Covering Eastleigh and nearby
From shops and surgeries to schools, care homes and private houses, any building in the SO50 postcode district can be covered for sensor upgrades and replacement. Specialist engineers working under our management carry out the work, and you deal with us as the contracting party from start to finish.
Business parks around Eastleigh tend to have reception doors that see steady rather than heavy traffic, often with access control after hours. A swing or sliding operator linked to a card reader or intercom is a common arrangement for entrances like these.
Nearby towns we also list for sensor upgrades and replacement (straight-line distance): Chandler's Ford (2.5 miles), Hedge End (4.3 miles), Southampton (4.9 miles), Romsey (6.7 miles), Winchester (6.9 miles), Totton (6.9 miles).
What to think about for sensor upgrades and replacement in Eastleigh
- Care settings in Eastleigh often need longer hold-open times and wider safety zones for residents who move slowly, use walking frames or pause in the doorway.
- Corridor doors that people walk past rather than through may work better on a touch-free switch than a motion sensor, cutting needless openings and heat loss.
- Shiny, wet or newly polished floors can confuse infrared safety sensors. Mention any recent floor changes at your building in Eastleigh so the zones can be set for the new surface.
- Doors with side screens may need a light curtain on the leaf edge or post to protect the gap. This is one of the most common upgrades on older sliding doors.
- Entrances facing busy roads in Eastleigh can see false openings from passing vehicles and cyclists. A sensor with direction detection and a tighter zone usually helps.
Sensor upgrades and replacement in Eastleigh: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: typically £195 to £495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Add or replace a safety or activation sensor | £195 – £495 | per sensor fitted, ex VAT |
| Touch-free switch or push pad | £145 – £395 | per switch, ex VAT |
| Side-screen or light-curtain protection | from £295 | per door, ex VAT; on survey |
Sensor prices cover the part, fitting and set-up. If a sensor is fitted on a visit of its own, the visit charge (from £95 ex VAT) is added, and we confirm the total in writing before an engineer attends. Each sensor is set up for the door and tested before the engineer leaves.
Standards and rules in England
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
How it works
- Make contact. Phone, email or use the form. Tell us the type of door, what it is doing and whether it is safe to use, so the right visit for sensor upgrades and replacement can be planned.
- Written visit price. The cost of attending is agreed in writing before the visit is booked. For a planned service or inspection, the price per door and what each visit includes are set out at the same time.
- On-site work. The engineer, working under our management, checks the door from end to end, deals with the fault or the service, and tests every safety function and sensor setting before signing the door off.
- Report and quote. You receive a report of the findings. Where a repair, part or upgrade is recommended, it is quoted in writing so you can decide, and the door is left in a safe state if it cannot be used.
Ask for a price on new safety or activation sensors in Eastleigh. Each one is set up for the door's hazard zones and tested before the engineer leaves.
Sensor upgrades and replacement in Eastleigh: questions
Can you upgrade sensors on an old door in Eastleigh?
Most older doors can take modern sensors. A few very old controllers cannot monitor current safety sensors. If yours is one of them, we explain whether a controller upgrade or a new drive unit is the better option, and quote it, before any work is done.
How much should I budget for sensor upgrades and replacement in Eastleigh?
Our guide is £195 to £495 excluding VAT (per sensor fitted), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in Eastleigh, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Can you price new sensors for my door in Eastleigh from photos?
Often, yes. Photos of the sensor, the door from both sides and the label on the operator cover usually tell us which sensor is needed and whether it suits the controller. We can then quote the sensor and fitting in advance, with the visit price confirmed before anyone travels.
Will new sensors stop false openings at our entrance in Eastleigh?
Usually. Modern sensors can ignore cross traffic and detect only people moving towards the door, and the zone can be narrowed. If the entrance faces a busy street or catches heavy weather, the engineer may suggest a sensor that filters those conditions better.
How often should automatic doors in Eastleigh be serviced?
No law sets a fixed interval. We recommend a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer's instructions and how heavily the door is used; busy doors are often serviced more often. Site staff should also carry out simple regular checks and keep a record of them.
What if a door in Eastleigh is found to be unsafe?
The engineer explains the problem and, where needed, leaves the door in a safe state, for example switched off or set so it cannot trap or strike anyone. You receive a written note of the issue. The repair or upgrade that would put it right is quoted before any further work is carried out.
Do businesses in Eastleigh have to fit automatic doors?
No law says every building must have automatic doors. Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, and building regulations guidance in England calls for a powered door where an entrance door would otherwise be too heavy to open. An automatic door is often the simplest way to meet both.