Covering Radcliffe and nearby
We cover the whole of the M26 postcode district, along with nearby towns in Greater Manchester. You book each visit for sensor upgrades and replacement directly with us, and a specialist automatic door engineer working under our management travels to your site on the agreed date.
Parking on a busy high street can be tight. When work is booked in Radcliffe, the engineer's arrival is planned around loading restrictions, any market days and opening hours, so the visit causes as little disruption as possible.
Nearby towns we also list for sensor upgrades and replacement (straight-line distance): Whitefield (1.3 miles), Prestwich (2.6 miles), Bury (2.8 miles), Farnworth (3.2 miles), Walkden (4.4 miles), Swinton (4.4 miles).
What to think about for sensor upgrades and replacement in Radcliffe
- Sites in Radcliffe that open early or close late may want sensor work done outside trading hours. Tell us the quieter times when you book the visit.
- Shopping parades and older shopfronts in Radcliffe sometimes have low transoms or canopies that limit where a sensor can be mounted. The engineer checks height and angle first.
- Rain, snow and blowing leaves can trigger radar sensors over exposed doors. Some sensors filter weather better than others, which the engineer weighs up when choosing a replacement.
- Shiny, wet or newly polished floors can confuse infrared safety sensors. Mention any recent floor changes at your building in Radcliffe so the zones can be set for the new surface.
- Corridor doors that people walk past rather than through may work better on a touch-free switch than a motion sensor, cutting needless openings and heat loss.
Sensor upgrades and replacement in Radcliffe: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: typically £195 to £495 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Add or replace a safety or activation sensor | £195 – £495 | per sensor fitted, ex VAT |
| Touch-free switch or push pad | £145 – £395 | per switch, ex VAT |
| Side-screen or light-curtain protection | from £295 | per door, ex VAT; on survey |
Sensor prices cover the part, fitting and set-up. If a sensor is fitted on a visit of its own, the visit charge (from £95 ex VAT) is added, and we confirm the total in writing before an engineer attends. Each sensor is set up for the door and tested before the engineer leaves.
Standards and rules in England
Workplace law (the Workplace (Health, Safety and Welfare) Regulations 1992) expects powered doors to have suitable and effective features to stop them trapping anyone and, where needed for safety, to open by hand unless they open automatically if the power fails. Doors at work must also be kept in efficient working order under a suitable system of maintenance. HSE guidance on those regulations says the frequency of maintenance depends on the equipment and the manufacturer’s information.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
How it works
- Explain the problem. Whether the door is stuck, slow, noisy or due its next check, a short description and a few photos tell us which kind of visit to book for sensor upgrades and replacement and what to bring.
- Visit cost agreed. You get the visit price in writing before we book the engineer. There are no hidden extras: parts and further work are always quoted separately and in advance.
- Engineer on site. The engineer inspects the operator, sensors, tracks and leaves, carries out the repair or service, and runs the door through its safety tests before it goes back into use.
- Follow-up quoted. You are sent a record of the visit. If something else needs attention, we quote it in writing; for doors on a service plan, the next visit date is noted on the record.
Get your door detecting people properly again. Contact us about sensor replacement in Radcliffe, with the visit cost confirmed before anyone attends.
Sensor upgrades and replacement in Radcliffe: questions
Can you price new sensors for my door in Radcliffe from photos?
Often, yes. Photos of the sensor, the door from both sides and the label on the operator cover usually tell us which sensor is needed and whether it suits the controller. We can then quote the sensor and fitting in advance, with the visit price confirmed before anyone travels.
Is there a guide price for sensor upgrades and replacement in Radcliffe?
Our guide is £195 to £495 excluding VAT (per sensor fitted), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in Radcliffe, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Can a risk assessment in Radcliffe tell us which sensors we need?
Yes. A safety inspection tests each hazard zone and records where sensor coverage is missing or poor. The report then lists the sensors or light curtains needed, and we can quote those items exactly as listed, or you can pass the report to another competent installer.
Can you upgrade sensors on an old door in Radcliffe?
Most older doors can take modern sensors. A few very old controllers cannot monitor current safety sensors. If yours is one of them, we explain whether a controller upgrade or a new drive unit is the better option, and quote it, before any work is done.
Are parts quoted before they are fitted?
Always. If a repair or service in Radcliffe needs parts, such as rollers, belts, sensors, a control board or a motor, we quote them in writing first. Some common parts may be on the engineer's van; others are ordered once you accept the quote and fitted on a return visit at a price already agreed.
Can you take over servicing of doors in Radcliffe from another company?
Yes. Send us the door details and, if you have them, previous service records or inspection reports. The first visit gives a baseline for each door, and its price is agreed in writing beforehand. From then on, records continue in one consistent format, whichever company looked after the doors before.
Which building regulations apply to a new automatic entrance in Radcliffe?
In England the guidance is Approved Document M (Volume 2) for access, Approved Document B for fire safety and escape routes, and Approved Document K for glazing and powered doors. A new entrance can count as building work, so building control should be involved before it is ordered.