Covering Tranent and nearby
For sensor upgrades and replacement, coverage around Tranent is set by postcode and includes the EH33 postcode district, as well as nearby addresses in the Lothians. Specialist engineers working under our management attend each site, and the price is agreed in writing beforehand.
Many buildings in Tranent are older, with timber frames, thick walls, steps or uneven thresholds. These affect where an operator and sensors can go, and the engineer checks them on site before anything is fitted or adjusted.
Nearby towns we also list for sensor upgrades and replacement (straight-line distance): Prestonpans (1.5 miles), Musselburgh (3.7 miles), Dalkeith (5.7 miles), Mayfield (6.0 miles), Haddington (6.7 miles), Bonnyrigg (7.6 miles).
What to think about for sensor upgrades and replacement in Tranent
- Doors with side screens may need a light curtain on the leaf edge or post to protect the gap. This is one of the most common upgrades on older sliding doors.
- Sites in Tranent that open early or close late may want sensor work done outside trading hours. Tell us the quieter times when you book the visit.
- Shiny, wet or newly polished floors can confuse infrared safety sensors. Mention any recent floor changes at your building in Tranent so the zones can be set for the new surface.
- Sensor changes on escape route doors must never stop the door opening when it needs to. The engineer checks the door's escape mode after any sensor work.
- Shopping parades and older shopfronts in Tranent sometimes have low transoms or canopies that limit where a sensor can be mounted. The engineer checks height and angle first.
Sensor upgrades and replacement in Tranent: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: typically £195 to £495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Add or replace a safety or activation sensor | £195 – £495 | per sensor fitted, ex VAT |
| Touch-free switch or push pad | £145 – £395 | per switch, ex VAT |
| Side-screen or light-curtain protection | from £295 | per door, ex VAT; on survey |
Sensor prices cover the part, fitting and set-up. If a sensor is fitted on a visit of its own, the visit charge (from £95 ex VAT) is added, and we confirm the total in writing before an engineer attends. Each sensor is set up for the door and tested before the engineer leaves.
Standards and rules in Scotland
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
How it works
- Make contact. Phone, email or use the form. Tell us the type of door, what it is doing and whether it is safe to use, so the right visit for sensor upgrades and replacement can be planned.
- Written visit price. The cost of attending is agreed in writing before the visit is booked. For a planned service or inspection, the price per door and what each visit includes are set out at the same time.
- On-site work. The engineer, working under our management, checks the door from end to end, deals with the fault or the service, and tests every safety function and sensor setting before signing the door off.
- Report and quote. You receive a report of the findings. Where a repair, part or upgrade is recommended, it is quoted in writing so you can decide, and the door is left in a safe state if it cannot be used.
Has a risk assessment in Tranent listed sensor upgrades? Send us the report and we will quote each item before any work is done.
Sensor upgrades and replacement in Tranent: questions
Can you price new sensors for my door in Tranent from photos?
Often, yes. Photos of the sensor, the door from both sides and the label on the operator cover usually tell us which sensor is needed and whether it suits the controller. We can then quote the sensor and fitting in advance, with the visit price confirmed before anyone travels.
What is the guide price for sensor upgrades and replacement in Tranent?
Our guide is £195 to £495 excluding VAT (per sensor fitted), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in Tranent, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Our door in Tranent closes on people. Is that a sensor fault?
It is likely, and the door should be treated as unsafe. Switch it to a safe mode, such as manual or open, and keep people away from the leaves. Tell us it is unsafe and we will give you the earliest visit we can offer, then the engineer will check the safety sensors and their zones.
Do engineers carry sensors for doors in Tranent?
Engineers carry common combined and safety sensors, so many replacements can be fitted at the first visit. Light curtains and specialist sensors are ordered once the door is identified, with delivery typically 1 to 2 weeks. Photos in advance help us bring the right part first time.
Are parts quoted before they are fitted?
Always. If a repair or service in Tranent needs parts, such as rollers, belts, sensors, a control board or a motor, we quote them in writing first. Some common parts may be on the engineer's van; others are ordered once you accept the quote and fitted on a return visit at a price already agreed.
What happens during a visit in Tranent?
The engineer checks how the door is operating, diagnoses the fault or carries out the service, and tests the safety sensors and other functions before leaving. On a service visit that includes cleaning, adjustment and lubrication where needed. Anything that cannot be put right on the visit, or that needs parts, is explained and quoted before further work goes ahead.
Is a building warrant needed for a new automatic entrance in Tranent?
Often, yes. Most building work in Scotland needs a building warrant before it starts, and the non-domestic Technical Handbook sets out what an accessible entrance should provide, including a clear opening of at least 800 mm. We tell you at the survey if your job is likely to need one.