Coverage across the East Riding of Yorkshire
Not every part of the East Riding of Yorkshire is easy to reach, and some sites need planning around access, parking or opening hours. We take that into account when arranging sensor upgrades and replacement, and the engineer, working under our management, arrives with what the job is likely to need. The towns below, 5 in all, each have their own page, but any address in the area can be covered.
Towns listed in the East Riding of Yorkshire: Hull, Bridlington, Beverley, Goole, Cottingham.
What to think about for sensor upgrades and replacement in the East Riding of Yorkshire
- Sites in the East Riding of Yorkshire that open early or close late may want sensor work done outside trading hours. Tell us the quieter times when you book the visit.
- Corridor doors that people walk past rather than through may work better on a touch-free switch than a motion sensor, cutting needless openings and heat loss.
- Doors with side screens may need a light curtain on the leaf edge or post to protect the gap. This is one of the most common upgrades on older sliding doors.
- Care settings in the East Riding of Yorkshire often need longer hold-open times and wider safety zones for residents who move slowly, use walking frames or pause in the doorway.
- Shopping parades and older shopfronts in the East Riding of Yorkshire sometimes have low transoms or canopies that limit where a sensor can be mounted. The engineer checks height and angle first.
Sensor upgrades and replacement in the East Riding of Yorkshire: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: typically £195 to £495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Add or replace a safety or activation sensor | £195 – £495 | per sensor fitted, ex VAT |
| Touch-free switch or push pad | £145 – £395 | per switch, ex VAT |
| Side-screen or light-curtain protection | from £295 | per door, ex VAT; on survey |
Sensor prices cover the part, fitting and set-up. If a sensor is fitted on a visit of its own, the visit charge (from £95 ex VAT) is added, and we confirm the total in writing before an engineer attends. Each sensor is set up for the door and tested before the engineer leaves.
Standards and rules in England
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
How it works
- Tell us what is happening. Describe the fault, or the service or inspection that is due, and send photos of the door and any label on the operator. Include the address in the East Riding of Yorkshire and how much the site depends on the door.
- Visit price agreed in writing. We confirm the price of the visit in writing before an engineer attends. If the door can be priced from photos and its make and model, we say so at this stage.
- Engineer visit. A specialist engineer working under our management diagnoses the fault or carries out the service, then tests the operation of the door and its safety sensors before leaving the site.
- Findings and follow-up. You receive a written record of what was found and done. Any parts or further work needed are quoted in writing before they go ahead, and nothing is added without your agreement.
Has a risk assessment in the East Riding of Yorkshire listed sensor upgrades? Send us the report and we will quote each item before any work is done.
Sensor upgrades and replacement in the East Riding of Yorkshire: questions
Can you price new sensors for my door in the East Riding of Yorkshire from photos?
Often, yes. Photos of the sensor, the door from both sides and the label on the operator cover usually tell us which sensor is needed and whether it suits the controller. We can then quote the sensor and fitting in advance, with the visit price confirmed before anyone travels.
What do you charge for sensor upgrades and replacement in the East Riding of Yorkshire?
Our guide is £195 to £495 excluding VAT (per sensor fitted), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in the East Riding of Yorkshire, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Will new sensors stop false openings at our entrance in the East Riding of Yorkshire?
Usually. Modern sensors can ignore cross traffic and detect only people moving towards the door, and the zone can be narrowed. If the entrance faces a busy street or catches heavy weather, the engineer may suggest a sensor that filters those conditions better.
Will you record the sensor settings for our building in the East Riding of Yorkshire?
Yes. The job report lists each sensor fitted, its position, the settings used and the test results. Keep it with your service records, as it helps future engineers and shows the door's safety set-up was checked after the work. The same details are useful if an insurer or inspector asks.
Can visits in the East Riding of Yorkshire be arranged outside working hours?
Yes, where the site needs it. Early-morning, evening and weekend visits can be arranged for shops, surgeries and offices that cannot lose their entrance during the day. Any difference in price for out-of-hours attendance is agreed in writing before the visit is booked, alongside the standard visit price.
Do you leave a written record after each visit in the East Riding of Yorkshire?
Yes. Every visit ends with a written record of what was checked, what was done and anything that still needs attention. For safety inspections you receive a report of the findings and a site-specific risk assessment. Keeping these on file is the usual way to show that a workplace door is maintained and in good working order.
Do businesses in the East Riding of Yorkshire have to fit automatic doors?
No law says every building must have automatic doors. Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, and building regulations guidance in England calls for a powered door where an entrance door would otherwise be too heavy to open. An automatic door is often the simplest way to meet both.