Coverage across North Yorkshire
Not every part of North Yorkshire is easy to reach, and some sites need planning around access, parking or opening hours. We take that into account when arranging access control for automatic doors, and the engineer, working under our management, arrives with what the job is likely to need. The towns below, 8 in all, each have their own page, but any address in the area can be covered.
Towns listed in North Yorkshire: York, Middlesbrough, Harrogate, Scarborough, Redcar, Selby, Thornaby-on-Tees, Yarm.
What to think about for access control for automatic doors in North Yorkshire
- Older automatic doors in North Yorkshire may not have inputs for access control. The survey checks this, and an older operator may need upgrading or replacing before readers can be linked.
- Think about lost cards and leavers. A system that lets you remove a card centrally is easier to run than a shared keypad code on a busy site.
- Decide how the door should behave at each time of day before the survey. Opening hours, cleaning shifts, deliveries and weekend events all affect the schedule the door will follow.
- A video entry system needs a network or cable link between the door and wherever visitors are answered. Check the route before the survey, especially across car parks or between buildings.
- Offices on business parks in North Yorkshire often share entrances between tenants. Agree whose system controls the door, who pays for it and who can add or remove cards.
Access control for automatic doors in North Yorkshire: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £795 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Card or fob reader tied into the door | £795 – £2,495 | per door, ex VAT |
| Intercom or door entry tie-in | from £495 | priced on survey, ex VAT |
| Timed locking and night mode set-up | included with the above | programmed at commissioning |
| Electric lock added to an automatic door | on survey | depends on the door and the lock type |
Standards and rules in England
Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, which can include altering a physical feature such as a heavy entrance door. Fitting an automatic door helps, but does not on its own guarantee those duties are met.
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
Whoever motorises a manual door, or builds an automatic door from separate parts, may take on the manufacturer’s legal duties for the finished door: a risk assessment, a technical file kept available for the authorities, a Declaration of Conformity, the conformity marking and instructions. You receive the Declaration of Conformity and the instructions at handover. In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking.
How it works
- Tell us about the entrance. Send the address, a few photos and a rough size of the opening, and say how the door is used. That is enough for us to suggest options for access control for automatic doors and book a survey in North Yorkshire.
- Free site survey. A specialist engineer working under our management measures the opening, checks the frame, floor, head height and power, and talks through how people use the entrance. There is no charge and no obligation.
- Fixed written quote. You receive a fixed, itemised written quote with the specification, lead time, payment stages and warranty terms. The price does not change unless the scope does, and any change is agreed in writing first.
- Installation and handover. The door is fitted on the agreed dates, then set up, tested and documented with reference to BS EN 16005. You are shown the controls and the simple checks to make, and receive the handover paperwork.
Want your automatic door in North Yorkshire to open only for the right people? Start with a free site survey, with no obligation.
Access control for automatic doors in North Yorkshire: questions
Our automatic door in North Yorkshire is quite old. Can access control still be added?
Sometimes. Older operators may not have suitable inputs, or may not support an electric lock. The survey checks this, and if the operator needs upgrading first, the quote shows the cost of both, so you can decide. An older door may also benefit from a safety inspection at the same time.
What do you charge for access control for automatic doors in North Yorkshire?
Our guide starts from £795 excluding VAT (per door), the same guide price we use across the UK. The free site survey in North Yorkshire confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Do you work with our security installer in North Yorkshire?
Yes. Where a security installer already looks after your access control, we usually handle the door, the lock and the link to the operator, and they handle the reader, controller and permissions. The quote sets out who does what so nothing falls between the two.
Can you add access control to our automatic door in North Yorkshire?
In most cases, yes. We check the operator's inputs, the lock options and the cable route at a free survey, then quote a fixed price. We can connect to your existing system or supply a standalone reader or keypad for the door.
What is the lead time for access control for automatic doors in North Yorkshire?
Lead times depend on the door type and what has to be made to order. As a guide, operators and accessible door kits are typically two to four weeks from order, and complete sliding entrances typically four to eight weeks from drawing approval. Curved, revolving and hermetic doors usually take longer. The expected lead time is stated in your quote.
What happens once the installation in North Yorkshire is finished?
The engineer tests every function, including the safety sensors and the behaviour on power loss, and sets the door up with reference to BS EN 16005. You are shown how to use the controls and which simple checks to make, and you receive the handover documents, including the test record and any conformity paperwork that applies to the work.
Do businesses in North Yorkshire have to fit automatic doors?
No law says every building must have automatic doors. Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, and building regulations guidance in England calls for a powered door where an entrance door would otherwise be too heavy to open. An automatic door is often the simplest way to meet both.