Covering Shirley and nearby
For automatic door refurbishment, coverage around Shirley is set by postcode and includes the B90 postcode district, as well as nearby addresses in the West Midlands. Specialist engineers working under our management attend each site, and the price is agreed in writing beforehand.
Small offices, community centres and village halls around Shirley tend to have one main entrance, often used by visitors who need level access without steps. Automating the existing door, rather than replacing it, is frequently the most practical and affordable route.
Nearby towns we also list for automatic door refurbishment (straight-line distance): Solihull (1.6 miles), Birmingham (5.9 miles), Smethwick (8.4 miles), Redditch (9.0 miles), Halesowen (10.0 miles), Oldbury (10.3 miles).
What to think about for automatic door refurbishment in Shirley
- After refurbishment, sensors and speeds are reset to suit the new parts. Keep the test record with your service history so later engineers can see what was done.
- If the operator is close to the end of its life, refurbishing the running gear while fitting a new drive unit saves a second visit and a second set-up.
- Glass and made-to-measure leaves are typically 2 to 4 weeks from order. Plan the work around that lead time, especially if a damaged leaf is temporarily boarded.
- Care settings in Shirley benefit from level thresholds and smooth-running leaves that do not snag walking frames, trolleys or wheelchair footplates as people pass through.
- Office blocks and business parks in Shirley with several matching doors can refurbish them together for a consistent finish and a lower cost per door.
Automatic door refurbishment in Shirley: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £395 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Running gear refresh: rollers, guides, brushes and seals | £395 – £895 | per door, ex VAT |
| Track overhaul | £395 – £895 | per door, ex VAT |
| Replacement glass leaf | from £495 | each, ex VAT; size and glass type on survey |
| Full refurbishment of a sliding door | £1,495 – £2,995 | running gear, seals, guides and one leaf, ex VAT |
Standards and rules in England
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
How it works
- Tell us about the entrance. Send the address, a few photos and a rough size of the opening, and say how the door is used. That is enough for us to suggest options for automatic door refurbishment and book a survey in Shirley.
- Free site survey. A specialist engineer working under our management measures the opening, checks the frame, floor, head height and power, and talks through how people use the entrance. There is no charge and no obligation.
- Fixed written quote. You receive a fixed, itemised written quote with the specification, lead time, payment stages and warranty terms. The price does not change unless the scope does, and any change is agreed in writing first.
- Installation and handover. The door is fitted on the agreed dates, then set up, tested and documented with reference to BS EN 16005. You are shown the controls and the simple checks to make, and receive the handover paperwork.
Book a free refurbishment survey in Shirley. We will check the frame, leaves and running gear, then price each item separately on a fixed quote.
Automatic door refurbishment in Shirley: questions
Can you replace a single broken glass leaf in Shirley?
Yes. The leaf is made safe, measured and reglazed with new safety glass, or replaced completely if its frame is damaged. New glass is typically 2 to 4 weeks from order. Once the leaf is rehung, the door is set up again and the track and floor guide are checked.
What is the guide price for automatic door refurbishment in Shirley?
Our guide starts from £395 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Shirley confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Do you set up the door again after refurbishing it in Shirley?
Yes. New running parts change how the leaves move, so speeds, sensor zones and obstacle detection are checked and reset before handover. You receive a record of the parts fitted and the test results to keep with the door's service history.
Can refurbishment in Shirley help with draughts and heating costs?
New seals and brush strips, and leaves that close fully, reduce draughts through a closed door. For very exposed entrances, a second set of doors forming a draught lobby may also be worth considering, and we can price both so you can compare the likely benefit.
Do I need permission from a landlord or the council before work in Shirley?
It depends on the building. Tenants usually need the landlord's written consent before changing an entrance, and some changes to a shopfront or external door need planning permission. The survey notes anything that may need consent. We can supply drawings and product details to support an application, but the owner or tenant makes it.
What happens to the old door when a new one is fitted in Shirley?
If the work replaces an existing door, frame or operator, removal and disposal are listed in the quote. The old door comes out only when the new one is ready to go in, so the opening is not left empty for longer than necessary. Making good to the surrounding wall, floor or ceiling is included where the quote says so.
Which building regulations apply to a new automatic entrance in Shirley?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.