Covering Leeds and nearby
Engineers working under our management travel to addresses across the LS1, LS2, LS3, LS4, LS6 and LS13 postcode districts for fire door hold-open devices. There is no depot or showroom in Leeds; you arrange everything with us by phone, email or the form on this page, and we confirm the price in writing first.
Universities, colleges and city hotels see sharp peaks of traffic at changeover times and check-in hours. For entrances like these in Leeds, opening width, hold-open time and sensor range are set so the door copes with crowds without wasting heat.
Nearby towns we also list for fire door hold-open devices (straight-line distance): Rothwell (4.4 miles), Morley (4.4 miles), Pudsey (4.6 miles), Horsforth (4.9 miles), Batley (7.4 miles), Yeadon (7.4 miles).
What to think about for fire door hold-open devices in Leeds
- Listed buildings and conservation areas can make new cable runs difficult. Radio-triggered battery units avoid most wiring, although the transmitter still needs a connection at the alarm panel.
- Hard-wired magnets need a power supply near each door. In buildings in Leeds where that is awkward, battery units avoid running new cables along finished corridors.
- Doors that open too far from a wall for a wall magnet can use a floor-mounted unit or a magnet on an extension arm. The survey measures where each door rests when open.
- Think about who tests the fire alarm each week at your building in Leeds. Adding a walk past the held-open doors to that test is the easiest way to confirm they release.
- Fire doors on stairs and protected escape routes need particular care. The fire risk assessment may allow some of them to be held open and not others, so pricing is door by door.
Fire door hold-open devices in Leeds: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £145 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Battery acoustic hold-open unit | £145 – £295 | per door, fitted, ex VAT |
| Hard-wired hold-open magnet linked to the fire alarm | £245 – £595 | per door, ex VAT; alarm panel work extra |
| Free-swing door closer linked to the fire alarm | £395 – £895 | per door, fitted, ex VAT |
Which hold-open device is suitable depends on your fire risk assessment. Linking to the fire alarm may need work by your alarm engineer.
Standards and rules in England
Fire doors that are held open must close automatically when the fire alarm operates. Where hold-open devices can be used is decided by the fire risk assessment, which is the job of the responsible person under the Regulatory Reform (Fire Safety) Order 2005.
Hold-open devices and door release units linked to the fire alarm need regular testing as part of the building’s fire safety checks, and the results should be recorded.
How it works
- Send photos and the address. A few pictures of the door from both sides, the address in Leeds and a note of who uses the entrance help us understand the job before anyone visits the site.
- No-cost survey on site. We arrange a survey at a time that suits the building. The engineer records measurements, fixings and power, plus any constraints such as listed status, opening hours or access for deliveries.
- Itemised quote to approve. We price every element of the work on fire door hold-open devices separately in a written quote that you can check, share and approve. Lead time and payment stages are stated, and nothing is ordered until you accept.
- Fit, test and hand over. On the agreed dates the engineer installs the equipment, commissions the operator and tests each safety function. You get a demonstration, the test record and any conformity paperwork that applies to the work.
Send us a list of the doors you want held open at your building in Leeds, plus any notes from your fire risk assessment, and we will arrange a survey at no cost.
Fire door hold-open devices in Leeds: questions
What will the survey in Leeds look at?
The engineer checks that each door closes and latches from fully open, the condition of the closer and seals, where the door rests when open, nearby power supplies and the alarm panel or radio options. We also ask to see the relevant part of the fire risk assessment, so the quote covers only doors that can be held open.
How much should I budget for fire door hold-open devices in Leeds?
Our guide starts from £145 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Leeds confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Can you work with the fire alarm company that maintains our system in Leeds?
Yes, and for wired devices we usually need to. The connection at the alarm panel is made by, or agreed with, the engineer who looks after your alarm. We share the device details with them and agree the visits, so the alarm and the doors can be tested together once the work is finished.
Will you test the hold-open devices before leaving our site in Leeds?
Yes. Every door is released from fully open and checked to close and latch. Where the alarm connection is complete, the doors are also tested with the alarm itself. You receive a schedule of the doors and devices fitted, ready to keep with your fire safety records and weekly alarm test log.
What do you need from us for parking and access in Leeds?
Somewhere for the engineer's van as close to the entrance as possible, and a clear working area around the door. If parking is restricted, loading rules apply or the site has security procedures, tell us when you book. Those details go into the plan so the visit is not held up on the day.
What happens once the installation in Leeds is finished?
The engineer tests every function, including the safety sensors and the behaviour on power loss, and sets the door up with reference to BS EN 16005. You are shown how to use the controls and which simple checks to make, and you receive the handover documents, including the test record and any conformity paperwork that applies to the work.
Which building regulations apply to a new automatic entrance in Leeds?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.