Covering Burgess Hill and nearby
Sites across the RH15 postcode district are visited by specialist automatic door engineers working under our management. They travel to Burgess Hill for telescopic sliding doors as bookings come in, so dates depend on the diary rather than a fixed local team, and we give you the earliest date we can offer when you book.
Many buildings in Burgess Hill are older, with timber frames, thick walls, steps or uneven thresholds. These affect where an operator and sensors can go, and the engineer checks them on site before anything is fitted or adjusted.
Nearby towns we also list for telescopic sliding doors (straight-line distance): Haywards Heath (3.0 miles), Lewes (8.5 miles), Hove (8.9 miles), Brighton (9.0 miles), Uckfield (10.0 miles), Shoreham-by-Sea (10.6 miles).
What to think about for telescopic sliding doors in Burgess Hill
- Power for the operator usually comes from a fused spur at the head of the door. Where the nearest supply is some distance away, plan for an electrician to run a new circuit before the fitting day.
- Grit and leaves blown into the threshold collect in floor guide channels. Entrances facing a car park or open ground benefit from a matwell or canopy, which also keeps rain off the sensors.
- A telescopic header is deeper than a standard one. In older buildings in Burgess Hill with low ceilings or decorative fanlights, the survey checks whether the header can sit above the opening or needs to be recessed.
- Care homes and supported living buildings in Burgess Hill may want the main door to open freely for visitors but stay locked for some residents. A keypad or fob reader on the inside can be wired to the operator.
- If the entrance is on an escape route, ask your fire risk assessor what the door must do before ordering. Break-out telescopic leaves have to be chosen at the start, because they cannot be added afterwards.
Telescopic sliding doors in Burgess Hill: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £6,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Telescopic single-slide, two leaves | £6,995 – £9,995 | installed, ex VAT |
| Telescopic bi-parting, four leaves | £8,995 – £13,995 | installed, ex VAT |
| Very wide or full-height openings | Priced on survey | measured and designed at the survey |
| Touch-free switch or push pad, fitted | £145 – £395 | per switch, ex VAT |
| Card or fob reader tied into the door | £795 – £2,495 | per door, ex VAT |
Standards and rules in England
Under the Equality Act 2010, service providers and employers must make reasonable adjustments for disabled people, which can include altering a physical feature such as a heavy entrance door. New entrances and some alterations count as building work, so check with building control before the work is ordered.
In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking. Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Send photos and the address. A few pictures of the door from both sides, the address in Burgess Hill and a note of who uses the entrance help us understand the job before anyone visits the site.
- No-cost survey on site. We arrange a survey at a time that suits the building. The engineer records measurements, fixings and power, plus any constraints such as listed status, opening hours or access for deliveries.
- Itemised quote to approve. We price every element of the work on telescopic sliding doors separately in a written quote that you can check, share and approve. Lead time and payment stages are stated, and nothing is ordered until you accept.
- Fit, test and hand over. On the agreed dates the engineer installs the equipment, commissions the operator and tests each safety function. You get a demonstration, the test record and any conformity paperwork that applies to the work.
Book a free site survey in Burgess Hill, and an engineer will measure the opening and send a drawing with a fixed, itemised quote for telescopic sliding doors.
Telescopic sliding doors in Burgess Hill: questions
Can you fit telescopic sliding doors in Burgess Hill?
Yes. We arrange supply and installation in Burgess Hill and the rest of West Sussex. Specialist automatic door engineers working under our management carry out the survey and the fitting, and we stay the contracting party throughout, so one company is responsible for the drawing, the quote, the installation and the handover paperwork.
What is the guide price for telescopic sliding doors in Burgess Hill?
Our guide starts from £6,995 excluding VAT (per door set), the same guide price we use across the UK. The free site survey in Burgess Hill confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
What paperwork do we get after installation in Burgess Hill?
You receive the commissioning and test record, a site-specific risk assessment, user instructions and the conformity paperwork for the door. Keep them with your building records. They are the starting point for later servicing and safety inspections, and they show how the door was set up with reference to BS EN 16005.
Is the telescopic door survey in Burgess Hill really free?
Yes, for a new telescopic entrance the site survey costs nothing and carries no obligation. The engineer measures the opening, checks the structure, floor and power, and talks through layouts. You then receive a measured drawing and a fixed, itemised written quote, and you decide whether to go ahead.
Will the building stay secure while the entrance is being changed?
We plan to keep the entrance usable or secure throughout. Where a door has to come out, the work is sequenced so the opening is closed up before the engineer leaves, or a temporary door or hoarding is arranged when a longer gap cannot be avoided. How this is handled for your site in Burgess Hill is agreed before work starts.
Can automatic doors be fitted to a listed building in Burgess Hill?
Often, yes, but listed building consent is normally needed for changes that affect the character of the building, inside or out. Slim operators, concealed fixings and automating the existing door can all reduce the visual impact. Speak to the conservation officer at the local planning authority early; we can provide drawings and specifications to help.
Who is responsible for automatic doors on escape routes in Burgess Hill?
Under the Regulatory Reform (Fire Safety) Order 2005 the responsible person for the premises must make sure escape routes work and fire safety equipment is maintained. Automatic doors on an escape route need fail-safe opening or break-out, set by the fire strategy.