Covering Congleton and nearby
Homes, businesses and public buildings throughout the CW12 postcode district can arrange telescopic sliding doors with us. We are the contracting party and organise every visit; the engineer, who works under our management, travels in to Congleton for the job rather than working from premises in town.
Many buildings in Congleton are older, with timber frames, thick walls, steps or uneven thresholds. These affect where an operator and sensors can go, and the engineer checks them on site before anything is fitted or adjusted.
Nearby towns we also list for telescopic sliding doors (straight-line distance): Biddulph (3.5 miles), Kidsgrove (5.4 miles), Sandbach (6.3 miles), Macclesfield (7.6 miles), Leek (8.9 miles), Crewe (10.5 miles).
What to think about for telescopic sliding doors in Congleton
- Grit and leaves blown into the threshold collect in floor guide channels. Entrances facing a car park or open ground benefit from a matwell or canopy, which also keeps rain off the sensors.
- If the entrance is on an escape route, ask your fire risk assessor what the door must do before ordering. Break-out telescopic leaves have to be chosen at the start, because they cannot be added afterwards.
- Power for the operator usually comes from a fused spur at the head of the door. Where the nearest supply is some distance away, plan for an electrician to run a new circuit before the fitting day.
- Care homes and supported living buildings in Congleton may want the main door to open freely for visitors but stay locked for some residents. A keypad or fob reader on the inside can be wired to the operator.
- Entrances across Cheshire that face the prevailing wind can suffer from leaves dragging or sensors reacting to blown debris. A canopy, a draught lobby or careful sensor set-up deals with most of these problems.
Telescopic sliding doors in Congleton: guide prices
The site survey is free, including the measured drawing and a fixed, itemised written quote. Guide price: from £6,995 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Telescopic single-slide, two leaves | £6,995 – £9,995 | installed, ex VAT |
| Telescopic bi-parting, four leaves | £8,995 – £13,995 | installed, ex VAT |
| Very wide or full-height openings | Priced on survey | measured and designed at the survey |
| Touch-free switch or push pad, fitted | £145 – £395 | per switch, ex VAT |
| Card or fob reader tied into the door | £795 – £2,495 | per door, ex VAT |
Standards and rules in England
Building regulations guidance in England (Approved Document M, Volume 2) says a powered opening system should be used where a self-closing entrance door would need more than 30 N at the leading edge to open, or more than 22.5 N between 30° and 60°, and expects external doors used by the public in new buildings to give at least 1000 mm of effective clear width.
In Great Britain a new or converted powered door must meet the Supply of Machinery (Safety) Regulations 2008 before it is first used, and can carry the UKCA or the CE marking. Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance.
How it works
- Tell us about the entrance. Send the address, a few photos and a rough size of the opening, and say how the door is used. That is enough for us to suggest options for telescopic sliding doors and book a survey in Congleton.
- Free site survey. A specialist engineer working under our management measures the opening, checks the frame, floor, head height and power, and talks through how people use the entrance. There is no charge and no obligation.
- Fixed written quote. You receive a fixed, itemised written quote with the specification, lead time, payment stages and warranty terms. The price does not change unless the scope does, and any change is agreed in writing first.
- Installation and handover. The door is fitted on the agreed dates, then set up, tested and documented with reference to BS EN 16005. You are shown the controls and the simple checks to make, and receive the handover paperwork.
Tell us the width you need and the space either side, and we will arrange a free survey in Congleton for a telescopic sliding door.
Telescopic sliding doors in Congleton: questions
How much wider will our entrance in Congleton be with telescopic doors?
As a rough guide, a telescopic door gives about two-thirds of its overall width as clear opening, against about half for a standard sliding door. On a typical shop or surgery entrance that can mean an extra 300 to 600 mm. The survey drawing for your building in Congleton shows the exact clear width before you commit.
What will telescopic sliding doors in Congleton cost?
Our guide starts from £6,995 excluding VAT (per door set), the same guide price we use across the UK. The free site survey in Congleton confirms the price as a fixed, itemised written quote, and the guide price tool gives you a range before anyone visits.
Is the telescopic door survey in Congleton really free?
Yes, for a new telescopic entrance the site survey costs nothing and carries no obligation. The engineer measures the opening, checks the structure, floor and power, and talks through layouts. You then receive a measured drawing and a fixed, itemised written quote, and you decide whether to go ahead.
What paperwork do we get after installation in Congleton?
You receive the commissioning and test record, a site-specific risk assessment, user instructions and the conformity paperwork for the door. Keep them with your building records. They are the starting point for later servicing and safety inspections, and they show how the door was set up with reference to BS EN 16005.
What should I send before the survey in Congleton?
A few photos of the door from inside and outside, rough measurements of the opening, the address and a note of how the entrance is used. If the door already has an operator, a photo of any label on it helps. With that, the engineer arrives prepared, the survey takes less of your time and we can put the quote for telescopic sliding doors together more easily.
Can automatic doors be fitted to a listed building in Congleton?
Often, yes, but listed building consent is normally needed for changes that affect the character of the building, inside or out. Slim operators, concealed fixings and automating the existing door can all reduce the visual impact. Speak to the conservation officer at the local planning authority early; we can provide drawings and specifications to help.
Which building regulations apply to a new automatic entrance in Congleton?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.