Covering Portree and nearby
We cover the whole of the IV51 postcode district, along with nearby towns in the Highlands. You book each visit for sensor upgrades and replacement directly with us, and a specialist automatic door engineer working under our management travels to your site on the agreed date.
Small offices, community centres and village halls around Portree tend to have one main entrance, often used by visitors who need level access without steps. Automating the existing door, rather than replacing it, is frequently the most practical and affordable route.
What to think about for sensor upgrades and replacement in Portree
- Corridor doors that people walk past rather than through may work better on a touch-free switch than a motion sensor, cutting needless openings and heat loss.
- After a near miss at a door in Portree, keep a note of what happened and where the person was standing. It helps the engineer judge which zone the sensor failed to cover.
- Shopping parades and older shopfronts in Portree sometimes have low transoms or canopies that limit where a sensor can be mounted. The engineer checks height and angle first.
- Sites in Portree that open early or close late may want sensor work done outside trading hours. Tell us the quieter times when you book the visit.
- Shiny, wet or newly polished floors can confuse infrared safety sensors. Mention any recent floor changes at your building in Portree so the zones can be set for the new surface.
Sensor upgrades and replacement in Portree: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. For island addresses, travel is included in the agreed visit price. Guide price: typically £195 to £495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Add or replace a safety or activation sensor | £195 – £495 | per sensor fitted, ex VAT |
| Touch-free switch or push pad | £145 – £395 | per switch, ex VAT |
| Side-screen or light-curtain protection | from £295 | per door, ex VAT; on survey |
Sensor prices cover the part, fitting and set-up. If a sensor is fitted on a visit of its own, the visit charge (from £95 ex VAT) is added, and we confirm the total in writing before an engineer attends. Each sensor is set up for the door and tested before the engineer leaves.
Standards and rules in Scotland
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
How it works
- Make contact. Phone, email or use the form. Tell us the type of door, what it is doing and whether it is safe to use, so the right visit for sensor upgrades and replacement can be planned.
- Written visit price. The cost of attending is agreed in writing before the visit is booked. For a planned service or inspection, the price per door and what each visit includes are set out at the same time.
- On-site work. The engineer, working under our management, checks the door from end to end, deals with the fault or the service, and tests every safety function and sensor setting before signing the door off.
- Report and quote. You receive a report of the findings. Where a repair, part or upgrade is recommended, it is quoted in writing so you can decide, and the door is left in a safe state if it cannot be used.
Send a photo of the door and sensor at your building in Portree, and we will confirm the visit price and the likely sensor before booking an engineer.
Sensor upgrades and replacement in Portree: questions
Can you price new sensors for my door in Portree from photos?
Often, yes. Photos of the sensor, the door from both sides and the label on the operator cover usually tell us which sensor is needed and whether it suits the controller. We can then quote the sensor and fitting in advance, with the visit price confirmed before anyone travels.
What is the guide price for sensor upgrades and replacement in Portree?
Our guide is £195 to £495 excluding VAT (per sensor fitted), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in Portree, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Do you replace automatic door sensors in Portree?
Yes. Sensor replacement and upgrades in Portree are booked and managed by us and carried out by engineers who specialise in automatic doors. They work on sensors for sliding, swing, folding and revolving doors from most makers. The visit cost is set in writing before they attend, and each new sensor is tested before they leave.
Can a risk assessment in Portree tell us which sensors we need?
Yes. A safety inspection tests each hazard zone and records where sensor coverage is missing or poor. The report then lists the sensors or light curtains needed, and we can quote those items exactly as listed, or you can pass the report to another competent installer.
How is the visit price set for work in Portree?
We agree the visit price with you in writing before an engineer attends. It is based on the type of door, the work requested and the location. If parts or further work are needed once the engineer has found the cause, those are quoted before they are done, so the cost never moves without your agreement.
Do you offer service contracts in Portree?
Yes. A service contract sets out how many visits a year each door receives, what each visit includes and the price, all agreed in writing before you sign. Contracts suit sites with several doors or busy entrances, because visits are planned ahead and the records stay in one place. Contract length and notice terms are shown in the agreement.
Who is responsible for automatic doors on escape routes in Portree?
The person responsible for fire safety under the Fire (Scotland) Act 2005 for those premises. Scottish guidance allows automatic doors on escape routes only where they fail safely to outward opening or have a monitored fail-safe system that opens them on power failure, sensor failure and fire alarm.