Covering Sittingbourne and nearby
Addresses anywhere in the ME10 postcode district can book automatic door refurbishment through us. The engineer who attends works under our management and travels to the site. There is no branch in Sittingbourne, so the price, the booking and the paperwork all come from one place.
Health centres, GP surgeries and clinics around Sittingbourne need doors that open gently and stay open long enough for patients using walking aids or wheelchairs. Low-energy operators, push pads and careful sensor set-up matter more here than sheer speed.
Nearby towns we also list for automatic door refurbishment (straight-line distance): Faversham (7.0 miles), Gillingham (8.6 miles), Chatham (9.2 miles), Rochester (10.3 miles), Maidstone (10.7 miles), Strood (11.6 miles).
What to think about for automatic door refurbishment in Sittingbourne
- Busy retail units in Sittingbourne may prefer the work done in stages, one leaf at a time, so the entrance stays open throughout trading hours.
- Exposed entrances in Sittingbourne suffer most from worn seals and brush strips. New weatherproofing can cut draughts and noise noticeably, especially on doors facing the prevailing wind.
- Frames near the coast or busy roads can corrode faster. The survey checks fixings and the bottom of the frame, where water and grit tend to collect.
- Care settings in Sittingbourne benefit from level thresholds and smooth-running leaves that do not snag walking frames, trolleys or wheelchair footplates as people pass through.
- Glass and made-to-measure leaves are typically 2 to 4 weeks from order. Plan the work around that lead time, especially if a damaged leaf is temporarily boarded.
Automatic door refurbishment in Sittingbourne: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £395 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Running gear refresh: rollers, guides, brushes and seals | £395 – £895 | per door, ex VAT |
| Track overhaul | £395 – £895 | per door, ex VAT |
| Replacement glass leaf | from £495 | each, ex VAT; size and glass type on survey |
| Full refurbishment of a sliding door | £1,495 – £2,995 | running gear, seals, guides and one leaf, ex VAT |
Standards and rules in England
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Start with a short enquiry. Use the form, phone or email. Tell us whether the work is a new door, an upgrade or an opener for a home, and we arrange the next step for your site in Sittingbourne.
- Measured survey. The free survey confirms what will fit and what the entrance needs: opening width, door type, activation, safety sensors and behaviour on power loss or fire alarm, matched to how the building is used.
- Written price, no surprises. A fixed, itemised quote sets out the specification, the work involved, the expected lead time and the warranty terms. You can ask questions or change the specification before accepting it.
- Installed and commissioned. The door is installed with as little disruption as possible, then set up and tested for its hazard zones. Before leaving, the engineer explains the controls and hands over the documents for your records.
Send us photos of the door that needs attention in Sittingbourne, and we will arrange a survey at no cost and an itemised quote for the work.
Automatic door refurbishment in Sittingbourne: questions
Can you refinish the frame of our door in Sittingbourne?
Yes. Aluminium frames can be cleaned, repaired and recoated on site to refresh their colour. Badly damaged sections may need replacing rather than refinishing. Refinishing is listed separately in the quote, so you can decide whether to include it now or leave it for a later phase.
What do you charge for automatic door refurbishment in Sittingbourne?
Our guide starts from £395 excluding VAT (per door), the same guide price we use across the UK. The free site survey in Sittingbourne confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Will our entrance in Sittingbourne stay open during refurbishment?
Often, at least in part. Many jobs can be done one leaf at a time, and the work can be planned for quieter hours. If the entrance does need to close, the quote says for how long, so you can arrange another way in for staff and visitors.
Can refurbishment in Sittingbourne help with draughts and heating costs?
New seals and brush strips, and leaves that close fully, reduce draughts through a closed door. For very exposed entrances, a second set of doors forming a draught lobby may also be worth considering, and we can price both so you can compare the likely benefit.
What does the free site survey in Sittingbourne involve?
An engineer working under our management visits the building, measures the opening, checks the frame, floor, head height and power supply, and looks at how people use the entrance. The survey is free and carries no obligation. Afterwards you receive a fixed, itemised written quote for automatic door refurbishment, with drawings where the door type needs them.
Do I need permission from a landlord or the council before work in Sittingbourne?
It depends on the building. Tenants usually need the landlord's written consent before changing an entrance, and some changes to a shopfront or external door need planning permission. The survey notes anything that may need consent. We can supply drawings and product details to support an application, but the owner or tenant makes it.
Who is responsible for automatic doors on escape routes in Sittingbourne?
Under the Regulatory Reform (Fire Safety) Order 2005 the responsible person for the premises must make sure escape routes work and fire safety equipment is maintained. Automatic doors on an escape route need fail-safe opening or break-out, set by the fire strategy.