Covering Brecon and nearby
Addresses anywhere in the LD3 postcode district can book safety inspections and risk assessments through us. The engineer who attends works under our management and travels to the site. There is no branch in Brecon, so the price, the booking and the paperwork all come from one place.
Independent businesses in Brecon often have one entrance and cannot close for long. Work is usually scheduled early, late or on a quiet day, and where a door must be out of use for a period, we plan to keep the entrance usable or secure.
Nearby towns we also list for safety inspections and risk assessments (straight-line distance): Tredegar (13.4 miles), Merthyr Tydfil (13.7 miles), Ebbw Vale (14.0 miles), Aberdare (16.2 miles), Abergavenny (18.0 miles), Mountain Ash (18.1 miles).
What to think about for safety inspections and risk assessments in Brecon
- Programme switches left in the wrong mode cause many incidents. The inspection checks the switch is secure, labelled and set correctly for each time of day.
- Care homes and hospitals in Brecon have users who move slowly or unpredictably. The inspection pays close attention to sensor coverage and door speeds where frail or confused people pass through.
- Glass leaves need safety glazing and visible markings. Faded or missing manifestation is a common finding, and one of the quickest and cheapest to put right.
- Doors on escape routes must let people out safely during a fire or evacuation. The inspection checks break-out, power-failure opening or manual release, as the fire strategy requires.
- Schools and nurseries need particular care with finger traps at hinges and beside side screens, because children are more likely to put their hands into gaps.
Safety inspections and risk assessments in Brecon: guide prices
The visit price is agreed in writing before an engineer attends; parts and any further work are quoted before they are done. Guide price: typically £125 to £250 ex VAT.
| Item | Guide price | Notes |
|---|---|---|
| Safety inspection and risk assessment, existing door | £125 – £250 | per door, written report, ex VAT |
| Inspection added to a service visit | reduced | quoted with the service |
| Upgrades found by the inspection | quoted separately | see safety and compliance upgrades |
The inspection price is agreed in writing before the visit. Any upgrades the report recommends are quoted separately so you can plan them.
Standards and rules in Wales
BS EN 16005 is the current standard for the safety in use of powered pedestrian doors, and BS 7036-0:2014 is the British code of practice for risk assessment and risk reduction used alongside it. Standards are not law in themselves, but they are the recognised benchmark for showing an automatic door is safe to use, and we set up, test and document doors with reference to them. Standards are not retrospective, so an older door does not become unlawful when a standard is updated; a site-specific risk assessment shows whether any upgrades are sensible.
No law sets a fixed service interval. We recommend that a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer’s instructions and how heavily the door is used, and that someone on site carries out simple regular checks and keeps a record.
How it works
- Tell us what is happening. Describe the fault, or the service or inspection that is due, and send photos of the door and any label on the operator. Include the address in Brecon and how much the site depends on the door.
- Visit price agreed in writing. We confirm the price of the visit in writing before an engineer attends. If the door can be priced from photos and its make and model, we say so at this stage.
- Engineer visit. A specialist engineer working under our management diagnoses the fault or carries out the service, then tests the operation of the door and its safety sensors before leaving the site.
- Findings and follow-up. You receive a written record of what was found and done. Any parts or further work needed are quoted in writing before they go ahead, and nothing is added without your agreement.
Book an automatic door safety inspection in Brecon. Tell us how many doors you have and how they are used, and we will confirm the price in writing.
Safety inspections and risk assessments in Brecon: questions
How long will our door in Brecon be out of use during the inspection?
Usually only for short periods while sensors are tested and the door is observed in different modes. A single door generally takes about an hour in total. For busy entrances the inspection can be planned for a quieter time, or one leaf tested at a time where the door allows it.
How much should I budget for safety inspections and risk assessments in Brecon?
Our guide is £125 to £250 excluding VAT (per door), the same guide prices we use across the UK. We agree the visit price in writing before an engineer attends in Brecon, and quote any parts or further work before doing them. The price guide lists typical repair and service costs.
Can you inspect all the doors on our site in Brecon in one visit?
Usually, yes. A whole-site inspection covers every automatic door in one visit and one report, with each door's findings ranked so you can compare priorities across the site. Larger sites may need more than one day, which we agree with you when the inspection is priced.
Can an inspection in Brecon be combined with a service?
Yes, and it often makes sense. The engineer services the door, then carries out the risk assessment while on site, which saves a second visit. The combined price is agreed in writing before the visit, and you receive both the service record and the inspection report.
How soon can an engineer get to Brecon?
We do not promise response times. When you book, we give you the earliest date we can offer and confirm it once the price is agreed. If the door is unsafe in the meantime, it is usually best to switch it off or set it to a safe mode, put up a sign and keep people clear of it.
How often should automatic doors in Brecon be serviced?
No law sets a fixed interval. We recommend a trained engineer checks the safety functions at least once a year, with service intervals set by the manufacturer's instructions and how heavily the door is used; busy doors are often serviced more often. Site staff should also carry out simple regular checks and keep a record of them.
Are the rules for automatic doors different in Wales?
Some are. Wales has its own building regulations guidance: Approved Document M (Wales) calls for a powered door where opening a self-closing entrance door would need more than 20 N, lower than the figure used in England. Fire law (the Regulatory Reform (Fire Safety) Order 2005) and the Equality Act 2010 apply as in England.