatic swing doors in Bedfordshire?
Lead times depend on the door type and what has to be made to order. As a guide, operators and accessible door kits are typically two to four weeks from order, and complete sliding entrances typically four to eight weeks from drawing approval. Curved, revolving and hermetic doors usually take longer. The expected lead time is stated in your quote.
Who is responsible for automatic doors on escape routes in Bedfordshire?
Under the Regulatory Reform (Fire Safety) Order 2005 the responsible person for the premises must make sure escape routes work and fire safety equipment is maintained. Automatic doors on an escape route need fail-safe opening or break-out, set by the fire strategy.