Coverage across the Lothians
We treat the Lothians as one service area for drive unit replacement, so a site on the edge of the area gets the same written pricing and the same standard of work as one in the busiest town centre. Specialist automatic door engineers working under our management carry out each visit. Choose from the 15 towns below, or contact us with any address.
Towns listed in the Lothians: Livingston, Musselburgh, Bathgate, Bonnyrigg, Penicuik, Broxburn, Mayfield, Linlithgow, Armadale, Dalkeith, Tranent, Whitburn, Dunbar, Prestonpans, Haddington.
What to think about for drive unit replacement in the Lothians
- Worn floor guides and rollers can shorten the life of a new operator. It is often worth replacing them during the same visit rather than coming back later.
- Heavy glass leaves need an operator rated for their weight. The survey records the size and glass type of each leaf so the right drive unit is specified.
- Listed buildings and conservation areas in the Lothians make it attractive to keep the existing frame. A new operator inside the existing header changes little that can be seen.
- Check the power supply. A dedicated fused spur and isolator near the door is usually needed, and older installations sometimes need electrical work before the new operator goes in.
- Busy retail entrances in the Lothians may prefer the changeover after closing time or on a quiet trading day. Tell us your hours when you book the survey.
Drive unit replacement in the Lothians: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: typically £1,995 to £3,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| New drive unit on an existing automatic sliding door | £1,995 – £3,995 | existing leaves kept, installed, ex VAT |
| New operator on an existing automatic swing door | £1,795 – £3,995 | installed, ex VAT |
| Sensors replaced at the same time | £195 – £495 | per sensor, ex VAT |
Standards and rules in Scotland
Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible. BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in the Lothians.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Book a free survey in the Lothians to find out whether a new drive unit will bring your automatic door back to reliable use. The quote is fixed and itemised.
Drive unit replacement in the Lothians: questions
Will you remove the old operator from our premises in the Lothians?
Yes. The old drive unit, sensors and any other replaced parts are taken away as part of the job, and the work area is left clean. Disposal is included in the fixed quote, so there is nothing extra to arrange or pay for afterwards.
Is there a guide price for drive unit replacement in the Lothians?
Our guide is £1,995 to £3,995 excluding VAT (per door), the same guide prices we use across the UK. The free site survey in the Lothians confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Do you provide paperwork for the converted door in the Lothians?
Yes. When we fit a new drive unit we prepare the paperwork for the finished door, including the risk assessment, Declaration of Conformity and user instructions, and hand it over with the test results and settings. It belongs with your building records.
What lead time should we expect in the Lothians?
Once the quote is accepted, drive units are typically 2 to 4 weeks to arrive, depending on the length and weight rating needed. The changeover date is agreed with you as soon as the parts are confirmed, and it can be planned around your opening hours.
What happens to the old door when a new one is fitted in the Lothians?
If the work replaces an existing door, frame or operator, removal and disposal are listed in the quote. The old door comes out only when the new one is ready to go in, so the opening is not left empty for longer than necessary. Making good to the surrounding wall, floor or ceiling is included where the quote says so.
What does the free site survey in the Lothians involve?
An engineer working under our management visits the building, measures the opening, checks the frame, floor, head height and power supply, and looks at how people use the entrance. The survey is free and carries no obligation. Afterwards you receive a fixed, itemised written quote for drive unit replacement, with drawings where the door type needs them.
Is a building warrant needed for a new automatic entrance in the Lothians?
Often, yes. Most building work in Scotland needs a building warrant before it starts, and the non-domestic Technical Handbook sets out what an accessible entrance should provide, including a clear opening of at least 800 mm. We tell you at the survey if your job is likely to need one.