Coverage across Derbyshire
Not every part of Derbyshire is easy to reach, and some sites need planning around access, parking or opening hours. We take that into account when arranging automatic internal doors, and the engineer, working under our management, arrives with what the job is likely to need. The towns below, 14 in all, each have their own page, but any address in the area can be covered.
Towns listed in Derbyshire: Derby, Chesterfield, Long Eaton, Ilkeston, Swadlincote, Staveley, Belper, Heanor, Alfreton, Dronfield, Ripley, Buxton, New Mills, Glossop.
What to think about for automatic internal doors in Derbyshire
- Check the fire rating of each door before the survey. Fire doors need operators made for them, and fixings and cables must not weaken the rating.
- Schools and colleges in Derbyshire often prefer corridor work in the holidays. Book the survey early in the term before, so doors and operators can be ordered and delivered in time.
- Plan the work around the building's routine. Clinical areas, classrooms and kitchens in Derbyshire may need out-of-hours working, which should be agreed and priced up front.
- Noise matters on wards and in bedrooms. Ask for night settings or quieter operators on doors near where people sleep, and check how loud any electric locks are when they release.
- Measure what passes through the door, not just the door. Beds, hoists, trolleys and catering equipment can need a wider opening than the current door gives.
Automatic internal doors in Derbyshire: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £1,795 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Swing operator on an existing internal door | £1,795 – £3,995 | low-energy or full-energy, installed, ex VAT |
| Operators on a pair of cross-corridor doors | £3,795 – £6,495 | installed, ex VAT |
| Internal single-slide automatic door set | £4,495 – £7,995 | installed, ex VAT |
| Touch-free switch or push pad, fitted | £145 – £395 | per switch, ex VAT |
| Card or fob reader tied into the door | £795 – £2,495 | per door, ex VAT |
Standards and rules in England
Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, which can include altering a physical feature such as a heavy entrance door. Fitting an automatic door helps, but does not on its own guarantee those duties are met.
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
How it works
- Tell us about the entrance. Send the address, a few photos and a rough size of the opening, and say how the door is used. That is enough for us to suggest options for automatic internal doors and book a survey in Derbyshire.
- Free site survey. A specialist engineer working under our management measures the opening, checks the frame, floor, head height and power, and talks through how people use the entrance. There is no charge and no obligation.
- Fixed written quote. You receive a fixed, itemised written quote with the specification, lead time, payment stages and warranty terms. The price does not change unless the scope does, and any change is agreed in writing first.
- Installation and handover. The door is fitted on the agreed dates, then set up, tested and documented with reference to BS EN 16005. You are shown the controls and the simple checks to make, and receive the handover paperwork.
Tell us which corridor, ward or office doors are causing problems in Derbyshire, and we will arrange a site visit and a written quote.
Automatic internal doors in Derbyshire: questions
Can you service the internal doors in Derbyshire after fitting?
Yes. We can arrange planned servicing with each door's operator, sensors and fire alarm release checked and a written record left. Servicing is chargeable, and the price per visit is agreed in writing before an engineer attends. Visits can be grouped so several doors are done together.
Is there a guide price for automatic internal doors in Derbyshire?
Our guide starts from £1,795 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Derbyshire confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Can our cross-corridor fire doors in Derbyshire be held open?
Yes, using hold-open devices or fire-rated operators linked to the fire alarm, so the doors close when the alarm operates. We check the doors' condition and ratings first. Any change to how fire doors behave should be agreed with whoever holds your fire risk assessment.
Can internal doors at our offices in Derbyshire be linked to access control?
Yes. Card readers, fob readers or keypads can control who passes into staff areas, and the door opens automatically once access is granted. Locks release on the fire alarm where the fire strategy requires, and we can connect to an existing access control system or supply a standalone one.
What happens to the old door when a new one is fitted in Derbyshire?
If the work replaces an existing door, frame or operator, removal and disposal are listed in the quote. The old door comes out only when the new one is ready to go in, so the opening is not left empty for longer than necessary. Making good to the surrounding wall, floor or ceiling is included where the quote says so.
What do you need from us for parking and access in Derbyshire?
Somewhere for the engineer's van as close to the entrance as possible, and a clear working area around the door. If parking is restricted, loading rules apply or the site has security procedures, tell us when you book. Those details go into the plan so the visit is not held up on the day.
Do businesses in Derbyshire have to fit automatic doors?
No law says every building must have automatic doors. Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, and building regulations guidance in England calls for a powered door where an entrance door would otherwise be too heavy to open. An automatic door is often the simplest way to meet both.