Coverage across Dorset
Wherever you are in Dorset, we need the same three things to get started on break-out escape route doors: a short description of the door, a few photos if you have them, and the address. From there we agree the price in writing and book a specialist engineer working under our management. Every town listed below has a page of its own, 5 in total.
Towns listed in Dorset: Bournemouth, Poole, Weymouth, Christchurch, Ferndown.
What to think about for break-out escape route doors in Dorset
- Hospitals and clinics in Dorset often want break-out entrances tied into the building management and fire alarm systems. Allow time for the alarm contractor to provide a signal and for the estates team to approve the interface.
- A break-out door needs a dedicated fused spur and, where the strategy relies on it opening without mains power, a battery unit. If there is no supply near the head of the door, an electrician will need to run one.
- If a canopy, ramp or steps sit close to the door, measure how far a broken-out leaf will travel. A leaf that clips a handrail or step edge will not give the escape width the strategy assumes.
- Work on a busy entrance in Dorset is often best done early in the morning, in the evening or over a weekend. Any out-of-hours working is agreed and priced in the written quote rather than added later.
- Check the swing zone outside the entrance. Planters, cycle stands, bins and A-boards that are harmless beside a normal door can stop a break-out leaf opening fully, so plan to keep that area clear.
Break-out escape route doors in Dorset: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £7,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Break-out sliding door set for an escape route | from £7,995 | installed, ex VAT; typically up to £16,995 |
| Converting an existing sliding door to break-out | Priced on survey | depends on the frame, leaves and operator |
| Battery backup for power-cut operation | £395 – £695 | per door, ex VAT |
| Touch-free switch or push pad, fitted | £145 – £395 | per switch, ex VAT |
Standards and rules in England
In England, fire safety law says sliding or revolving doors must not be used for exits specifically intended as emergency exits. Break-out sliding doors are used where an entrance also forms part of an escape route, as the fire strategy allows. Whether a break-out door is suitable is decided by the fire strategy for the building and the responsible person under the Regulatory Reform (Fire Safety) Order 2005.
In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking. Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
How it works
- Send photos and the address. A few pictures of the door from both sides, the address in Dorset and a note of who uses the entrance help us understand the job before anyone visits the site.
- No-cost survey on site. We arrange a survey at a time that suits the building. The engineer records measurements, fixings and power, plus any constraints such as listed status, opening hours or access for deliveries.
- Itemised quote to approve. We price every element of the work on break-out escape route doors separately in a written quote that you can check, share and approve. Lead time and payment stages are stated, and nothing is ordered until you accept.
- Fit, test and hand over. On the agreed dates the engineer installs the equipment, commissions the operator and tests each safety function. You get a demonstration, the test record and any conformity paperwork that applies to the work.
Ask for a free survey of your escape route entrance in Dorset. You will get a fixed quote, and nothing is ordered until you accept it.
Break-out escape route doors in Dorset: questions
Can you look after break-out doors in Dorset once they are fitted?
Yes. We can arrange planned servicing, with the break-out fittings, alarm release and power failure behaviour tested at each visit and a written record left on site. Each visit is priced in writing before anyone attends, and the interval is set by how hard the door works.
How much should I budget for break-out escape route doors in Dorset?
Our guide starts from £7,995 excluding VAT (per door set), the same guide price we use across the UK. The free site survey in Dorset confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
We have an old sliding door in Dorset. Do we have to replace all of it?
Not always. If the frame and operator can take break-out leaves and parts are still available, a conversion may be possible. If the door is older or its parts are unsupported, replacing the whole entrance is usually more reliable. The survey looks at both and the quote explains the difference.
Will a break-out door in Dorset need building regulations approval?
It can. Replacing an entrance, especially one on an escape route, may count as building work that needs approval, and the rules differ in each UK nation. We tell you at survey when approval or landlord consent looks likely, so it can be arranged before the door is ordered.
What do you need from us for parking and access in Dorset?
Somewhere for the engineer's van as close to the entrance as possible, and a clear working area around the door. If parking is restricted, loading rules apply or the site has security procedures, tell us when you book. Those details go into the plan so the visit is not held up on the day.
What power supply is needed for break-out escape route doors in Dorset?
Most powered doors need a fused spur close to the operator, and some activation and access control devices also need a low-voltage link. The survey checks what is already there. If a new supply is required, the quote says whether we arrange it or your own electrician does, so nothing is left unclear on the day.
Who is responsible for automatic doors on escape routes in Dorset?
Under the Regulatory Reform (Fire Safety) Order 2005 the responsible person for the premises must make sure escape routes work and fire safety equipment is maintained. Automatic doors on an escape route need fail-safe opening or break-out, set by the fire strategy.