Coverage across Dyfed
Coverage for automatic door refurbishment extends across all of Dyfed, including addresses some distance from the towns listed below. We are the contracting party, the engineers work under our management, and the price is agreed in writing first. If your town is not among the 7 we list, contact us anyway; the process and guide prices do not change.
Towns listed in Dyfed: Llanelli, Aberystwyth, Carmarthen, Haverfordwest, Milford Haven, Pembroke Dock, Ammanford.
What to think about for automatic door refurbishment in Dyfed
- Busy retail units in Dyfed may prefer the work done in stages, one leaf at a time, so the entrance stays open throughout trading hours.
- After refurbishment, sensors and speeds are reset to suit the new parts. Keep the test record with your service history so later engineers can see what was done.
- Frames near the coast or busy roads can corrode faster. The survey checks fixings and the bottom of the frame, where water and grit tend to collect.
- Older shopfronts with discontinued door systems may need equivalent parts rather than exact matches. The survey identifies what is still available before anything is ordered.
- Office blocks and business parks in Dyfed with several matching doors can refurbish them together for a consistent finish and a lower cost per door.
Automatic door refurbishment in Dyfed: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £395 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Running gear refresh: rollers, guides, brushes and seals | £395 – £895 | per door, ex VAT |
| Track overhaul | £395 – £895 | per door, ex VAT |
| Replacement glass leaf | from £495 | each, ex VAT; size and glass type on survey |
| Full refurbishment of a sliding door | £1,495 – £2,995 | running gear, seals, guides and one leaf, ex VAT |
Standards and rules in Wales
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in Dyfed.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Cracked glass, worn rollers or draughty seals at your entrance in Dyfed? Book a free survey and choose the work that matters most to you.
Automatic door refurbishment in Dyfed: questions
Do you set up the door again after refurbishing it in Dyfed?
Yes. New running parts change how the leaves move, so speeds, sensor zones and obstacle detection are checked and reset before handover. You receive a record of the parts fitted and the test results to keep with the door's service history.
How much should I budget for automatic door refurbishment in Dyfed?
Our guide starts from £395 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Dyfed confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Can you refinish the frame of our door in Dyfed?
Yes. Aluminium frames can be cleaned, repaired and recoated on site to refresh their colour. Badly damaged sections may need replacing rather than refinishing. Refinishing is listed separately in the quote, so you can decide whether to include it now or leave it for a later phase.
Do you refurbish automatic doors in Dyfed?
Yes. Refurbishment work in Dyfed is planned and priced by us, then carried out by automatic door engineers and glaziers working under our management. There is no charge for the survey, and you receive a fixed quote with each item priced separately, from new glass and rollers to seals, floor guides, the threshold and frame refinishing.
Can installation in Dyfed happen outside opening hours?
Yes. Many shops, surgeries and offices prefer work early in the morning, in the evening or at weekends, when the entrance is quietest. Tell us your constraints when you enquire and they are built into the plan. Any extra cost for out-of-hours work is shown in the written quote rather than added afterwards.
Can automatic doors be fitted to a listed building in Dyfed?
Often, yes, but listed building consent is normally needed for changes that affect the character of the building, inside or out. Slim operators, concealed fixings and automating the existing door can all reduce the visual impact. Speak to the conservation officer at the local planning authority early; we can provide drawings and specifications to help.
Do businesses in Dyfed have to fit automatic doors?
There is no blanket requirement. Service providers and employers must make reasonable adjustments for disabled people under the Equality Act 2010, and Welsh building regulations guidance expects entrances that are easy to open. An automatic door is a common way to meet both.